General Electric Dishwasher Valves

Popular General Electric Dishwasher Valves

Your Price
$43.78
  In Stock
General Electric Dishwasher Water Inlet Valve
★★★★★
★★★★★
54 Reviews
PartSelect Number PS3654179
Manufacturer Part Number WD15X10014
This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoid on the valve open and close according to the desired amount of water needed.
Fixes these symptoms
  • Leaking
  • Not cleaning dishes properly
  • Not draining
  • See more...
Installation Instructions
Greg from Burlington, VT
Water leak, small puddle to front left of dishwasher
You'll need to remove the front toe kick and (if installed, the GE Profile baffling for additional silencing action).

You will need to disconnect the right wire connection to access the right screw (and may need to use a flat head screwdriver). You can then remove the 2 screws that hold the Valve Water Inlet on.

You will then need to loosen and the hose clamp that attaches the water line to the Valve Water Inlet. You may need to force it undone since the rubber connection is pretty secure around the water tube inlet.

Disconnect the plastic wire housing from the Valve Water Inlet and you should now have the Valve Water Inlet disconnected.

Reverse the order and reconnect everything and you should be good to go!

Double-check for any leaks prior to pushing everything back in :)
Read more...
Your Price
$24.32
  In Stock
General Electric Dishwasher Piston and Nut Assembly
★★★★★
★★★★★
19 Reviews
PartSelect Number PS260690
Manufacturer Part Number WD24X10018
This is used for the check valve.
Fixes these symptoms
  • Leaking
  • Not cleaning dishes properly
  • Not draining
  • See more...
Installation Instructions
Dan from Minnetonka, MN
Dishwasher wouldn't fully drain
I removed the four screws holding the screen and molded plastic cage inside the rear of the dishwasher to expose the check valve assembly. I then unscrewed the piston and nut assembly with my hand and replaced it with the new one. I found that the rubber cone shaped valve on the old piston and nut assembly was entirely disintegrated. This easy repair solved the problem. Read more...
Your Price
$95.37
  In Stock
General Electric Dishwasher Water Inlet Valve
★★★★★
★★★★★
14 Reviews
PartSelect Number PS259368
Manufacturer Part Number WD15X10003
This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed. This valve has a 3/8" inlet and comes with the mounting bracket.
Fixes these symptoms
  • Leaking
  • Not cleaning dishes properly
  • Not draining
  • See more...
Installation Instructions
mike from huntley, IL
Dish washer is not running through cycles
First and formost before you buy read everything in trouble shooting your dishwasher. Then you do not buy parts you do not need. First you turn off power, then water. Remove two screws, a rubber hose and a hard line by unscrewing if you are lucky some contractors might sweat this on. No biggie just two extra steps that's all. do in reverse to assemble... Read more...
Your Price
$36.02
  In Stock
General Electric Dishwasher Drain Valve Shaft Seal
★★★★★
★★★★★
11 Reviews
PartSelect Number PS263930
Manufacturer Part Number WD8X181
The drain valve shaft seal is a part for your dishwasher drain pump valve. This seal creates a watertight closure around the flapper valve shaft. This part can be accessed through the access panel at the front for a built-in. For a portable dishwasher, consider disconnecting and unplugging the taps and lay on a blanket to access the bottom of the machine. This will need to be replaced if you notice leaking coming from the pump. This part measures approximately 3/8 inches in diameter and is black in color. This is a genuine OEM part that comes right from the manufacturer.
Fixes these symptoms
Installation Instructions
Joseph from Livermore, CA
Water leak from gate (diverter) valve shaft
This was a fairly simple repair. After disconnecting power to the dishwasher and removing the panel below the door, first had to remove a retainer C clip from the gate valve shaft. Then disconnected the linkage from the gate valve solenoid, removed two return springs and slid the gate valve contol arm off the shaft. Then removed the solenoid bracket that was fastened to the housing by 2 screws. This allowed access to the push on nut on the valve shaft. Removed the old push on nut which exposed the leaking seal. Removed the bad seal, then moistened and carefully slid on and seated the new drain valve shaft seal. Affixed new push on nut. Reinstalled the above mentioned parts that were removed. Problem solved - no more leak. Total cost $18.81 for factory GE parts plus $6.95 shipping. Thank you PartSelect. Read more...
Your Price
$47.71
  In Stock
General Electric Dishwasher Water Inlet Valve
★★★★★
★★★★★
8 Reviews
PartSelect Number PS259411
Manufacturer Part Number WD15X93
This water inlet valve is specially designed for those dishwashers that fit under the counter from 1974 To Present. The valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed.
Fixes these symptoms
  • Leaking
  • Not cleaning dishes properly
  • Not draining
  • See more...
Installation Instructions
Don from Mount Vernon, IL
Insufficient fill water, dishes not getting clean (valve diaphram had ruptured)
1. Remove lower cover skirt.
2. Shut of water at undersink valve.
3. Unplug power cord or turn off circuit breaker.
4. Disconnect water supply line from fill valve.
5. Unplug the electrical connector from the valve.
6. Remove the 2 valve mounting bracket screws.
7. With loose valve in hand, rotate to gain access to allow release of outlet hose clamp for hose removal.
8. Remove brass fitting from old valve and install on new valve. Use teflon tape on the pipe threads only.

