25344723104 Kenmore Refrigerator - Instructions

After removing the broken glass, the new shelf slid into place easily. I only had to make sure it rested in the front slot that prevents it from sliding. The ordered shelf arrived within 4 business days and was perfect in all ways.

When i found out there was no thread in brace where bolts were supposed to screw in, I panicked. I thought I would have to send part back or go to a machine shop to make a thread. I called a friend for help and he told me the bolts would make the thread if I just screwed them in. Sure enough, the bolts made the thread and then I just proceeded to instal motor and put refrigerator back together. It was simple.

Unplugged freezer from electrical socket. Removed lower trays from freezer. Removed sound proof stripping from sides of back panel. Removed upper, lower and side screws from back, lower panel using No. 2 phillips screwdriver. Disconnected motor wires from quick disconnect power supply. Removed motor bracket from freezer back using nut driver. Removed motor from bracket using same nut driver. Replaced motor and screws in bracket. reattached quick disconnect. Attached fan blade to motor making certain to push blade on shaft securely. Replaced bracket to freezer back. Replaced back cover. Replaced stripping. Plugged into power supply. Total time 15-20 minutes.

Simply snapped into place. For anyone that reads my response I wanted to add that PartSelect operates in my opinion an easy to understand and searchable website, in additon I recieved my item within two days of order placement. They give ecommerce a good name.

Placed glass into front edge of frame first then gently lower the back side down into position

I removed the shelf and placed in the crisper frame.

Took out of the box hooked it on in about 5 seconds too easy

I can't believe how fast it shipped!!! Thanks! Great job!

ordered new shelf and snapped in on the side. Problem fixed. Easy

I first noticed my ice cream getting soft. Then 2 days later the alarm went. I emptied the freezer, opened the panels and saw no frost. I saw that 99% of issues were resolved with a defrost timer and thermostat so I ordered those. I have to say the parts came quickly and they went in very easy. My freezer seems to be in the 1% category though. It's still not cooling even though I can measure the temperature at the front of the evaporator coil is cold but by the end of the coil it's almost room temperature. I think a repairman is called for.

New shelf was here in a couple of days, I was shocked it was so quick. Popped it right in! 5 minutes. This is a great website!!!

I am replacing rhe electrical parts that were wet. The motor and freon piping are sealed and uneffected by the flood.

I unscrewed the screws that held the old fan on, disconnected the wiring harness and removed the old fan. I pulled the blades off the motor and put it on the new fan. One thing of note, the screw holes on the new fan weren't threaded. I assume this is by design, so I used the screws to thread the holes before installing it in the freezer. Once I did this, the rest of the installation was easy, just screw it back in and connect the wiring harness.

It was simply a matter of snapping in the replacement shelf.

I read the model number on the inside of refrigerator label, ordered the part online from PartSelect. Part arrived in 24 hours. My daughter placed bracket onto fitting and repair was complete in less than 10 seconds.