Whirlpool Washer Pulleys

Videos!

Your Price

$37.76

Whirlpool Washer Drive Pulley

★★★★★

23 Reviews

PartSelect Number PS10057144

Manufacturer Part Number W10721967

This is a replacement clutch assembly or cam kit for your washer. The clutch assembly is mounted on the drive shaft on the bottom of your washer. You may need to replace the clutch assembly if the splines on the clutch assembly are stripped and the washer is making noise, or if you are having problems with the wash and spin cycles. You will need to access the bottom of the washer for this repair. It is easiest to if you disconnect your washer from both the water and power source, and lay it on its back. The clutch assembly contains 6 parts, and all are included with the kit. It is also important to change out the entire assembly, rather than individual pieces.

Fixes these symptoms

Burning smell
Cycle Not Advancing
Noisy and Marks Left on Clothes
See more...

Installation Instructions

Jerry from WALLA WALLA, WA

Noise on bottom of Washer louder as time went on. 1 1/2 years

Well, first investigated and found loose nut on drive clutch. First take off the two screws with nut drive then cover off using a screwdriver blade to snap off the cover. Then socket ratchet to take off the nut on drive clutch. take off belt by slowly rotating the drive gear. two screws that hold the electronics to the upper drive clutch and put aside, so you can snap off the cover for drive clutch on upper part with screwdriver and off the parts come and install whole unit back as took it apart. Line up the new upper clutch so that is position as was before. (Using parts diagram helps a lot as www. partsselect.com has for you or Maytag.com.) Then put the electronic part board back on and the gear and nut. Make sure it is tight by several attempts to make sure it's snugged up good and then slowly roll belt back on the pulley and motor drive. Put your cover guard back on with two screws and done. Read more...

Videos!

Your Price

$38.95

Whirlpool Washer Dryer Motor Pulley

★★★★★

7 Reviews

PartSelect Number PS11744884

Manufacturer Part Number WP8066184

The WP8066184 is a dryer motor pulley that is used in some dryer models. It supports the motor belt where it connects with the motor. Symptoms of failure include squealing or grinding noise during drum rotation. Please use the model number of the appliance to check for compatibility before purchasing.

Fixes these symptoms

Drum Not Spinning
Noisy
See more...

Installation Instructions

holly from LONG BCH TWP, NJ

Drum not turning; accompanied by loud "screeching" sound.

Followed instructional video provided for this type of repair after diagnosing problem via of 'troubleshooting' on PartsSelect site. Simple, safe, and relatively easy (minimal mechanical knowledge helpful).
Second time using PartSelect; washing machine repair ~ 6 mo. previous.
PartSelect was spot-on with that repair as well, saving hundreds of dollars.....my go-to site for appliance repairs and pats....make it yours as well and you will NOT be disappointed! Fast, prompt shipping. Read more...

Videos!

Your Price

$89.13

Whirlpool Washer Drum Drive Pulley

★★★★★

1 Review

PartSelect Number PS11745017

Manufacturer Part Number WP8182650

This drive pulley attaches to the back of the washers drum.

Fixes these symptoms

Will not agitate
See more...

Installation Instructions

Francis from Rochester, NY

Washer made loud banging noise during spin cycle

I first removed the back panel held on by about 10 screws. I removed the drive belt from the pulley, then removed the lock nut securing the pulley to the drum & removed the pulley. Attached the new pulley to the drum, tightened on the lock nut, attached the new belt & ran a spin cycle. When that went OK I replaced the back panel & the washer was back in service. Read more...