Shindaiwa Parts
Popular Shindaiwa Parts
Your Price
$6.59
In Stock
Shindaiwa Primer
PartSelect Number PS11826485
Manufacturer Part Number P005003120
This Primer Bulb is a clear, plastic, individually sold part with an Outer Diameter of 0.720 inches (18.30 mm) and a Height of 0.674 inches (17.12 mm). With Flange: 0.842" (21.40 mm). This part is rated as Easy to install by customers, and attaches to the primer pump assembly.
If the part shows signs of breakage, such as cracks appearing due to the bulb drying out, or fatigue, then it must be replaced. Refer to your owners manual/model number to ensure you are choosing the correct part.
Fixes these symptoms
- Will Not Start
- See more...
Your Price
$5.36
In Stock
Shindaiwa Fuel Filter
PartSelect Number PS11826311
Manufacturer Part Number A369000480
This OEM Fuel Filter is a silver and white, steel/felt, part measuring about 1.25 inches in length and 3/4 inch wide. It can be installed with pliers and is rated as Easy to install by customers.
This part attaches inside the fuel tank to clean the fuel of debris, and should be replaced during regular maintenance, check your manual for recommended replacement time. If the filter is leaking or it has a blockage preventing fuel flow, then it should be replaced. If the engine sounds like it is not getting enough fuel, then remove the filter and check it for blockage.
Installation Instructions
Paul from SENECA, SC
Fuel line grommet rotted
This blower is quite old looked on YouTube. Removed grommet with needle nose pliers. Removed tank to install new parts. I had trouble getting return line off carb so planned to reuse it after grommet was in place. Thin was a mistake because the seated grommet compresses the holes. Took unnecessary time to get it through. With my trimmer with all lines in place. Hardest part was to get the grommet to seat even with silicone.
Read more...
Your Price
$4.99
In Stock
Shindaiwa Fuel Line Grommet
PartSelect Number PS8859978
Manufacturer Part Number 13211546730
This fuel line grommet is compatible with several types of outdoor power equipment. The fuel line grommet creates a seal where the fuel line enters and exits the fuel tank. It is made of black rubber and this version has 3 holes. If your fuel tank or fuel lines are leaking fuel, or your current fuel grommet is worn out, you should consider replacing it. This item is sold individually.
Installation Instructions
Donald from ORANGE PARK, FL
fuel tank leaking around where lines went in tank
took all the old parts off and replaced them
Read more...
Your Price
$4.98
In Stock
Shindaiwa Primer Pump
PartSelect Number PS8858167
Manufacturer Part Number 12318140630
The Primer Pump, aka the Pump Bulb, is a clear, individually sold, plastic part, sourced from the original equipment manufacturer. It has an Outer Diameter of 0.616 Inches, 15.66mm and is 0.558 Inches and 14.19mm in height. This part is used to pump fuel from the tank to the carburator and is rated Easy to install.
This part installs onto the primer assembly. If the part dries out or starts leaking that means it is broken (likely due to fatigue or general wear) and must be replaced. Check the model number to ensure you are choosing the right part.
Your Price
$3.99
In Stock
Shindaiwa Spark Plug Bpm-8Y
PartSelect Number PS9263506
Manufacturer Part Number 15901019830
This Spark Plug Bpm-8y is a silver and white OEM part. Made of steel and ceramic it is individually sold, and is an electrical part. It is installed with a spark plug socket and is rated as Easy to install. It is attached inside of the cylinder head, and is used to ignite the air fuel mixture inside the combustion chamber.
You can clean the spark plug with a fine sandpaper of 180 or more, then spray it with carburator cleaner and wipe dry. However, even after regular maintenance, spark plugs need to be changed as part of good engine fine-tuning. Regap to manufacturer specifications. Refer to your owners manual or model number to ensure you are choosing the correct product.
Note: If your engine has more than one cylinder and sounds like it has a miss, you can remove each spark plug wire one at a time to find the miss. If the engine drops in rpm when you remove the wire, then that cylinder is fine, if it does not drop then you have found your miss!
Your Price
$7.09
In Stock
Shindaiwa Air Filter
PartSelect Number PS9195232
Manufacturer Part Number A226001410
This part is the replacement air filter for your small engine, used for outdoor power equipment. It has a black plastic rim that is approximately 2.5 inches by 2.5 inches. The air filter in your small engine prevents dirt and debris from entering the cylinder, where it can cause more serious damage. If your air filter is clogged, it can decrease your engine performance, and it will need to be cleaned or replaced. If the filter is damaged, it will need to be replaced as well. This is an OEM part sourced directly from the manufacturer, and is it sold individually.
