Edger Parts
Popular Edger Parts
Your Price
$14.33
In Stock
Edger Blade (New Style, Washers for this blade p/n 243797-00)
PartSelect Number PS11925341
Manufacturer Part Number 243801-00
Your Price
$22.11
In Stock
Edger Fuel Tank Assembly W/Fuel Lines Incl. 29
PartSelect Number PS11812933
Manufacturer Part Number 753-06797
The fuel tank assembly is responsible for storing and supplying fuel to the engine in lawn and outdoor power equipment. It includes the tank, fuel cap, and fuel lines. The fuel tank assembly will fail if the tank develops cracks or leaks, or if the fuel lines can become clogged. When the fuel tank assembly fails, you will notice fuel leakage, restricted fuel supply, stalling, difficulties starting and overall lower performance. Before beginning any repairs, first drain any remaining fuel from the tank for your safety. Disconnect the fuel lines from the tank and remove the fuel tank from the equipment. Position the new tank on to the mounting holes and secure it in place. Connect the fuel lines to the engine and vent to complete your repair.
Installation Instructions
Robert from ORANGE, CA
One of the two fuel lines cracked and leaking
Removed the 6 screws holding the red plastic cover, tank, and the old fuel lines from the carburetor. Placed the new tank in the sunlight for a few minutes to soften the new fuel lines. Then attached the new lines to the carburetor and replaced the cover
Read more...
Your Price
$6.08
In Stock
Edger Air Cleaner Element
PartSelect Number PS10039827
Manufacturer Part Number A100631
This foam air cleaner element helps to keep dirt and debris out of the engine in your lawn equipment. It is sometimes called an air filter element, cartridge, or insert. You can find it near the engine in a housing that lets air into the combustion chamber, where it gets mixed with fuel. This fuel-air mixture produces energy that powers the engine when it is ignited by the spark plug. If the element gets dirty or clogged, you will need to replace it. If you do not replace it, you may notice black smoke coming out of your machine. Your engine will work poorly and might use more gas than it should. To remove your element, refer to your user manual for instructions, as the steps may vary from one model to another. Generally, you need to locate the element housing and remove the screws or clips that hold its cover in place. You can then carefully remove the element from inside. This genuine OEM replacement part is sold individually.
Installation Instructions
Manuel from SELMA, NC
edger will not run longer than 1 minute
I replaced the carburetor, air filter, cleaned out the gas tan and replaced the fuel line and filter. As a last resort I replaced the gas cap and gas still will not flow from the gas tank to the carburetor. I have worked on engines of all sizes over the years and this one has me stumped.....by the way I am 71 years old:) If anyone has an idea please le me know.
Read more...
Your Price
$6.59
In Stock
Edger Primer
PartSelect Number PS11826485
Manufacturer Part Number P005003120
This Primer Bulb is a clear, plastic, individually sold part with an Outer Diameter of 0.720 inches (18.30 mm) and a Height of 0.674 inches (17.12 mm). With Flange: 0.842" (21.40 mm). This part is rated as Easy to install by customers, and attaches to the primer pump assembly.
If the part shows signs of breakage, such as cracks appearing due to the bulb drying out, or fatigue, then it must be replaced. Refer to your owners manual/model number to ensure you are choosing the correct part.
Fixes these symptoms
- Will Not Start
- See more...
Your Price
$4.99
In Stock
Edger Fuel Line Grommet
PartSelect Number PS8859978
Manufacturer Part Number 13211546730
This fuel line grommet is compatible with several types of outdoor power equipment. The fuel line grommet creates a seal where the fuel line enters and exits the fuel tank. It is made of black rubber and this version has 3 holes. If your fuel tank or fuel lines are leaking fuel, or your current fuel grommet is worn out, you should consider replacing it. This item is sold individually.
Installation Instructions
Donald from ORANGE PARK, FL
fuel tank leaking around where lines went in tank
took all the old parts off and replaced them
Read more...
Your Price
$6.62
In Stock
Edger Blade
PartSelect Number PS9971402
Manufacturer Part Number 530095086
These Weed Eater Blades are 8-3/8 x 1-1/2 inch black, metal blades which come individually sold and attach to the output shaft. Installation requires a wrench set and socket set, and is rated as "Easy". This blade is used for edging the grass around walkways and driveways. If the blade hits pavement it may break, and you will notice a vibration or poor trimming, and the part must be replaced. Refer to your make model, and diagrams to ensure you're choosing the correct part.
Your Price
$4.98
In Stock
Edger Primer Pump
PartSelect Number PS8858167
Manufacturer Part Number 12318140630
The Primer Pump, aka the Pump Bulb, is a clear, individually sold, plastic part, sourced from the original equipment manufacturer. It has an Outer Diameter of 0.616 Inches, 15.66mm and is 0.558 Inches and 14.19mm in height. This part is used to pump fuel from the tank to the carburator and is rated Easy to install.
