JES735WJ - Instructions

Everything worked on the display light inside worked but when you closed the door and set time it would start counting down but not heating nor would the turntable turn. Started reading troubleshooting chart and first thing I did was removed the cover and checked door switches and found primary door switch wasn't working so I ordered a new one installed it and it worked. Anyone doing this has to be very careful because of the stored energy in the capacitor is strong enough to kill.
My micro is only 2 years old so I was hoping it wasn't anything major.

next day delivery,placed tray in appliance

I REMOVED THE TOP PANEL OF THE MICR0WAVE AND THEN REMOVED ONE SCREW TO REMOVE THE CONTROL PANEL. rEMOVED OLD SWITCH. SNAPPED IN NEW SWITCH AND CONNECTED WIRE. REPLACED CONTROL PANEL AND UPPER PANEL.

Insert roller guide and cooking tray. That was all.

Removed outer cover

removed lower door switch

installed new switch

Wa La!

Removed the MW from the wall. Took the top screws off the air vent. Then removed the two screws holding on the display. I then moved the display to its side and it revealed the micro switches. I removed the plug in leads from the micro switch one at a time. I did this with all three micro switches only one at a time. I reinstalled everything and plugged it in. No more fans starting when the door is opened.

Great

When I got home that night, I went to your website, ordered the glass turntable, which was the exact replacement part I needed. The shipping was so fast that in two days I had an almost new microwave which cost me a grand total of 31.00. Not too bad! (I priced the same model in other stores and they averaged anywhere from 69.00 to 129.00. Thirty one dollars was way better, don't you agree? I would suggest your site for anyone needing replacement parts. Thanks for your help!

remov cover to check voltage and found problem at the interlock switch ohm the switch and found it was open replace both switches it work fine now

Part just snapped into place and wires were reattached.

tested cap. with ohm meter which showed a short. A new HV cap., a fuse and it is working fine again.

REMOVE OLD PARTS REPLACE WITH NEW

unplugged power
removed main black cover.
located part WB24X10047 and replaced

order replacement part roller guide, Synchronous Motor # GM-16-2F302 unplug appliance,remove glass plate & roller guide. flip over to see screws at bottom & Sides, if you don't have special bit to remove 4 tamper proof screws located on the 4 corners, use Dremel to cut slot on screw head so you can remove screws with flat tip screw driver. Be mindful of the magnetron screwed to bottom plate, Be mindful the bottom plate is sharp, Danger to avoid high voltage capacitor, once screws are removed ease the bottom tray out< Note location of tabs on tray, and alignment slots, you are removing bottom tray to get to turntable motor held on by one screw & tab, note location of black & white wire, swap out motor,carefully re align bottom plate tabs & slots & screw holes re install screws, flip over install roller guide & glass plate, The new roller guide has a pin sticking up from the center, the weight of the glass plate keeps the roller guide engaged on the motor, test, every thing works fine cost of parts under $30 removal & replacement under 1/2 hour,

Multimeter checked/confirmed switches, sensors, and fuse first. All good. High power diode was bad - Replaced. Still no heat but now loud "MMMMM" noise when running. This means either the capacitor is also bad and/or magnetron.