Popular Microwave Parts

Your Price
$8.87
   In Stock
Microwave Light Bulb - 40W
★★★★★
★★★★★
157 Reviews
PartSelect Number PS2376034
Manufacturer Part Number 8206232A
This 40w light bulb is a replacement bulb constructed of glass and metal. It is an easy-to-install electrical part which produces 40w of light. If the bulb won't light up then it may be broken and should be replaced. The bulb attaches directly to an appropriate light socket and has a small screw-in base. To access the exterior light bulb, you will need to remove the panel on the bottom of the microwave using a Phillips screwdriver. If your exterior light bulb has not been changed before, it is probably held in place with some silicone. You will need to cut away this silicone to remove the old bulb. If you cannot access the silicone with a utility knife, it can be removed using dental floss. Once the silicone is removed, simply unscrew the old bulb, and replace it with the new one. Be sure to disconnect the power to the microwave before you begin this repair. This light bulb measures about 1 1/8 inches. We do not recommend using a higher-wattage bulb for this appliance, and can only recommend this specific bulb. If fixing the bulb does not solve your microwave light issue, it's possibly a problem with the socket, which means the socket and/or board will need to be replaced. This can be a more dangerous repair, so consult your user manual or a technician before attempting.
Installation Instructions
Chris from Cedar Hill, TX
Burned out light under microwave and Filters needed changing
I just removed the multiple screws which held the hood cover on. I then attempted to remove the light bulbs from the socket. This proved impossible because the bulbs were so fragile from the heat and grease build up. To make this task much easier and probably safer, just replace the bulb housing and light bulb. The bulb housing unplugs very easily. Just replace it then screw your new bulb in. P.S. Be sure to unplug appliance before you start.

The filters are very easy to replace. No tools needed.

Hope this helps.
Read more...
Your Price
$11.52
   In Stock
Microwave Charcoal Filter
★★★★★
★★★★★
31 Reviews
PartSelect Number PS1871363
Manufacturer Part Number 8206230A
This Charcoal Filter traps grease from your oven's exhaust to help prevent it from entering the vent, which could cause damage over time. If the exhaust fan on your microwave is not working, you may need to replace your charcoal filter. This charcoal filter is located within the intake grille of your microwave, which will need to be unscrewed and opened to gain access to the filter. The manufacturer recommends that you change your charcoal filter every six months. This filter measures 5 inches by 5.375 inches by 0.375 inches. Be sure to measure your current filter to assure correct replacement. This product is sold individually. We recommend the use of gloves during installation to protect your hands from messy grease during your repair. You should also unplug your appliance at the electrical outlet or switch it off at the breaker. Using a Phillips screwdriver, unthread the screws securing the grill. Open the door and slide the grill to the left and lift it up to remove it. This will allow access to the filter so it can be either replaced or cleaned. Remember to insert the tabs of the grill into the frame and slide it to the right when you are done. To finish, shut the oven door and secure the grill with the screws.
Fixes these symptoms
Installation Instructions
Richard from San Antonio, TX
Mounting brackets are fragile and plastic support is easily broken
Replaced the intake grille. The grille should be removed prior to cleaning. The entire part is plastic and easily broken so that the two tabs for the mounting screws are shattered and will not hold the part in place. If one attempts to clean the grille using only a moderate amount of pressure with a cloth the fragile plastic will break. The part is poorly designed. When the vent is removed to replace the charcoal filter, one may discover that the grille has already been broken in a previous cleaning operation. Read more...
Your Price
$35.41
   In Stock
Microwave Grease Filter
★★★★★
★★★★★
56 Reviews
PartSelect Number PS3650910
Manufacturer Part Number W10208631A
This Grease Filter is constructed of Acrylonitrile Butadiene Styrene and is used to trap grease and help eliminate odors from the exhaust air while cooking. It attaches onto the exhaust and is rated as easy to install. The part is 12 15/16" x 5 3/4", and comes in silver. Refer to your make and model number to ensure this part is right for you. If the exhaust fan of your appliance is not working, this part is the most likely cause. This part is sold individually, and it should be noted that many microwaves require two filters, so you may need to replace both at the same time by purchasing two of this part. You should consider gloves during this simple repair (which requires no tools) to save yourself from getting greasy hands.
Fixes these symptoms
Installation Instructions
Mark from SCHAUMBURG, IL
Dirty filters
Remove top grill assembly and replaced filters,parts were delivered on time and fit as expected, Job well done! Read more...
Your Price
$9.35
   In Stock
Microwave GREASE FILTER
★★★★★
★★★★★
1 Review
PartSelect Number PS12722303
Manufacturer Part Number WB02X32793
This is a grease filter compatible with various microwaves. Grease filters are used to collect food grease and prevent buildups on the internal components of the microwave, such as the fans and other electronics. This grease filter is made of mesh and measures 7.5 inches long by 5 inches wide. If your current microwave grease filter is clogged with grease and not able to be easily cleaned, it should be replaced. This filter can be replaced easily by pulling on its D-clasp and pushing the new filter into place. Depending on how many filters your microwave uses, you may want to consider how many you need before ordering. This filter is an OEM part and is sold individually.
Installation Instructions
Richard from SAN ANTONIO, TX
lamp out
unscrew small nut from glass plate underneath micro used a small Phillips screw driver and inserted new lamp into socket and Inserted glass plate and secured with small nut w/ screws drivet Read more...
Your Price
$12.24
   In Stock
Microwave FILTER,GREASE
★★★★★
★★★★★
31 Reviews
PartSelect Number PS12713651
Manufacturer Part Number 5230W1A012E
This is a single grease filter manufactured for a microwave. The microwave grease filter filters the exhaust air and traps any grease flowing out of the appliance. It is important to keep the filter clean and intact by cleaning it regularly and replacing it when needed. A clogged air filter can cause your appliance to run inefficiently and possibly alter the taste and smell of your food. This filter is approximately 7.5 inches wide and 5 inches deep. This part is sold separately. No tools are required for this repair, the filter simply slides in and out using the easy-pull tab on the filter.
Installation Instructions
David from Smithfield, VA
Grill Vent Broken Tabs
Piece of cake. Grill arrived quickly, was easily installed with a Phillips head screwdriver, needed for the two upper screws which most folks don't think about - Hence the need for this part, since the charcoal filter is behind the grill and most people don't think about replacing this. Easy installation of all filters. Thanks! Read more...
Your Price
$22.13
   In Stock
Microwave Halogen Light Bulb - 120V 20W
★★★★★
★★★★★
41 Reviews
PartSelect Number PS2351821
Manufacturer Part Number WB25X10019
This light bulb is located on the inside of your microwave. The bulb is behind the top grill. It will need to be replaced when it has burnt out and no longer works. Unplug the unit before beginning this repair. Remove the top grill of your microwave, use your screwdriver to open the light socket, scrape off any silicone holding the bulb in place, clean the area of any oil and dirt, insert the new bulb into the socket without touching the bulb, slide the holder back into place, line up the tabs on top of the metal plate, and secure the holder back into place.
Installation Instructions
Anita D from LACEY, WA
original grease filter fell apart while washing it and couldn't be put back together
Can't believe GE Profile allows such a flimsy filter to be used at all. These filters should not just fall apart while running water through them.