This part installs onto the primer assembly. If the part dries out or starts leaking that means it is broken (likely due to fatigue or general wear) and must be replaced. Check the model number to ensure you are choosing the right part.
Your Price
$3.99
In Stock
Edger Spark Plug Bpm-8Y
PartSelect Number PS9263506
Manufacturer Part Number 15901019830
This Spark Plug Bpm-8y is a silver and white OEM part. Made of steel and ceramic it is individually sold, and is an electrical part. It is installed with a spark plug socket and is rated as Easy to install. It is attached inside of the cylinder head, and is used to ignite the air fuel mixture inside the combustion chamber.
You can clean the spark plug with a fine sandpaper of 180 or more, then spray it with carburator cleaner and wipe dry. However, even after regular maintenance, spark plugs need to be changed as part of good engine fine-tuning. Regap to manufacturer specifications. Refer to your owners manual or model number to ensure you are choosing the correct product.
Note: If your engine has more than one cylinder and sounds like it has a miss, you can remove each spark plug wire one at a time to find the miss. If the engine drops in rpm when you remove the wire, then that cylinder is fine, if it does not drop then you have found your miss!
Your Price
$7.46
In Stock
Edger Fuel Line (25" Length)
PartSelect Number PS9472350
Manufacturer Part Number 530069599
This Fuel Line is a 25-inch, clear, plastic line used to deliver fuel. It requires a screwdriver, pliers, socket set, and nut driver and is rated as "Easy" to install by customers. If the fuel line wear out to the point of breaking, cracks and/or leaking will appear and the part should be replaced. Refer to your make, model and diagram to ensure this is the correct part for you.
Your Price
$9.16
In Stock
Edger Blade
PartSelect Number PS9129938
Manufacturer Part Number 781-0080-0637
This Edger Blade is a black, metal blade which is sold individually and comes certified from the manufacturer. Installation is rated as "Easy" and requires a socket set and wrench set. This blade attaches to the drive shaft and is used for edging the grass around driveways and walkways. If this part becomes worn/fatigued/damaged (which may happen after hitting the pavement) you will notice an odd vibration and poor trimming, at which time the part should be replaced.
Edger Brands
- Airstream Edger Parts
- Ariens Edger Parts
- Bolens Edger Parts
- Craftsman Edger Parts
- Cub Cadet Edger Parts
- Echo Edger Parts
- Homelite Edger Parts
- Husky Edger Parts
- Husqvarna Edger Parts
- Kawasaki Edger Parts
- Little Wonder Edger Parts
- MTD Edger Parts
- Paramount Edger Parts
- Poulan Edger Parts
- Powermate Edger Parts
- Ryobi Edger Parts
- Shindaiwa Edger Parts
- Southland Edger Parts
- Tanaka Edger Parts
- Toro Edger Parts
- Troy-Bilt Edger Parts
- Weed Eater Edger Parts
- Yard Machines Edger Parts
- Yard Man Edger Parts
Related Edger Parts
- Edger Bearings
- Edger Blades
- Edger Brackets and Flanges
- Edger Caps and Lids
- Edger Carburetors
- Edger Engines
- Edger Filters
- Edger Handles
- Edger Hardware
- Edger Hoses and Tubes
- Edger Knobs
- Edger Manuals and Literature
- Edger Seals and Gaskets
- Edger Spark Plugs
- Edger Springs and Shock Absorbers
- Edger Starters
- Edger Transmissions and Clutches
- Edger Wheels and Rollers
- Edger Wire Plugs and Connectors
Popular Edger Models
Below are the most popular Edger models we have. Enter your model number in the search box to find your model.
- 128LD 128 Ld - 20093100001-Current (Us_can)
- 128LD 128 Ld - 952711953 (Us_lowes)
- 128LD 128 Ld - 952711969 (Us_can)
- 970 Electric Edger
- 128CD 128 Cd - 952711968 (Us_can)
- 128CD 128 Cd - 952711952 (Us Only)
- PE550 Gas Edger
- PE550 Gas Edger
- PE550 Gas Edger
- PE550 Gas Edger
- PE550 Gas Edger
- 224L 224 L
- 123L 123 L
- UT13140 4-Cycle Lawn Edger
- PWLE0799 79cc 4-Cycle Lawn Edger
- TM6000X8NB Tm6000x8nb - Edgers And Trimmers
- 323L 323 L (20041000001-20051800000)
- 323L 323 L (20061400001-20070100000)
- 323L 323 L (20070100001-20080900000)
- 323L 323 L (20020100001-20041000000)