Install new valve by reversing the procedure.
Read more...
Your Price
$88.99
  In Stock
General Electric Dishwasher Water Inlet Valve
PartSelect Number PS259369
Manufacturer Part Number WD15X10004
May look different than the original, but will function the same.
Fixes these symptoms
Installation Instructions
Brad from wadsworth, OH
water inlet valve leaking
I had a shut off water supply shut off shut under my sink. That is where I shut the water off for the dishwasher. I knew it was for the dishwasher ,because it follow the line, and could see it was going to the washer. Then I went down stairs in the basement. Opened my breaker box, and found the breaker for the dish washer marked dish washer, and put in the off position. When I was still up stairs I opened dish washer , and inside at the top was two screws holding the dishwasher to the counter top. Those two screws turned out to be the exact size of just about every screw I ended up having to unscrew on this machine. So at the time I was in the basement turning off breaker, I went to the garage to gather up tools. Take the two screws that are screwed to the counter top. Then I layed on the floor, and at the bottom of the dish washer there is a panel on the front of the machine with screws attaching it. Take those screws out. Pull off cover. Now get a flash light so you can see. They're adjustable feet that the dishwasher are being leveled by. Those feet need to most likely be adjusted down so you can the machine pulled out, and make it possible to work on. now you can you can pull it out, but watch that water supply line does not get hung up, or electrical wires. Once the machine is pulled out there is another cover on the front that I took off. Four screws hold it on. Now you can get to the part to fix it. The other thing you need to know is after taking off the valve and taking off the old 90 fitting. It will need cleaned up. When you put it on the new shut off valve use pipe dope or thread tape so it doesn't leak. Good luck. Read more...
Your Price
$78.88
  In Stock
General Electric Dishwasher WATER VALVE W/SCREWS
★★★★★
★★★★★
2 Reviews
PartSelect Number PS959010
Manufacturer Part Number WD15X10009
Fixes these symptoms
Your Price
$23.38
  In Stock
General Electric Dishwasher Check Valve
PartSelect Number PS259812
Manufacturer Part Number WD1X5488
Also available in a kit.
Fixes these symptoms
Your Price
$20.94
  Special Order
General Electric Dishwasher Body Valve and Drain Check
PartSelect Number PS260539
Manufacturer Part Number WD22X10018
Fixes these symptoms
Installation Instructions
Joseph from Macomb Twp, MI
Water was not completely draining from the dishwasher after last rinse cycle
I used Partselect.com to bring up my model #. Partselect.com provided complete breakdown of the part and where it was located. It was very easy following the diagrams provided. Read more...
Your Price
$23.21
  Special Order
General Electric Dishwasher VALVE
PartSelect Number PS263325
Manufacturer Part Number WD37X115

Related General Electric Dishwasher Parts