I ordered replacement 4 replacements because I'm sure this will happen again. Part Select fortunately had replacements! You just slide the new filter in place, no tools required. Thanks Part Select.
Read more...
Your Price
$18.86
   In Stock
Microwave Grease Filter
★★★★★
★★★★★
25 Reviews
PartSelect Number PS3506741
Manufacturer Part Number WB02X11534
This is a replacement grease filter for your microwave. Sometimes known as the air filter, this part fits underneath your microwave and catches grease. As a result, your grease filter can become clogged, and this is the part you will need to replace it. It measures approximately 7 inches by 7 inches. Most microwaves have two grease filters, but this part is sold individually.
Installation Instructions
Mark from GRAND BLANC, MI
Lens cracked and bulbs burned out
First I removed the single screw holding the lens assembly in place. Then I lowered the assembly and tilted it until it came out. To remove the existing cracked glass lens there were four tabs bent down on it. By hand I lifted each tab just enough to remove the broken lens. I then replaced the broken lens with the new one and re-bent the tabs down by hand to secure them to the new lens.

The lens assembly, now removed, revealed the cavity that contained the two halogen bulbs. Since they were both burned out for days, they weren't hot so I could pull each one out by hand. The bulbs are secured by two straight heavy gauge wire leads and provided a little resistance but come out fairly easily. Make a mental note of the angle they came out so it will be easier to replace them with new ones.

You're not supposed to touch halogen bulbs with your bare hands, so I used the bubble wrap they came in as a means to hold the bulb while installing it.

Be sure to insert the bulbs at the same angle they came out so the pins do not get bent.

Once both bulbs are in place, replace the lens cover assembly by putting the end opposite where the screw hole goes in first on the right, then swing it up until flush and screw it down.
Read more...
Your Price
$12.46
   In Stock
Microwave CHARCOAL FILTER
★★★★★
★★★★★
1 Review
PartSelect Number PS16216937
Manufacturer Part Number WB02X35687
This charcoal filter is a genuine OEM replacement part that is compatible with various models of microwave. It has a length of approximately 8 inches by 5 inches. The filter is designed to absorb odors, grease, and smoke generated during cooking and vent them outside or recirculate clean air back into the kitchen. The charcoal filter consists of activated charcoal, which is highly effective at trapping airborne particles. If there is a persistent odor in the kitchen even after cleaning the microwave and surrounding area, it may indicate that the charcoal filter is saturated and no longer effective. Additionally, if there is visible damage to the filter, such as cracks or holes, the filter should be replaced. It is recommended to replace the filter every 6 months.
Your Price
$7.95
   On Order
Microwave LATCH
PartSelect Number PS12746282
Manufacturer Part Number 5304522796
Fixes these symptoms
Your Price
$54.60
   In Stock
Microwave Vent Grille - Black
★★★★★
★★★★★
50 Reviews
PartSelect Number PS3535252
Manufacturer Part Number MDX61912701
This is replacement vent grille or vent grill for your microwave. You will find the grill vent either above or below the microwave door, depending on your model. If your vent grill is discolored or cracked, or if the mounting brackets for the grill are broken, you may need to replace the grill. This part is made of black plastic and is approximately 24 inches long and 3.5 inches wide. This product is sold individually.
Fixes these symptoms
Installation Instructions
Andy from PERRYSBURG, OH
Vent Grille tabs snapped off
Repair was easy but you have to remove the screw at the top of the microwave (top left) in order to secure the far left tab with the hole in the tab. Place the grille in place, push to the left and then secure the screw you removed. Just remember that the mounted screw will need to be removed the next time you need access in order to replace the charcoal filter. Read more...

Microwave Brands

Related Microwave Parts

Popular Microwave Models

Below are the most popular Microwave models we have. Enter your model number in the search box to find your model.