GTW220ACK2WW General Electric Washer - Instructions
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Agitator teeth were stripped
Pulled the nut off the inside middle piece of agitator and replaced part.
Parts Used:
-
Denzil from Crest Hill, IL
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Wrench set
1 person
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Out of balance often
After loosening top screws on back ,snaps in front,no need to total remove top changing springs you have to reach below top of case with vice gripes and attach to spring rod about 8 inch down and lift up (tuff for 80 year old) tap down on plastic retainer, turn retainer 1/2 turn so hook will slip out ,now lower spring it will fall out of bottom retainer. Now for reinstall ,instead of vice gripes on the spring down inside case with no room , by hand take new (correct color) spring reach deep inside and install bottom into bottom retainer now take old spring run long end hook threw retainer hole in top case, hook to hook ,now you can pull new spring easy out the top about 3 inches and now vice gripes above case with enough room to reinstall top retainer remove gripes now only 3 more to go
Parts Used:
-
RANDALL from HOBBS, NM
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:30 - 60 mins
-
Tools:Nutdriver, Pliers
1 person
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
The machine would not start all the time.
-
Henry from GAINESVILLE, FL
-
Difficulty Level:Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Screw drivers, Socket set
1 person
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Water dripping after washing was done
Watch a YouTube video on how to fix it. Video was really easy to follow
Parts Used:
-
Kevin from MANCHESTER, PA
-
Difficulty Level:Really Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Nutdriver, Pliers, Screw drivers, Socket set
1 person
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Washer wouldn’t drain
-
Ronald from Chickasha, OK
-
Difficulty Level:Really Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Pliers, Screw drivers
1 person
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
washed well but would not shift out of spin cycle
easiest repair I have ever made. No problems and was surprised as to how fast and easy it was to repair. I did not need two of steps the instructions stated I had to do. best purchase I have ever made.
Parts Used:
-
terry from MILLINGTON, TN
-
Difficulty Level:Very Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Socket set
2 of 4 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!