General Electric Cooktop Ignitions

Your Price

$166.20

General Electric Cooktop Spark Module

PartSelect Number PS1480954

Manufacturer Part Number WB13T10076

This part sends enough current to the igniter to create a spark to the bottom of the burner cap.

Your Price

$74.64

General Electric Cooktop Spark Module Kit

★★★★★

2 Reviews

PartSelect Number PS12742738

Manufacturer Part Number WB13X32509

Elevate your cooking experience with the GE Spark Module Kit. This must-have component is designed to efficiently control the sparks for lighting your cooktop surface burners, ensuring a consistent and safe ignition every time you cook. Prior to installing, always remember to unplug your cooktop and shut off the gas supply for your safety. As an aditional precaution, we recommend wearing work gloves during installation to protect your hands. Trust in the quality of GE to deliver reliable and unrivaled performance for your cooktop's igniter system with the GE Spark Module Kit.

Fixes these symptoms

Will Not Start
See more...

Installation Instructions

William from Littleton, CO

No spark to ignite the gas.

First I shut off the gas valve below the range and unplugged the unit from the electrical outlet. I left the flexible gas line fitting undisturbed/attached to the range top gas fitting. Then I removed the two screws below the unit (under the counter) that affix the range to the counter/support structure. Then I removed all of the knobs and burner grills and gas diffusers sitting on the top of the range. Then I lifted out the burner bowls and disconnected each from their respective spark wires. Then I gently pried the range from its hole in the counter being carefulm not to break the glass top and lifted it out turned it at an angle to the counter top hole and set it back down on the counter. Then I gently pried off the glass top from the metal range base, cleaned it thoroughly and set it aside. Then, I placed the new spark module next to the old one and one by one I transferred each wire to its respective location on the new module. The instructions pointed out that the new spark module has a revised grounding scheme and that a ground wire is no longer needed, so I removed and discarded the green ground wire. I then affixed the new spark module into the location where the old spark module had been. Next I replaced the wiring harness which contains the switches for each burner location. It is important to replace the wiring harness along with the spark module as they must work together reliably to complete the gas ignition circuit. The old wiring harness simply lifts/unsnaps out and the new one snaps into its place. Once both the spark module and wiring harness were in place, reassembly of the range was simply the reverse of disassembly. Read more...

Your Price

$159.31

General Electric Cooktop Spark Module

PartSelect Number PS1480956

Manufacturer Part Number WB13T10078

Your Price

$168.73

General Electric Cooktop 4-prong Spark Ignitor Module

PartSelect Number PS235656

Manufacturer Part Number WB21X10029

Your Price

$96.97

General Electric Cooktop Spark Module - 120v 60hz

★★★★★

2 Reviews

PartSelect Number PS231335

Manufacturer Part Number WB13K5079

This part sends enough current to the igniter to create a spark to the bottom of the burner cap.

Fixes these symptoms

Will Not Start
See more...

Installation Instructions

3 sisters hacienda from ESCONDIDO, CA

No ignition

replace parts and plug in wire harness as you go.....clean up old seal area on burner bowl and stove top...install new seals.....done.....saved $400 in repair labor or $1200 for new stove top..... Read more...