1413 - Instructions
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Stopped and would not restart / start.
1)Shut off power supply to dryer. 2)Removed lint filter. 3)Removed two screws that secure filter duct to dryer top. 4)Lifted front of top to gain access to door switch. 5)Removed two switch mounting screws. 6)Removed the two power leads. 7)Reconnected power leads to new switch using "Normally Closed" terminal on switch. 8)Reversed the previous procedures to complete repair.
Parts Used:
-
Patricia from Duck, WV
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers
Was this instruction helpful to you?
Thank you for voting!
broken
-
Tomas from Orlando, FL, FL
-
Difficulty Level:Really Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Drier would not start
The install is very easy. First unplug the direr and then remove four (4) screws from the top of the control panel. The front of the control panel can be moved up and out so it can be laid over so you can get to the switch. Remove the two wires connected to the switch and the two mounting screws. Replace the switch by reinstalling the two screws and the two wires. Remount the control panel and plug the drier in. Job done.
Parts Used:
-
Bert M. from TOMS RIVER, NJ
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Nutdriver, Screw drivers
Was this instruction helpful to you?
Thank you for voting!