GDP695SBM5TS General Electric Dishwasher - Overview
Sections of the GDP695SBM5TS
[Viewing 7 of 7]
Keep searches simple, eg. "belt" or "pump".
Dishwasher Lower Rack Roller
PartSelect #: PS16217024
Manufacturer #: WD12X26146
The lower rack roller supports the smooth sliding of your dishwasher’s bottom rack. Measuring 1.5 inches in diameter and charcoal-colored, this OEM replacement part is sold individually. Replace all f...
$12.95
In Stock
Door Latch
PartSelect #: PS6447681
Manufacturer #: WD21X10490
This is replacement door latch for your dishwasher. The door latch is attached to the tub frame, and connects to the door strike to keep your dishwasher door closed during operation. If you have a bro...
$45.95
In Stock
HEATING ELEMENT
PartSelect #: PS16729156
Manufacturer #: WD05X30818
The element heating assembly is found at the bottom of the dishwasher tub, and helps to warm the water in the wash cycle, and dry the dishes afterward. If the water does not heat up during the wash cy...
$55.40
On Order
RACK CARRIER AND ROLLER KIT
PartSelect #: PS17873321
Manufacturer #: WD01X35298
- Includes: 4 brackets, 4 roller wheel brackets, and 8 wheels part # WD12X26146
Dishwasher Lower Dishrack Carrier and Roller Kit (Set of 4). This kit will replace all four one piece roller carriers w...
$34.95
In Stock
Water Valve & Harness Assembly
PartSelect #: PS12743161
Manufacturer #: WD15X26140
This is a washer inlet valve assembly for your dishwasher. This valve allows water to flow into your dishwasher at the proper rate. If your dishwasher tub is not filling with water or filling when the...
$42.95
In Stock
Dishwasher Bracket Countertop
PartSelect #: PS11700868
Manufacturer #: WD01X21740
This mounting bracket is manufactured to secure your dishwasher to your countertop. Mounting brackets should be installed so the dishwasher doesn’t tip forward. You can fit the bracket to either the c...
$34.95
In Stock
Dishwasher Screw 816 Hxw 1/2 (Stainless Steel)
PartSelect #: PS258461
Manufacturer #: WD02X10067
This OEM-compatible screw is designed for use with many GE dishwashers. Measuring 8-16 HXW and 1/2" in length, this stainless steel screw secures the middle spray arm hub to the upper rack assembly, e...
$13.95
In Stock
Configured User Interface Control Board
PartSelect #: PS17137058
Manufacturer #: WD21X31902C
This is the user interface control board for various dishwashers. The user interface panel is what you directly interact with on your dishwasher to start and stop it and select the specific cycle you ...
$218.15
In Stock
DETERGENT MODULE
PartSelect #: PS17137025
Manufacturer #: WD12X32798
The detergent dispenser in your dishwasher stores the detergent until it is ready to be dispensed. If your dishes are not coming clean, or you notice the detergent is still in the dispenser at the end...
$42.95
In Stock
Drain Pump Kit
PartSelect #: PS12582714
Manufacturer #: WD19X24829
This is a drain pump kit for dishwashers. The drain pump for is responsible for pulling out and removing all contaminated food water from your dishwasher during and at the end of its washing cycle. If...
$56.95
In Stock
Wash Arm Kit
PartSelect #: PS6011684
Manufacturer #: WD35X10393
This kit includes the lower and middle spray arms. Water is forced through this spray arm by the unit's pump and motor assembly. The force of the water propels the spray arms, spraying water and deter...
No Longer Available
Questions And Answers for GDP695SBM5TS
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Common Symptoms of the GDP695SBM5TS
[Viewing 10 of 10]Leaking
Fixed by
these parts
these parts
Show All
Will Not Start
Fixed by
these parts
these parts
Show All
Not drying dishes properly
Fixed by
these parts
these parts
Show All
Not cleaning dishes properly
Fixed by
these parts
these parts
Show All
Door latch failure
Fixed by
these parts
these parts
Show All
Not draining
Fixed by
these parts
these parts
Show All
Will not fill with water
Fixed by
these parts
these parts
Show All
Will not dispense detergent
Fixed by
these parts
these parts
Show All
Door won’t close
Fixed by
these parts
these parts
Show All
Noisy
Fixed by
these parts
these parts
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Diswasher not drying dishes
Didn't actually do the compete repair but got close. Pulled out dishwasher, disconnected and checked continuity on the existing heating element (about 16 ohms) the new element was also about 16 ohms. This indicates they both were working fine and no need for replacement. Next step would have been to swap the elements would have been
... Read more
simple. Tried to replace main board as well, still not the issue so giving up and replacing the dishwasher. It wasn't the high temp cut off thermostat either incidentally and no error codes in maintenance mode. Check continuity of your existing element before ordering to save aggravation.
Read less
Parts Used:
-
David from SHAWNEE, KS
-
Difficulty Level:Easy
-
Total Repair Time:30 - 60 mins
43 of 68 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Dishwasher was randomly beeping when not in use. Then eventually the display wouldn’t light up.
I first tested for 120volts to my dishwasher to verify it was getting power from my electrical panel. Then tested pins 2 and 5 on the control board to make sure there was 14 volts going to the user interface harness. After I verified that I knew it was the user interface that was bad. I watched a video I found on YouTube and followed it.
... Read more
This repair was fairly easy while watching the video and making sure that you use the correct pin out that comes in the box for your model. I’m not an appliance repair person and it took me about an hour start to finish. I’m going to attach the video I https://youtu.be/TI8cUjy5YOE
https://www.youtube.com/watch?v=GN5t4VFgLCY
https://www.youtube.com/watch?v=GN5t4VFgLCY
Read less
Parts Used:
-
Brian from MANSFIELD, MA
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:30 - 60 mins
-
Tools:Nutdriver
27 of 27 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
The dishes were not dry after the wash cycle
Open the washer, remove the bottom dish rack, then twist off the bottom water sprayer. Use a screwdriver to remove the mounting/ stabilizing screws so you can slide out the dishwasher. Close the dishwasher and slide it out. Underneath at the back there are two wires powering the drying element, carefully remove them. Use an adjustable wre
... Read more
nch to remove the two plastic mounting nuts for the drying element. Open the washer and remove the old drying element, and insert the new element. Reassemble the dishwasher in the reverse order if disassembly.
Read less
Parts Used:
-
Daniel from JACKSONVILLE, AL
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers, Wrench (Adjustable)
32 of 48 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!