General Electric Microwave Circuit Boards and Touch Pads

Popular General Electric Microwave Circuit Boards and Touch Pads

Your Price
$240.34
  In Stock
General Electric Microwave Display Control Board
★★★★★
★★★★★
1 Review
PartSelect Number PS1022528
Manufacturer Part Number WB27X10858
Fixes these symptoms
Your Price
$347.32
  In Stock
General Electric Microwave Digitron
★★★★★
★★★★★
1 Review
PartSelect Number PS1018741
Manufacturer Part Number WB27X10856
Installation Instructions
William from EAGLE, ID
Flashing display
Replace Advantium 120 flashing display.

Step one: Disconnect the power to the Advantium 120. Unplug unit, trip the breaker, whatever. Your responsibility to make sure the electrical power is removed.

For cabinet mounted units remove four screws from front side flange holding the microwave to cabinet

On the cabinet mounted model access three screws along the top front edge of case behind the display then one screw on each side of display and two hidden screws accessed through the top of the case via access holes. (use a magnetic see driver for these screws)

Work the display panel off and support it until the connectors are removed.

There are three small color coded plugs on the left side to the PC board and five larger colored plugs on the right side. Note plug locations.

Lay the removed control panel upside down on a towel at the corner of the sink so the selector knob is not resting on the counter.

Remove PC plug to the display and remove four screws on the PC board. Shift the PC board to release the tabs. Then remove two screws holding the PC display board. Note two guide pins also align the PC board.

Remove the rubber insulator from the old board and put it at the same location on the new board. There is usually enough stickiness on this insulator to put it back on the new board.

Installation is reverse. Reconnect power. Try it out after completion by boiling water in a microwave safe container. My new display was much brighter than the replaced display. No flashing.
Read more...
Your Price
$197.33
  In Stock
General Electric Microwave Electronic Control Board
★★★★★
★★★★★
1 Review
PartSelect Number PS12295369
Manufacturer Part Number WB27X29822
Fixes these symptoms
Your Price
$158.26
  In Stock
General Electric Microwave POWER BOARD
★★★★★
★★★★★
1 Review
PartSelect Number PS1020967
Manufacturer Part Number WB27X10861
Your Price
$242.12
  In Stock
General Electric Microwave Control Panel - Black/Stainless
★★★★★
★★★★★
1 Review
PartSelect Number PS2322068
Manufacturer Part Number WB56X10826
Installation Instructions
Zach from Nampa, ID
buttons on front panel of microwave would not work
Unplug the microwave unit from power source. I removed the air vent from the microwave that is located at the top of the microwave. Next I unscrewed the control panel that was held by one screw towards the top of the microwave. The panel then needs pushed upward to release from main microwave chasis. Gently remove control panel. Unplug the 3 main communication lines and the 1power line from the PCB. Pull up on ribbon cable slot in order to release pressure from the ribbon cable. Pull from the sides of the ribbon cable slot. Then the cable can be removed. You will then remove the 4 screws holding the PCB to the control panel and release the 2 hinges holding the board in place. Put PCB back together on new control assymbly. Plug in new ribbon cable, communication cables, and power cable back into the PCB. Put rest of microwave back together and test out. All went well with mine thank goodness. I am a technician at trade so it was easy for me to know how and what to do. Read more...
Your Price
$102.40
  On Order
General Electric Microwave CONTROL PANEL Assembly ES
★★★★★
★★★★★
2 Reviews
PartSelect Number PS8755561
Manufacturer Part Number WB56X20477
Installation Instructions
Jerry from Piedmont, AL
Control panel would not work
Removed the plastic vent from over the door, removed the 2 screws
from the top of the control panel. Lift the panel upwards. Remove the screw from the ground wire. Unplug all the wiring and remove panel.
Remove the screws holding the circuit board. Unplug the ribbon. Install circuit board onto new panel and plug in ribbon.Reinstall panel back into the microwave. A 20 minute job and you are done.
Read more...
Your Price
$226.63
  In Stock
General Electric Microwave Control Panel with Touchpad - Stainless/Black
★★★★★
★★★★★
1 Review
PartSelect Number PS1993844
Manufacturer Part Number WB07X11128
Fixes these symptoms
Installation Instructions
George from NAPLES, FL
Power surge caused unusual display readout
Microwave self-diagnosed problem as touchpad defect. Unplug oven, remove 2 screws on top cabinet and slide exhaust grill to side to release. Remove one screw retaining touchpad and slide up to release. Snap a picture of connections, one pair could be swapped. Unplug connectors from circuit board. Remove 4 screws holding board to touchpad. To release ribbon cable, pull up on connector slightly and pull out cable. Install board on new touchpad. Slide ribbon cable from new touchpad into connector and press down on retainer. Tug on cable to check connection. Reinstall in reverse. Read more...
Your Price
$310.17
  On Order
General Electric Microwave Electronic Control Board
PartSelect Number PS11762558
Manufacturer Part Number WB27X27171
Genuine OEM control board
Your Price
$556.56
  Special Order
General Electric Microwave Main Control Board
PartSelect Number PS1018841
Manufacturer Part Number WB27X10901
This part is located in the control panel of the microwave.
Your Price
$100.52
  Special Order
General Electric Microwave Main Control Board
PartSelect Number PS1019676
Manufacturer Part Number WB27X10842

Related General Electric Microwave Parts