Installation Instructions
Paul from SENECA, SC
Fuel line grommet rotted
This blower is quite old looked on YouTube. Removed grommet with needle nose pliers. Removed tank to install new parts. I had trouble getting return line off carb so planned to reuse it after grommet was in place. Thin was a mistake because the seated grommet compresses the holes. Took unnecessary time to get it through. With my trimmer with all lines in place. Hardest part was to get the grommet to seat even with silicone.
Read more...
Your Price
$4.99
In Stock
Your Price
$8.60
Special Order
Shindaiwa Filter, Fuel
Pull off old filter and replace with new. Push back into fuel tank & be done. Read more...
PartSelect Number PS11826309
Manufacturer Part Number A369000460
The Fuel Filter is a white and silver, individually sold, steel part. It reuires pliers to install and its installation is rated as Easy.
The part attaches inside of the fuel tank and is used to clean the fuel of debris. It should be changed regularly. Check your owners manual for the recommended replacement schedule for your engine.
If the fuel is leaking or their is a blockage, you will know the part is broken and will likely need to be replaced. To check for small leaks, feel around for dampness and the smell of fuel.
Installation Instructions
Keith from NORWOOD, NJ
Replace clogged fuel filter.
Thru fuel cap, insert copper wire with hook formed on end. Fish around until you grab the fuel line. Pull the fuel line and filter thru the fuel fill neck.Pull off old filter and replace with new. Push back into fuel tank & be done. Read more...
Your Price
$7.63
In Stock
Shindaiwa Fuel Tank Vent
PartSelect Number PS9183121
Manufacturer Part Number A356000031
This a a genuine OEM replacement check valve for your small engine. It is also known as a fuel tank vent. You may need to replace this part if you are noticing debris or dirty oil in the reservoir. Make sure the engine is cool before you begin this repair, and remove the wire and boot from the spark plug to prevent the engine from starting up.
Installation Instructions
Donald from ORANGE PARK, FL
fuel tank leaking around where lines went in tank
took all the old parts off and replaced them
Read more...
Your Price
$5.19
In Stock
Shindaiwa Fuel Return Tube 3x6x90mm
PartSelect Number PS8862036
Manufacturer Part Number 13201056330
The fuel return tube or fuel return line, as it is also known, delivers fuel back to the tank from the primer bulb. This is a genuine OEM part from the manufacturer, and it is yellow in color and sold individually. Its overall dimensions are 3x6x90mm. Over time, or due to over-tightening, cracks may appear in your fuel return tube, causing fuel to leak. You will know it is time to replace this part if you notice these symptoms.
This is an easy repair, according to our customers, and does not require any special tools. The new part will simply attach to the primer bulb and fuel tank.
Installation Instructions
Paul from SENECA, SC
Fuel line grommet rotted
This blower is quite old looked on YouTube. Removed grommet with needle nose pliers. Removed tank to install new parts. I had trouble getting return line off carb so planned to reuse it after grommet was in place. Thin was a mistake because the seated grommet compresses the holes. Took unnecessary time to get it through. With my trimmer with all lines in place. Hardest part was to get the grommet to seat even with silicone.
Read more...
Related Shindaiwa Parts
- Shindaiwa Blower Parts
- Shindaiwa Chainsaw Parts
- Shindaiwa Clearing Saw Parts
- Shindaiwa Cultivator Parts
- Shindaiwa Edger Parts
- Shindaiwa Hedge Trimmer Parts
- Shindaiwa Pole Saw Parts
- Shindaiwa Power Broom Parts
- Shindaiwa Sprayer Parts
- Shindaiwa Spreader Parts
- Shindaiwa String Trimmer Parts
- Shindaiwa Water Pump Parts
Popular Shindaiwa Models
Below are the most popular Shindaiwa models we have. Enter your model number in the search box to find your model.
- 110 Electric Chainsaw
- T344 Grass Trimmers (T)
- T344 Trimmer
- T344 Grass Trimmers (T)
- T344 Trimmer
- M2510 Multi-Tool
- C302 Brushcutters (C)
- M2500 Multipurpose Tool
- 450 Chainsaw
- T230X Gas Trimmer
- 300 Gas Chainsaw
- 757 Chainsaw
- T270 Trimmer
- EB802 Backpack Blowers
- T242 Trimmer
- EB630 Blowers Backpack
- EB630 Blower
- EB802RT Backpack Blowers
- PB270 Power Broom
- 500 Gas Chainsaw
