Whirlpool Washer Knobs

Popular Whirlpool Washer Knobs

Your Price
$11.09
  In Stock
Whirlpool Washer Control Knob
★★★★★
★★★★★
5 Reviews
PartSelect Number PS11757250
Manufacturer Part Number WPW10711289
This control knob is for dryers. Control knob lets you control cycle settings. Remove the knob by pulling it straight off its post.
Installation Instructions
JEFFREY from MODESTO, CA
The broke of the knob and had to replace the whole mother board and the knob
I had to remove the whole top of the washer and unplugged all the wire to the board. Getting the board out was the hardest thing to do because no screws it was clamped in place. Once I figured how to unclamped the thing without breaking it, it was relatively simple and to only 15 min to button it back up. Read more...
Your Price
$11.09
  In Stock
Whirlpool Washer D-Shaped Knob Insert
★★★★★
★★★★★
2 Reviews
PartSelect Number PS11746209
Manufacturer Part Number WP8536939
This insert is sold individually. Knob not included. Knob is sold separately.
Installation Instructions
Larry from HICKORY, NC
The main knob insert snapped.
Nothing to it. Just remember to put the insert in the knob, NOT on the selector stem. Line up the flat part of the insert with the flat part of the stem and push the knob in place.

Don NOT ram it on the selector stem. When it's seated, don't push any more. That's all there is to it. It works. If the pointer on the knob indicates the selector is lined up correctly, but it isn't, the problem is the selector, not the knob.
Read more...
Your Price
$45.31
  In Stock
Whirlpool Washer Timer Knob
★★★★★
★★★★★
49 Reviews
PartSelect Number PS11741232
Manufacturer Part Number WP3362624
This replacement timer knob is black with a chrome center. Use this improved timer knob with its metal threads for your clothes washer. Colors Almond, Toast and Platinum are discontinued.
Fixes these symptoms
Installation Instructions
Carol from Bluffton, IN
Threaded section of knob broke
I merely unscrewed the remainder of broken knob and attached the new knob which has a metal stem and should be much more durable. Piece of cake. Read more...
Your Price
$43.60
  In Stock
Whirlpool Washer Control Knob
★★★★★
★★★★★
21 Reviews
PartSelect Number PS11744940
Manufacturer Part Number WP8181859
This knob is light gray and is used on platinum-colored models. Sold individually and accepts a D-shaped shaft.
Installation Instructions
eric from Boulder, CO
Belt Wheel was broken at axle. Terrible noise.
Removed the top and back of dryer with screw socket. It was quite easy. Then, I removed the broken wheel by releasing the tension spring. I replaced the wheel. The toughest part was re-threading the belt. But, even that was simple. The dryer runs smoothly and quietly again! Read more...
Your Price
$18.83
  In Stock
Whirlpool Washer Push Button
PartSelect Number PS11754596
Manufacturer Part Number WPW10424308
This push button is just over three inches long. It is all black in color and is made of plastic.
Fixes these symptoms
Your Price
$40.00
  In Stock
Whirlpool Washer Knob
★★★★★
★★★★★
2 Reviews
PartSelect Number PS11756281
Manufacturer Part Number WPW10558463
Your Price
$51.34
  In Stock
Whirlpool Washer Timer Knob
PartSelect Number PS10067044
Manufacturer Part Number W10756270
(4 Pack)
Installation Instructions
Mario from OXNARD, CA
Timer knob popped off. Base rod into knob snapped. Needed new timer
Removed back panel screws. Left/Right, Center.
Grabbed Canned Air and sprayed inside panel. Lots of lint ...
Unscrew timer - Single center top screw. Tiny threads, kind of wide head.
Unplug 4 wire adapters .. (top/left/right/bottom).
All 4 pin adapters have unique A/B side. Can't mix up.
Reconnect wires, tighten top center screw.
Before closing up panel, plug in test with empty tumble to confirm if dryer heats up. (Gas Dryer).
All good, has worked great.
Read more...
Your Price
$44.20
  In Stock
Whirlpool Washer KNOB
★★★★★
★★★★★
6 Reviews
PartSelect Number PS11738143
Manufacturer Part Number W10875909
Your Price
$47.05
  In Stock
Whirlpool Washer Hold to Start Button - Aqua
PartSelect Number PS11744942
Manufacturer Part Number WP8181861
Fixes these symptoms
Installation Instructions
Richard from FREDERICKSBRG, TX
The hold to start button would not start wash cycle
After disassembly per the video, I identified the plastic bracket holding the button had broken allowing the hold to start button to shift from pushing the red button on the circuit board to start the door latching cycle. I glued the plastic bracket with JB Weld after holding it in proper position with Gorilla Tape. After letting it dry over night, I reassembled and the original Hold to Start button worked fine. I did not need the replacement button as I originally thought. The disassembly process took 15 minutes. Take the time to break the front of the washer down per the video prior to ordering parts. Read more...
Your Price
$25.99
  In Stock
Whirlpool Washer Control Knob
★★★★★
★★★★★
2 Reviews
PartSelect Number PS11744944
Manufacturer Part Number WP8181881
This knob is used to control settings on a washer.
Installation Instructions
Dave from JOSHUA, TX
Broken knob on washer and dryer
Old knobs were broken, replaced with new knobs, no tools, just push new knobs on controls. Read more...

Related Whirlpool Washer Parts