Whirlpool Washer Motors
- Search your model number to find:
- Genuine OEM parts guaranteed to fit
- Free manuals and guides
- Repair instructions and videos
Popular Whirlpool Washer Motors
Your Price
$20.95
In Stock
Whirlpool Washer Direct Drive Motor Coupling
First take off the water pump by removing the two clips that hold it in place. Place a shallow pan under the pump to catch the water that is in the pump and hoses. Open the hose clamps with a pair of pliers or channel locks (better) and slide the hoses off of the water pump.
The motor comes off next. Unplug the electrical connector from the motor and two wires from the capacitor. Remove the two screws holding the clamps in place and then pop off the two clamps. You will need to hold up the motor with one hand while you remove the clamps or it will fall to the floor once the clamps are removed.
One piece of the coupling assemble will be attached to the motor and the other will be attached to the gearcase drive shaft. If you want to clean up the mess created by the shredded rubber center piece of the coupling assembly you will have to take off the motor mounting plate. It is held on by two bolts and removing it makes installing the coupling easier but probably not necessary.
Push the back half of the coupling on to the gearcase drive shaft until the shaft is flush with the face of the coupling. Install the new rubber center piece on to the coupling then re-install the motor mounting plate. Install the other half of the coupling on to the motor shaft and lift the motor up to the coupling. You have to rotate the motor shaft by spinning the fan blades until the coupling lines up so you can slide it into the other half of the coupling. Then just reattach the motor, connectors and water pump in the reverse order of disassembly. Read more...
PartSelect Number PS1485646
Manufacturer Part Number 285753A
This direct drive motor coupling (Direct Drive Washer Motor Coupling, Motor Coupling, Washer Motor Coupling, Coupling Kit) provides a cushioned connection between the transmission and the motor shaft. It attaches to the direct-drive transmission and the motor shaft. If this part is defective it will affect the agitator in your washer because of its direct connection with the motor. Your washer may not agitate, spin slowly, or not spin at all. The coupling must be replaced when there is no longer a consistent connection between the transmission and the motor shaft. The coupling can wear over time because of its location between two major parts of the dryer. It is subject to material fatigue over time from normal use, or breakage caused by frequent overloading. The part measures approximately 2 inches in diameter, and is constructed of plastic and metal. This model comes in black/white.
Fixes these symptoms
- Burning smell
- Leaking
- Noisy
- See more...
Installation Instructions
Jeff from Wayne, NJ
No movement from Basket & agitator
The job looked intimidating but turned out to be very easy.First take off the water pump by removing the two clips that hold it in place. Place a shallow pan under the pump to catch the water that is in the pump and hoses. Open the hose clamps with a pair of pliers or channel locks (better) and slide the hoses off of the water pump.
The motor comes off next. Unplug the electrical connector from the motor and two wires from the capacitor. Remove the two screws holding the clamps in place and then pop off the two clamps. You will need to hold up the motor with one hand while you remove the clamps or it will fall to the floor once the clamps are removed.
One piece of the coupling assemble will be attached to the motor and the other will be attached to the gearcase drive shaft. If you want to clean up the mess created by the shredded rubber center piece of the coupling assembly you will have to take off the motor mounting plate. It is held on by two bolts and removing it makes installing the coupling easier but probably not necessary.
Push the back half of the coupling on to the gearcase drive shaft until the shaft is flush with the face of the coupling. Install the new rubber center piece on to the coupling then re-install the motor mounting plate. Install the other half of the coupling on to the motor shaft and lift the motor up to the coupling. You have to rotate the motor shaft by spinning the fan blades until the coupling lines up so you can slide it into the other half of the coupling. Then just reattach the motor, connectors and water pump in the reverse order of disassembly. Read more...
