Craftsman Snow Blower Transmissions and Clutches

Your Price

$29.97

Craftsman Snow Blower Friction Disc Wheel

★★★★★

3 Reviews

PartSelect Number PS9263021

Manufacturer Part Number 1501435MA

Installation Instructions

Kenneth from ALDAN, PA

Refurbishing for next winter season

I replaced the auger belt and drive belt by separating the machine. The auger belt alone can be replaced by simply tilting without separating but the drive belt can not. So after separating the machine, I removed the auger belt by loosening the belt guide and removing the tensioner. I then loosened the nut that secures the drive wheel. This gave me enough play to remove the drive belt from the drive tensioner and then wiggle it from the drive wheel and out of the machine. Install by wiggling the belt back behind the drive wheel until you can slip it on the wheel. pull tensioner pulley out of the way to get the belt on the top pulley. Tighten the nut to secure the drive wheel. Reconnect the machine at the bottom of the auger housing and replace the auger belt, tensioner, and belt guide. Complete by replacing the upper bolts that hold the two parts together. I have not replaced the friction wheel as of yet. My process took 30 - 45 minutes for both belts. Read more...

Your Price

$48.35

Craftsman Snow Blower Worm Gear

PartSelect Number PS9165943

Manufacturer Part Number 917-04861

This is a worm gear that is designed for use within a variety of snowblowers and snowblower tractor attachments. The worm gear is used to rotate the auger through the drive mechanism, also known as the transmission. Featuring an approximately 2-inch diameter, this worm gear is made of high-quality, durable metal and is sold as an individual part. The worm gear will likely be secured in place using bolt or other fastener, and replacing this gear will require a wrench set and screwdriver. Make sure to check any user manuals or diagrams for exact placement of the worm gear within your snowblower.

Your Price

$143.17

Craftsman Snow Blower Chute Rotation Gearbox

PartSelect Number PS11813283

Manufacturer Part Number 918-04801B

Installation Instructions

Ralph from SALT LAKE CTY, UT

The chute rotation assembly was stuck

I ordered a replacement chute rotation gearbox. The small metal ball on the end of the cable (on the replacement part) was attached about 1/8" too long and made it so that there was too much play in the trigger that operates it. Thus, the replacement part did not work. I called customer service for directions about returning the part. They said it must have been defective. I'm still waiting for instructions about returning it for a refund. The whole thing was a bust. I ended up disassembling the old gearbox and fixing it, instead of replacing it (which would have been my preference). The replacement part did not work at all! Read more...