4KSB5MY4 KitchenAid Blender - Instructions

place screwdriver under old coupler and pried up on it in different spots until it popped off. Took less than 5 min. to do.

Part is left hand thread. Use screwdriver to lock motor fins and twist off part.

Used a wrench 19/64 flat

Pried the old coupling off and unscrewed the metal piece remaining then screwed the new coupling on.

I followed the instructions on the sheet that came with the replacement part. The instructions are accurate, however, the working is misleading. I think additional information is needed to make the install easier. First, a flat head screwdriver works best. Also, all the rubber that is on the broken coupling needs to be removed before trying to get the coupling off. Once all the rubber has been removed then it becomes easier to see the metal rod that holds the coupling and distance between the coupling and the base of the blender, take the screwdriver and gently pry the coupling off in an upward movement while going around in a circular manner. Then you can see the coupling rising up from the rod. Then take a hold of the broken coupling and pull it off. Then attach the new coupling, screwing it on counterclockwise. Once you realize what is going on, it's actually quite easy.

I looked on the Web for help in changing this part they suggested prying the part off with a screwdriver. This would work but I figured this approach was a little to brutal.I had a set of distributor wrenches and these had one that fit the shaft under the drive coupling Using the wrench to hold the shaft I used a small set of water pump pliers to remove the coupling.As the directions on the Web states this is a reverse thread.The whole project took all of five minutes to complete

Followed the video you sent removing the old drive coupling. Installed the new part according to instructions. I found I did not need to order the seal. I am a do it yourselfer and have never had such a good experience.

I utilized the "pound the coupling in a clockwise direction" to loosen the coupling. Two good "wackes" and it was loose. Installed new coupling. I found this method in the previous customer installation instructions on the site. Please note that my new part number is ps401661. This part works normally even though my model number did not list a part number, perhaps because my blender is an older model. Without the installation instructions site I would not have known that the thread was a "reverse thread". This site is very helpful. Good luck

popped off the old one, popped on the new one. could not have been any easier. :)

Hammer was used to remove the old one, tapping quickly on old coupling. I did use a thin pliers (wire stripper) to hold shaft when I screwed on new coupling, even though it said one did not need to. Good instruction sheet came with the new coupling.

used needle nose pliers to hold shaft after prying rubber top off. unscrewed metal tap, counterclock wise. installed new piece

The part comes with instructions on how to replace the coupling. The instruction basically says to pry out the worn coupling. This is exactly what you should do. It might sound strange or brute force but it actually works. The coupling is actually made of some soft metal that comes out easily. The only downside is that you have to clean up the leftover metal bits. You don't need to find a slim wrench for the motor spindle as suggested by other in the thread ..... just follow the instruction pry out the old coupling.

Just as the provided instruction says, pry-off old coupling than screw on the new. This repair was too easy! This blender was out of commission a long time, it is good to have it back in use.

Inserted the screwdriver under the original gear and pried it off. After that you just screw the new gear on, it has reverse threads so no tighting is required.

I used a screwdriver,pulled out the piece,then change with a new one,that I was ordered before.It was ver easy to assembly.