20113 (1988) Kenmore Range - Instructions
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Burner stopped heating up.
Searched the internet for the replacement part, placed the order and then disconnected the old one and inserted the new burner prongs into the socket. Worked perfectly!!!
Parts Used:
-
Robin from Chicago, IL
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Light bulb failure
Received the part the day after ordering. Appreciated the quick service and repair took less than a minute.
Parts Used:
-
Grant from Alexandria, VA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Burner stopped working. Replaced burner & block.
We read comments by other DIYers and then looked at the video on YouTube. Our range is old and the screw holding the clamp for the block was too tight to remove so we removed the block from the old clamp and left clamp intact. Turned the circuit breaker off. Cut the existing wires and wired the new block to them. Put the block back into the old clamp, put new surface burner in and good as new. My boyfriend and I did it together but I could have done it myself - it was that simple. Thanks PartSelect for quick delivery and excellent DIY info.
Parts Used:
-
Margaret from New Hope, PA
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Surface burner not controllable by selector switch
After replacement of burner element to no joy, ordered and replaced the infinite switch control. Turned off and tagged range circuit breaker. Lifted top range surface and propped up. Removed screws of control panel back cover and removed cover exposing the front panel control switches and wiring. Tested for any voltage on exposed connectors with multimeter. Noted that replacement switch and old switch had different connector physical layout. Drew a layout of both switch connectors on paper noting that while connector tabs were in different locations the labels of each connection was clearly labeled and matched. Pulled off the knob from old switch and removed the two screws holding it on front control panel. Pulled old switch out at the back of the panel. Then using needle nose pliers pulled one connector at a time from old switch and moved to new switch matching labeled connectors. Reinstalled new switch, back cover, lowered range surface top, turned breaker back on, and new burner control works great.
Parts Used:
-
Edward from Henrico, VA
-
Difficulty Level:Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Pliers, Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Finding a drip pan that fit so that pots could sit level.
Ordered the drip pan from ParSelect.com. Unplugged element and took out old pan. Placed new pan in and replaced element. For the first time in many years, the part fit.
Parts Used:
-
Ann B from Hueytown, AL
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!