Whirlpool Dishwasher Sensors

Videos!

Your Price

$31.36

Whirlpool Dishwasher Turbidity Sensor

★★★★★

5 Reviews

PartSelect Number PS11757214

Manufacturer Part Number WPW10705575

Measures level of soil in the water.

Fixes these symptoms

Leaking
Not cleaning dishes properly
Not draining
See more...

Installation Instructions

Mark from Lancaster, NY

Failed diagonistics test for OWI sensor

Pulled the dishwasher out from the counter, on the lower right hand side, about mid way back there is a bundle of all yellow wires, follow that to the sensor which mounts into the bottom of the wash tub. The sensor is easily removed by grasping it by hand and turn it about a half turn (can't remember which direction). It then just pulls out. Disconnect the wire bundle by pushing on the retaining clip and the install is the reverse. Read more...

Your Price

$21.89

Whirlpool Dishwasher Sensor

PartSelect Number PS12745367

Manufacturer Part Number W11410464

Your Price

$51.26

Whirlpool Dishwasher Sensor

PartSelect Number PS12070543

Manufacturer Part Number W11084121

Fixes these symptoms

Not cleaning dishes properly
See more...

Installation Instructions

Melvin from SACRAMENTO, KY

would not shut off.

easy the sensor was on the right side, and easy to get to, I turn off the power, turned off the water, and pulled it out, the first thing I saw was the yellow wires and plug. took about 5 minutes, to replace it. Read more...

Your Price

$16.90

Whirlpool Dishwasher Sensor

PartSelect Number PS16744936

Manufacturer Part Number W11612329

Your Price

$51.26

Whirlpool Dishwasher Sensor

PartSelect Number PS12578552

Manufacturer Part Number W11226898

Your Price

$91.76

Whirlpool Dishwasher Thermistor

PartSelect Number PS11745500

Manufacturer Part Number WP8269208

This part is used to regulate water temperature when certain cycles or options are selected. The thermistor is part of the sensor mounted in the tub.

Fixes these symptoms

Not cleaning dishes properly
Will Not Start
See more...

Installation Instructions

Deb from LaPorte, IN

Stopped Running,Will Not Start, and Clean LED Blinks 7 times then repeats

Got Maintenance Flyer out an read about problem
Removed access plate
Disconnectd water and drain
Removed anchor screws
Pulled unit out and disconnedted from Electric
Flipped on it's back
Ohmed out all heat related items and found discrepency with Thermisitor resistance
Ordered and received Part
Changed out Thermisitor
Checked wiring to Heater and replaced connections
Hooked electric up
Ran Diognostics per Maintenance flyer and cleared fault
Hooked back up and ran like a champ

The reason it took so long is because I put the old thermisitor back in and tryed to run the diognostics just to make sure that was the problem Read more...