General Electric Microwave Motors

Your Price

$37.95

General Electric Microwave Drive Motor

★★★★★

37 Reviews

PartSelect Number PS237772

Manufacturer Part Number WB26X10038

This is a microwave turntable drive motor. This is a genuine OEM replacement part. It accepts a D-shaped drive shaft. The drive motor is located under the glass microwave turntable, and allows the turntable plate to rotate while the appliance is in use. Your drive motor might be broken if it is noisy or does not turn at all. Be sure to disconnect power to the microwave before starting this repair. Simply unscrew the bottom plate and the drive motor of your microwave, disconnect the wires, and install the replacement part. This drive shaft is 21 volts, is about 2 inches in diameter, and is made of metal.

Fixes these symptoms

Noisy
Tray won’t turn
Won’t turn on
See more...

Installation Instructions

GERRY from BONITA SPRINGS, FL

No Water From Dispencer

Repairs went just fine done I about 20 min. Read more...

Your Price

$37.89

General Electric Microwave Motor Synchronous

★★★★★

20 Reviews

PartSelect Number PS3529208

Manufacturer Part Number 6549W1S011B

This AC synchronous motor is a genuine OEM replacement part specially made for microwaves. It operates on an alternating current, and it is responsible for rotating the turntable to ensure even heating of your food. The motor can fail due to physical damage or malfunctioning internal components such as the bearings. If your turntable is not rotating, you will need to replace the motor. You can find it underneath the microwave cavity, near the center. Disconnect the microwave from the power source and remove the cover. Turn the microwave over and remove the bottom panel to access the motor. Disconnect the motor from its mounting location, and then insert the new motor in its place. Ensure the new motor is securely attached before reassembling the appliance.

Fixes these symptoms

Noisy
Tray won’t turn
See more...

Installation Instructions

Steven from Oak Forest, IL

Motor Burned Out On Turntable

My 8 year old daughter cleaned the inside of the microwave with enough water to rival a tsunami. Resulted in a clean microwave with a fried out motor that no longer revolved. Part came quickly. Took cover and bottom off to get to the part. One screw held it on and a plug. Removed those, put on new part and she was good to go. No trip to home depot today. Read more...

Your Price

$48.95

General Electric Microwave Turntable Motor

★★★★★

8 Reviews

PartSelect Number PS2370063

Manufacturer Part Number WB26X10233

Fixes these symptoms

Noisy
Tray won’t turn
See more...

Installation Instructions

Mark from LADYS ISLAND, SC

Turn table on microwave would not turn.

Removed 6 screws from the front and back of the bottom of the unit. 3 screws each side. The panel will swing down. Remove the wires from the motor. Remove the one screw from the old
motor. Insert the new motor and reverse the procedure.
DIY will save you a $ 95.00 GE repairman labor bill, plus the cost of the motor. I repaired the problem for less than $25.00! Read more...

Your Price

$66.28

General Electric Microwave Turntable Motor

★★★★★

1 Review

PartSelect Number PS12722592

Manufacturer Part Number WB26X32190

This turntable motor is for microwaves. The turntable motor rotates the glass tray inside the microwave oven. Because high-voltage capacitors in a microwave can retain a lethal electrical charge even when the microwave is unplugged, a service technician should install this part.

Fixes these symptoms

Tray won’t turn
See more...

Your Price

$96.97

General Electric Microwave Motor

PartSelect Number PS1020855

Manufacturer Part Number WB26X10193

Enhance the functionality of your microwave with this genuine GE turntable motor. This essential component rotates the glass tray within your microwave oven to ensure an even heat distribution. Specifically designed for GE microwaves, this high-quality part provides durability and powerful performance. Due to the potentially lethal electrical charge retained by high-voltage capacitors in microwaves, installation should only be attempted by a service technician. Trust this GE turntable motor to keep your microwave operating at its best.

Fixes these symptoms

Tray won’t turn
See more...

Installation Instructions

Javin from Waltham, MA

Turntable did not turn when anything on top

Turn off the circuit breaker to the microwave. Remove the 4 black wood screws that secure the microwave to the cabinet. Pull the microwave all the way out and set it on something that leaves you access to the middle access panel on the bottom. Remove the access panel on the bottom that has one screw. Unhook the 2 cables to the motor remembering which color goes where. Remove the 2 screws for the motor and replace the motor. Finish up in reverse... Read more...

Your Price

$42.95

General Electric Microwave Motor Ac Synchronous

★★★★★

6 Reviews

PartSelect Number PS2355837

Manufacturer Part Number WB26X10226

Installation Instructions

Susana from PHOENIX, AZ

Turn table motor malfunctioning, noisy and intermittent.

My oven is installed above the counter making it a bit difficult to reach the screws closest to the wall. Instructions should note that both harnesses need to be disconnected and that there are two screws, not one holding the motor. This one issue made it frustrating since that screw is located towards the back away from your vision. This is when the flash light and a bit of contortions were required. Read more...

Your Price

$31.95

General Electric Microwave Synchronous Motor

★★★★★

11 Reviews

PartSelect Number PS953598

Manufacturer Part Number WB26X10143

This motor rotates the glass turntable in the microwave.

Fixes these symptoms

Noisy
Tray won’t turn
See more...

Installation Instructions

Klaus from Holland, PA

the carousel in the turntable would not work

I had previously determined the like culpit was the synchronous motor. The roller guide had flat spots on each roller. Order parts from Part Select - pretty good price, parts were delivered in 3 days - much faster than I expected. Printed out a parts diagram from their website and grabbed my screwdriver. Also needed a pair of side cutters to cut the metal web that held the motor cover in place - only need to unscrew screw that hold the cover in place (bottom), cut the metal connectors, remove the plate and unscrew the screw holding the motor in place, pull out old unit, replace with new motor and secure the motor with the screw. Put the cover in place and secure - put the microwave back on the counter, pluf it in, put something in the oven and start her up. Took less than 15 minutes and cost me $50 for the parts. Great deal and easy to do. Read more...

Your Price

$72.22

General Electric Microwave Turntable Motor

★★★★★

1 Review

PartSelect Number PS1481109

Manufacturer Part Number WB26X10208

This motor rotates the glass turntable in the microwave.

Fixes these symptoms

Noisy
Tray won’t turn
See more...

Installation Instructions

jeannine from solana beach, CA

Microwave making really loud noises when operating

This is the second time I've had this problem-once while it was still under warranty and now this time. Quite annoying noise but super easy to fix (just remember to unplug the appliance first!). I used the flashlight to help find the screws as my microwave is installed over the range.
My vent motor has also gone out...maybe I'll tackle that next! Read more...

Your Price

$33.95

General Electric Microwave Turntable Drive Motor

★★★★★

2 Reviews

PartSelect Number PS237758

Manufacturer Part Number WB26X10024

Fixes these symptoms

Tray won’t turn
See more...

Installation Instructions

Stan from LOS ALAMOS, NM

Turntable drive moter making ratcheting sound

Removed power from unit. Removed 7 screws from cover on bottom of microwave. Unplugged the power connector from the installed motor. Removed 2 screws holding motor. Positioned new motor using small nibs used for purpose of proper positioning. Used mounting screws removed from old motor to firmly fix new motor in place. Installed original mounting screws holding bottom cover in place. Connected power and tested operation. Read more...