Whirlpool Dishwasher Wheels and Rollers
Popular Whirlpool Dishwasher Wheels and Rollers
42% OFF
Your Price
$26.89
$46.00
In Stock
Whirlpool Dishwasher Lower Dishrack Wheel
PartSelect Number PS3406971
Manufacturer Part Number W10195416
This OEM gray Dishwasher Lower Dishrack Wheel Assembly is a plastic kit that allows the rack to slide in and out of the dishwasher easily. If it breaks or becomes damaged. sliding will feel difficult. This can happen due to normal wear and tear, and the part should be replaced if this occurs. Check your model number and user manual to make sure this part is correct. It attaches directly to the dishrack. To repair, open the dishwasher door and pull out the lower dishrack. Next, push the tab from both sides and it should pop out. To install the new wheel assembly, place it on the rack and make sure the caps overlap the wire from the inside before you clip it in place by pushing the wheel. It measures roughly 3x6 inches.
Fixes these symptoms
- Door latch failure
- Door won’t close
- Leaking
- See more...
Installation Instructions
Thomas from WEST OLIVE, MI
Broken wheel unit on the bottom dish rack
All you do is pop out the old wheel unit at two (2) points on the plastic wheel housing and pop in the new one. Easy fix. Less than a 5 minute fix.
Read more...
Whirlpool Dishwasher Lower Dishrack Wheel Assembly
PartSelect Number PS11750057
Manufacturer Part Number WPW10195417
This gray plastic lower dishrack roller is a part for your dishwasher. It attaches to the bottom of the lower dishrack, allowing it to move in and out smoothly. If the lower dishrack stops moving in and out easily or preventing you from being able to shut the dishwasher door, inspect the dishrack roller for damage. The assembly includes 2 rollers and the bracket that attaches to the dishrack (parts are not sold separately). This assembly is sold individually, so you will need 4 assemblies to replace them all in your appliance. For this easy repair, start by removing the lower dishrack from the appliance and set it on the counter. Use a screwdriver to pry off the old roller assembly from the lower tabs. Align the new part on the dishrack by snapping it in place.
Fixes these symptoms
- Door latch failure
- Door won’t close
- See more...
Installation Instructions
Barbara from BETHESDA, MD
One of the rollers broke of on the lower dish rack
Snapped the old one off and snapped the new one on.
Read more...
Your Price
$20.89
In Stock
Whirlpool Dishwasher Dishrack Adjuster and Wheel Assembly
PartSelect Number PS11756470
Manufacturer Part Number WPW10571738
This dishrack adjuster and wheel assembly is for dishwashers and lets you adjust the dishrack height and attaches the track wheels to the dishrack.
Fixes these symptoms
- Not cleaning dishes properly
- See more...
Installation Instructions
Alfred L from WESTBOROUGH, MA
The wheels on the bottom ‘basket’ are only fastened by a ‘Snap-in’ (plug) style connector that gets brittle and breaks over time
Pop off the shell assembly from the bottom basket and clip/click on a new wheel assembly.
Read more...
Whirlpool Dishwasher Upper Dish Rack Wheel Mount
PartSelect Number PS11745459
Manufacturer Part Number WP8268743
This upper dish rack wheel mount can be used on either side of your dish rack. It is sold individually. The part includes the wheel and support, which attaches to the dish rack and allows it to slide in and out easily.
Fixes these symptoms
- Door latch failure
- Door won’t close
- Noisy
- See more...
Installation Instructions
Jason from Todd, NC
Worn dishrack wheel mount
This wheel mount broke from normal use and made the upper dish rack disconnect from the sliding arm that extends it outside the dishwasher body so that you can fill it. The part was delivered quickly and was easy to install using just a screwdriver to loosen the retainer clip on the end of the extension slide. Once the retainer clip was removed, the new part was slid into place and clipped onto the rack. The install was complete.
Read more...
Your Price
$29.36
In Stock
Whirlpool Dishwasher Upper Rack Wheel with Mount
PartSelect Number PS11745451
Manufacturer Part Number WP8268655
This is a replacement upper dish rack wheel with mount for your dishwasher. The mount supports the dish rack, and the wheel allows the rack to slide out easily. To replace this part, remove the rack stops and pull out the upper dish rack. This wheel mount pops off, and the new one can be snapped into place.
Fixes these symptoms
- Door latch failure
- Door won’t close
- Noisy
- See more...
Installation Instructions
James from Gulfport, MS
The wheels on the upper dish rack broke
I removed the end caps on the slides with needle nose pliers, removed the old wheels and installed the new ones, then I snapped the slide end caps back on. Super responsive service from PartSelect.com Thanks!
Read more...