Your Price
$92.56
In Stock
Whirlpool Washer Dryer Drive Motor W/pulley
1) Removed back - 6 screws
2) Removed dryer vent - 2 screws on top, 3 on bottom
3) Popped the top open
4) Removed Front of dryer cabinet - 2 screws
5) Removed Belt
6) Removed Drum
7) Cleaned up all lint
8) Pop off motor retainers front and back
Here is the tricky part for me.
9) Removed vent fan on back of motor.
I did not know that the back of the fan was square, and you could put an open ended wrench on it to hold it while you also have a vice grip on the front motor shaft. Then its a simple left to loosey operation. I first tryed to turn the fan blade to take it off, but proved to be to tight.
10) Repeat backwards to reassemble
While I had it apart I also replaced the Drum support rollers & Installed a new belt. Not that diffucult of a repair Good Luck, was certainly better than buying a new one at + $300.00 at Black Friday rates. Read more...
PartSelect Number PS334304
Manufacturer Part Number 279827
This motor fits most Whirlpool incorporated dryer brands before 1996. NOTE: Pulley is NOT available separately.
Fixes these symptoms
- Drum Not Spinning
- Noisy
- Will Not Start
- See more...
Installation Instructions
Mark from Fremont, NE
Wife told me Dryer would make a funny sound, then stop + had an a funny smell as well. The Electric motor that drove the unit was overheating and locking up, It was time to be replace.
The best part of my repair was I had everything back in service in 3 days. And one of these days was to consider just buying a new dryer. Had parts overnited and all parts fit and easy to replace.1) Removed back - 6 screws
2) Removed dryer vent - 2 screws on top, 3 on bottom
3) Popped the top open
4) Removed Front of dryer cabinet - 2 screws
5) Removed Belt
6) Removed Drum
7) Cleaned up all lint
8) Pop off motor retainers front and back
Here is the tricky part for me.
9) Removed vent fan on back of motor.
I did not know that the back of the fan was square, and you could put an open ended wrench on it to hold it while you also have a vice grip on the front motor shaft. Then its a simple left to loosey operation. I first tryed to turn the fan blade to take it off, but proved to be to tight.
10) Repeat backwards to reassemble
While I had it apart I also replaced the Drum support rollers & Installed a new belt. Not that diffucult of a repair Good Luck, was certainly better than buying a new one at + $300.00 at Black Friday rates. Read more...
Your Price
$145.60
In Stock
Whirlpool Washer 2speed Drive Motor 60hz 120v
PartSelect Number PS11743427
Manufacturer Part Number WP661600
This is a 2-speed drive motor for your washing machine. The motor rotates the spin basket when the washing machine is in spin or tumbling mode. You will likely need to replace the motor if you are experiencing burning smells or your washer will not start. The tools you will need to make this repair include a number two Phillips screwdriver, a flat-blade screwdriver, and a 5/16 nut driver.
Fixes these symptoms
- Burning smell
- Will not agitate
- Will not drain
- See more...
Installation Instructions
Lowell from Dover, DE
Washer had water leak in lower front and would not drain.
Laid the washer on its back and found leak in water pump. Found out it was caused by vibration from motor with bad bearing. Removed pump and motor which were held on by clips. Both were removed and replaced without removing cabinet from machine.
Read more...
Your Price
$124.11
In Stock
Whirlpool Washer Rotor
PartSelect Number PS11769961
Manufacturer Part Number W10915701
This motor rotor connects to the spin basket shaft and rotates the spin basket in washers. Unplug the washer before installing, and wear work gloves for safety. Verify compatibility with your model before purchasing.
Fixes these symptoms
- Spinning Issues
- See more...
Your Price
$95.99
In Stock
Whirlpool Washer Rotor
PartSelect Number PS12584381
Manufacturer Part Number W11260238
Stay at the forefront of appliance maintenance with this genuine ROTOR from Whirlpool. Specifically built for efficient compatibility with various models of Whirlpool, KitchenAid, Maytag, Jenn-Air, Amana, Inglis, and Magic Chef, its prime function is attaching to the spin basket shaft, thus aiding the rotation of the spin basket. Ensure safe installation by unplugging your washer and wearing work gloves for protection. Let ROTOR's performance consistency cater to your appliance care requirements. The significance of verifying your model and part number before ordering cannot be overemphasized for perfect fit and top-tier function. Remember, parts may appear identical, but critical differences in size and shape can impact performance.
