DP400PWD1 Kelvinator Dishwasher - Instructions

I removed all of the clips, that held the rubber seal inside the basket. I then replaced the new rubber seal with new clips. Very easy. The instructions were very helpful.

I snapped on the new roller and bingo! problem solved.

Two rollers on the lower rack were missing and one was flattened. I popped off the bad roller and snapped the three new rollers in place, all by hand. Took about 60 seconds.

Never worked on a dishwasher before but quickly learned that on this particular one, it's only this thin little brass nut that tightens down the element from the underside of the washer. If not tight enough, water drips right down onto the electrical connections. In this case water began to drip and the heat from the electrical current began melting a clear rubber shield thing. Luckily I was home during the cycle and figured out the problem. Great website that seems to have all necessary parts for my washer. Quick shipment!

Snapped the new one in. One second repair - like new.

So easy it shouldn't even count as a repair, really. The dishwasher, there when I bought the place, had a lower rack that wouldn't roll out as it should. That's because there were no wheels on the left side.

The rack lifts out easily. These wheels snap on to small protrusions from the wire rack.

Snapped new wheels into place on the axel. New wheels were exactly like the old ones

This could not have gone easier! As long as you get the proper parts it's a piece of cake. I wish everything was this easy!

Installed New rollers onto bottom rack. Part order & delivery were top notch from Partselect. Will definitely order from them again.

Both heating element brass nuts had a split in them. They had fallen off the heating element and were hanging on the electrical wires. I removed the wires from the heating element and removed the brass nuts from the wires. I then screwed the new nuts on the heating element and reattached the wires. problem solved. I want to thank you for having the parts I needed as Sears had discontinued them for this Kenmore appliance.

Fisrt, I opened dishwasher door. I then pulled out the lower rack & put new part in place and pushed in lower rack. Last, I closed dishwasher door.

merely snapped the part on

Rollers just snapped on the diswasher rack. Took just seconds to do.

Laid over portable dishwasher and looked for evidence of a leak.Nothing obvious. Looked up Illustrated parts breakdown to see what could be the possible source and settled on the main seal on the water pump between the washing machine itself and the motor. Also replaced grommets on the heating element.She hasn't used it yet but am confident problem is solved.

husband replaced wheels.