Your Price
$11.09
In Stock
Whirlpool Dishwasher Rack Adjuster
PartSelect Number PS11750255
Manufacturer Part Number WPW10204131
This OEM dishrack roller and adjuster is found in your dishwasher. They work together to support and facilitate the smooth movement of your dishrack. The dishrack rollers are small wheels located on the sides of the dishrack and allow it to slide in and out effortlessly. Meanwhile, the dishrack adjuster is used to adjust the height via the selector at the back of this component. Over time, the rollers wear out. You may experience resistance or difficulty when sliding the dishrack in or out. If left unreplaced, your rollers or adjuster may break, causing dishes to tilt, collide, or fall over during the wash cycle. When removing a roller and adjuster from your appliance, you will need to pull out the dishrack partway. Detach the assembly by depressing the tabs on the two end stops before lifting them up. Keep in mind that the roller and adjuster are sold together, but the dishrack itself is sold separately.
Installation Instructions
Randy from Glenview, IL
Replacement of broken Rack Assembly Mount with Wheel
The only piece that may be a little difficult to remove here without a tool is the 'Track Stop'. This piece has a couple of clip-like pieces that need to be depressed in order to remove it. A flathead screw driver will do the trick. Once this piece is out and you have popped the Mount off of the Rack, you simply roll the piece out of the track, roll the new one in and snap the new Mount in place, replacing the Track Stop when you are done. VERY EASY!
Read more...
Your Price
$11.29
In Stock
Whirlpool Dishwasher Upper Rack Wheel and Mount Assembly
PartSelect Number PS11745525
Manufacturer Part Number WP8270019
Sold Individually.
Fixes these symptoms
- Not cleaning dishes properly
- See more...
Installation Instructions
Kevin from Hurst, TX
top dw rack fell off of rollers
Amazingly, this not-too-old dishwasher's plastic parts that hold the top rack onto the sliders became brittle (a real design flaw, in my opinion) and the tabs that held the rollers in place all broke off. With the right parts and the great instructions on this site, the repair was fairly easy and we saved a lot of $$ by not having to call for service. Just follow the instructions...
Read more...
Whirlpool Dishwasher Upper Rack Roller
PartSelect Number PS11753471
Manufacturer Part Number WPW10350401
This assembly is the wheel and the mount for your upper dishrack. Sold individually. This is an authentic OEM part for use with Whirlpool, KitchenAid, Kenmore and Jenn-Air Dishwashers. The dishrack wheel lets you roll the rack easily on the support rails. This part is sold individually. The most common reason for replacing the dishrack wheel is if it breaks causing the rack to jam. The tool that you will need to replace the dishrack wheel is a flathead screwdriver.
Fixes these symptoms
- Door won’t close
- See more...
Installation Instructions
Richard from TRUCKEE, CA
Fully loaded top rack would detach from track when pulled out for emptying.
Removed dishwasher from cabinetry to replace tub rollers (4). Replaced roller sets (4) on top rack. Also replace both rails and rail stops. Screwdriver was only tool required for this part of repair. Needed wrench and screwdriver to remove and replace dishwasher in lower cabinetry.
Read more...
Whirlpool Dishwasher Upper Rack Wheel
PartSelect Number PS11748156
Manufacturer Part Number WPW10078214
Sold individually.
Installation Instructions
Rhonda from STATESVILLE, NC
Broken wheel upper rack
Pulled tip off wheel rack in slid broken wheel out slid new wheel in replaced plastic gray end of rack
Read more...
Your Price
$49.67
In Stock
Whirlpool Dishwasher Lower Dishrack Wheel
PartSelect Number PS11748193
Manufacturer Part Number WPW10082868
This part attaches to the lower dishrack.
Installation Instructions
mary from LA GRANGE PK, IL
dish rack wheels plastic broken
just replaced broken piece ,,,, very easy ,,, will use you again for parts should the need arise
Read more...
Related Whirlpool Dishwasher Parts
- All Whirlpool Dishwasher parts
- Whirlpool Dishwasher Brackets and Flanges
- Whirlpool Dishwasher Caps and Lids
- Whirlpool Dishwasher Circuit Boards and Touch Pads
- Whirlpool Dishwasher Dishracks
- Whirlpool Dishwasher Dispensers
- Whirlpool Dishwasher Doors
- Whirlpool Dishwasher Ducts and Vents
- Whirlpool Dishwasher Filters
- Whirlpool Dishwasher Handles
- Whirlpool Dishwasher Hardware
- Whirlpool Dishwasher Hoses and Tubes
- Whirlpool Dishwasher Latches
- Whirlpool Dishwasher Motors
- Whirlpool Dishwasher Panels
- Whirlpool Dishwasher Pumps
- Whirlpool Dishwasher Racks
- Whirlpool Dishwasher Seals and Gaskets
- Whirlpool Dishwasher Spray Arms
- Whirlpool Dishwasher Springs and Shock Absorbers
- Whirlpool Dishwasher Switches
- Whirlpool Dishwasher Wire Plugs and Connectors