Whirlpool Washer Filters
Popular Whirlpool Washer Filters
Whirlpool Washer Charcoal Filter
PartSelect Number PS1871363
Manufacturer Part Number 8206230A
This Charcoal Filter traps grease from your oven's exhaust to help prevent it from entering the vent, which could cause damage over time. If the exhaust fan on your microwave is not working, you may need to replace your charcoal filter. This charcoal filter is located within the intake grille of your microwave, which will need to be unscrewed and opened to gain access to the filter. The manufacturer recommends that you change your charcoal filter every six months. This filter measures 5 inches by 5.375 inches by 0.375 inches. Be sure to measure your current filter to assure correct replacement. This product is sold individually. We recommend the use of gloves during installation to protect your hands from messy grease during your repair. You should also unplug your appliance at the electrical outlet or switch it off at the breaker. Using a Phillips screwdriver, unthread the screws securing the grill. Open the door and slide the grill to the left and lift it up to remove it. This will allow access to the filter so it can be either replaced or cleaned. Remember to insert the tabs of the grill into the frame and slide it to the right when you are done. To finish, shut the oven door and secure the grill with the screws.
Fixes these symptoms
- Exhaust fan not working
- No heat
- Noisy
- See more...
Installation Instructions
Richard from San Antonio, TX
Mounting brackets are fragile and plastic support is easily broken
Replaced the intake grille. The grille should be removed prior to cleaning. The entire part is plastic and easily broken so that the two tabs for the mounting screws are shattered and will not hold the part in place. If one attempts to clean the grille using only a moderate amount of pressure with a cloth the fragile plastic will break. The part is poorly designed. When the vent is removed to replace the charcoal filter, one may discover that the grille has already been broken in a previous cleaning operation.
Read more...
Whirlpool Washer Inner Tub Filter Plug Kit
A lot of time was used to clean the filthy tub and basket.
While replacing the broken motor coupling I decided to replace some of the seals.
PartSelect got the ordered parts to me in a couple of days.
I wouldn't hesitate to do the job again. Read more...
PartSelect Number PS334684
Manufacturer Part Number 285868
Kit contains 4 plugs - replaces the lint filter that goes under spin basket. The filter under the spin basket is no longer required. Replaces round filter assembly.
Fixes these symptoms
- Marks left on clothes
- See more...
Installation Instructions
Bob from East Palestine, OH
The motor turned with loud noise ,but nothing else worked
I used "Emley's Cheap and Easy Repair" book to remove,install and reassemble the machine. A lot of time was used to clean the filthy tub and basket.
While replacing the broken motor coupling I decided to replace some of the seals.
PartSelect got the ordered parts to me in a couple of days.
I wouldn't hesitate to do the job again. Read more...
Whirlpool Washer Screen
1st I removed both water hoses
2nd I removed 1 hex head screw that released a backing plate & removed the plate holding the water inlet valve.
3rd I pulled the 4 electrical connections & loosened a clamp to remove a small water hose.
4th I removed 2 hex head screws that held the water valve to the backing plate.
-----------that was a whole 5 - 10 minutes!------------
Next I reversed the process
4th I attached the inlet valve with the 2 hex head screws
5th re-attached the 4 electrical connections(had slip on spades) pushed on the hose & tighterned the clamp.
6th replaced the backing plate with the inlet valve attached & tightened the single hex head screw.
7th re-attached the hot & cold lines................................DONE
15 minutes tops Read more...
PartSelect Number PS11746894
Manufacturer Part Number WP96160
Found on the water inlet valve.
Installation Instructions
Peter from Aurora, IL
The fill cycles would start then stop suddenly
This was an easy repair. 1st I removed both water hoses
2nd I removed 1 hex head screw that released a backing plate & removed the plate holding the water inlet valve.
3rd I pulled the 4 electrical connections & loosened a clamp to remove a small water hose.
4th I removed 2 hex head screws that held the water valve to the backing plate.
-----------that was a whole 5 - 10 minutes!------------
Next I reversed the process
4th I attached the inlet valve with the 2 hex head screws
5th re-attached the 4 electrical connections(had slip on spades) pushed on the hose & tighterned the clamp.
6th replaced the backing plate with the inlet valve attached & tightened the single hex head screw.
7th re-attached the hot & cold lines................................DONE
15 minutes tops Read more...
Whirlpool Washer Agitator Lint Filter
PartSelect Number PS11743344
Manufacturer Part Number WP63840
This lint filter sits on top of your washer's agitator. Not only does it filter the lint out of your washing machine, but it also helps the agitator to move clothing around on the inside of your washing machine.
Fixes these symptoms
- Will not agitate
- See more...
Installation Instructions
Virginia from Philadelphia, PA
The old lint filter was worn, and would "pop up" so that clothes weren't being moved about during the wash and rinse cycles. If I didn't frequently push it down again, it would fly off during a spin cycle. Dangerous!
I simply lifted the lint filter and its cap off, pressed the new agitator cap onto the new lint filter and put the assemblage into place. No tools needed at all. A $50 dollar repair saved me from replacing my washer/dryer! I'm very pleased.
Read more...
Whirlpool Washer Lint Filter and Upper Agitator
PartSelect Number PS11743343
Manufacturer Part Number WP63753
This part serves two functions for your washing machine: lint filter and upper agitator.
Fixes these symptoms
- Will not agitate
- See more...
Installation Instructions
Patty from Caldwell, ID
Dishwasher leaving food residue on all dishes
Had to take apart dishwasher and replace chopper assembly. The dishwasher had a lot of debris in in including pieces of broken plastic forks. Now works great
Read more...
Related Whirlpool Washer Parts
- All Whirlpool Washer parts
- Whirlpool Washer Agitators
- Whirlpool Washer Bearings
- Whirlpool Washer Belts
- Whirlpool Washer Brackets and Flanges
- Whirlpool Washer Caps and Lids
- Whirlpool Washer Circuit Boards and Touch Pads
- Whirlpool Washer Dispensers
- Whirlpool Washer Doors
- Whirlpool Washer Drawers and Glides
- Whirlpool Washer Drums and Tubs
- Whirlpool Washer Handles
- Whirlpool Washer Hardware
- Whirlpool Washer Hinges
- Whirlpool Washer Hoses and Tubes
- Whirlpool Washer Knobs
- Whirlpool Washer Latches
- Whirlpool Washer Legs and Feet
- Whirlpool Washer Motors
- Whirlpool Washer Panels
- Whirlpool Washer Pumps
- Whirlpool Washer Seals and Gaskets
- Whirlpool Washer Springs and Shock Absorbers
- Whirlpool Washer Switches
- Whirlpool Washer Timers
- Whirlpool Washer Transmissions and Clutches
- Whirlpool Washer Valves
- Whirlpool Washer Wire Plugs and Connectors