Your Price
$184.54
In Stock
Whirlpool Washer Motor Rotor
PartSelect Number PS10064560
Manufacturer Part Number W10754161
The motor rotor connects to the spin basket shaft and rotates the spin basket
Your Price
$138.66
In Stock
Whirlpool Washer Stator
PartSelect Number PS11769960
Manufacturer Part Number W10915700
Introducing the STATOR from Whirlpool - a genuine OEM part, meticulously crafted for select models of Whirlpool, KitchenAid, Maytag, Jenn-Air, Amana, Inglis, and Magic Chef appliances. This motor stator plays an integral role in the functionality of your washer, working harmoniously with the motor rotor to effortlessly rotate the spin basket. To ensure the longevity of your appliance and to keep it running smoothly, it's advised to unplug your washer during the installation of this part. Remember, even though parts might appear same, subtleties in size and shape can make a significant difference. Therefore, please verify that the part number is accurate for your specific model before purchasing. Lastly, for your safety, always wear work gloves during the installation process.
Your Price
$163.15
In Stock
Whirlpool Washer Drive Motor
PartSelect Number PS11770267
Manufacturer Part Number W11026785
The drive motor spins the spin basket and drives the agitator or spin basket in the agitation or tumbling mode.
Your Price
$120.23
In Stock
Whirlpool Washer Motor Stator
PartSelect Number PS10064559
Manufacturer Part Number W10754158
Enhance the performance of your washing machine with the Genuine Motor Stator from Whirlpool. Specifically designed to function impeccably with some models of Whirlpool, KitchenAid, Maytag, Jenn-Air, Amana, Inglis, and Magic Chef, this motor stator ensures high-grade operation. It teams up with the motor rotor to rotate the spin basket, facilitating optimal spin performance. Bear in mind it's advisable to disconnect the washing machine before undertaking any installations and consider wearing work gloves to guard your hands. Please ensure this part is correct for your model before purchase, as parts may vary slightly in size and shape. Trust in Whirlpool's commitment to providing quality appliance parts.
Your Price
$123.43
In Stock
Related Whirlpool Washer Parts
- All Whirlpool Washer parts
- Whirlpool Washer Agitators
- Whirlpool Washer Bearings
- Whirlpool Washer Belts
- Whirlpool Washer Brackets and Flanges
- Whirlpool Washer Caps and Lids
- Whirlpool Washer Circuit Boards and Touch Pads
- Whirlpool Washer Dispensers
- Whirlpool Washer Doors
- Whirlpool Washer Drawers and Glides
- Whirlpool Washer Drums and Tubs
- Whirlpool Washer Electronics
- Whirlpool Washer Elements and Burners
- Whirlpool Washer Filters
- Whirlpool Washer Handles
- Whirlpool Washer Handles and Latches
- Whirlpool Washer Hardware
- Whirlpool Washer Hinges
- Whirlpool Washer Hoses and Tubes
- Whirlpool Washer Knobs
- Whirlpool Washer Latches
- Whirlpool Washer Legs and Feet
- Whirlpool Washer Lights and Bulbs
- Whirlpool Washer Panels
- Whirlpool Washer Power Cords
- Whirlpool Washer Pulleys
- Whirlpool Washer Pumps
- Whirlpool Washer Seals and Gaskets
- Whirlpool Washer Sensors
- Whirlpool Washer Springs and Shock Absorbers
- Whirlpool Washer Switches
- Whirlpool Washer Timers
- Whirlpool Washer Transmissions and Clutches
- Whirlpool Washer Valves
- Whirlpool Washer Wheels and Rollers
- Whirlpool Washer Wire Plugs and Connectors