KitchenAid Refrigerator Doors

Popular KitchenAid Refrigerator Doors

Your Price
$58.29
  In Stock
KitchenAid Refrigerator Complete Dairy Compartment Door - Clear
★★★★★
★★★★★
9 Reviews
PartSelect Number PS11739923
Manufacturer Part Number WP2256101
This is a replacement dairy compartment door for your refrigerator. The dairy compartment door opens and closes to allow access to the dairy items stored in the refrigerator door. Because it is made of clear plastic, the door can occasionally become cracked and broken. When the door is cracked, it will need to be replaced. The door measures approximately 15 inches in length and 6 inches in width. To replace the door, carefully remove the old door and insert the new door, lipped edge down. This product is sold individually and is OEM part from the manufacturer.
Installation Instructions
Patricia from Inglewood, CA
Both parts were broken and required replacement.
The broken part was removed and new part installed without any trouble. Read more...
Your Price
$11.09
  In Stock
KitchenAid Refrigerator Pivot Block
★★★★★
★★★★★
14 Reviews
PartSelect Number PS11743531
Manufacturer Part Number WP67003405
This is a replacement pivot block for your refrigerator. It is made of white plastic and is approximately 4 inches long and 1 inch wide. The pivot block catches and holds the door mullion cover when you close the door. If your refrigerator door will not close properly, you may need to replace the pivot block. This part is sold individually and is an OEM part sourced directly from the manufacturer.
Fixes these symptoms
Installation Instructions
Elijah from Killeen, TX
I had several broken appilances broken with parts to be replaced.
I had ordered the parts from Part Select and came with in a week. I ahd a Whrilpool microwave that had a door panel and vent grille that needed to be replaced and that was rplced with ease took less that five minutes to do. My Maytag refridgerator had it kickplate grille replace along with the pivot block that took all of about two minutes. The longest job that took about 5 minutes was my Whirlpool glass oven door that needed to be replaced, but that was pretty ease to replace also with an extra hand from my son. I just didn't want to break another glass door or I would have done it myself plus I was teaching him how to do self reparts. Read more...
Your Price
$166.63
  In Stock
KitchenAid Refrigerator Vertical Mullion Rail - Black
★★★★★
★★★★★
18 Reviews
PartSelect Number PS11738596
Manufacturer Part Number WP12722803B
Commonly referred to as the flapper assembly, the door mullion is an important part of a double, or triple door refrigerator.
Fixes these symptoms
Installation Instructions
Don from Alpine, TX
Broken Rail-Mullin
The mullin requires only one screw removal, then LIFT the entire mullin upwards. Pop the wire harness loose, and replace with new mullin. Simple job, Read more...
Your Price
$11.09
  In Stock
KitchenAid Refrigerator Door Closure Cam Kit
★★★★★
★★★★★
17 Reviews
PartSelect Number PS2168612
Manufacturer Part Number R0181181
This door closing cam kit is intended for use on the bottom of your refrigerator and freezer door hinges. The cam helps close the doors and to lifts them slightly when opened. If your door will not open or close, or will not stay closed, there could be an issue with the door close cam. Other common symptoms associated with the door close cam are: the door is sweating, the fridge is too warm, or a clicking sound can be heard coming from the door. If your refrigerator has an ice and water dispenser, you will need to disconnect the power and water to the unit before you begin the repair.
Fixes these symptoms
  • Clicking sound
  • Door Sweating
  • Door won’t open or close
  • See more...
Installation Instructions
Russ from Asheville, NC
Door would not close
After emptying the refrig. door, I unscrewed the plate on the top of the refrigerator that covered the door bolts. Then off with the three bolts. I removed the door by lifting it up a few inches. The two parts of the door cam were easily removed and replaced with the new part. BEFORE REPLACING the door spread vasoline on both cam parts.
(Not after as I did. The second time you do any of these repairs go SO much better :o)
After putting the door back on, adjust the tension of the screws holding the door in place if needed to align the door on the cams so that it shuts completely. Failure to do this will require taking the top off the door again. (see comment above on "... second time...")
If all is properly aligned, the door should swing completely shut.
Even with the mistakes that required removing the door to lubricate the cams, and removing it AGAIN to readjust the screws on the top to properly align the door on the cams, this was a twenty minute job. My wife and I were still speaking to one another at the end of it- a sure sign of an easy repair.
Read more...
Your Price
$42.45
  In Stock
KitchenAid Refrigerator Compartment Door
★★★★★
★★★★★
9 Reviews
PartSelect Number PS11739749
Manufacturer Part Number WP2218113
This part is the replacement compartment door for your refrigerator. It is made of clear plastic and is approximately 9 inches by 6 inches. The compartment door snaps into the walls of the dairy compartment on the refrigerator door itself and operates on a hinge so that it can open and close. The main reason to replace the compartment door is if yours is cracked, broken, or missing. To replace the compartment door, carefully remove the hinges, then attach the new door into the hinges. This part is sold individually and is an OEM part.
Installation Instructions
john from NORWOOD, MA
replaced cracked compartment door
removed old and installed new compartment door by hand. Read more...
Your Price
$180.92
  In Stock
KitchenAid Refrigerator Verticle Mullion Rail - Apollo Gray
PartSelect Number PS11738595
Manufacturer Part Number WP12722803AP
Fixes these symptoms
Installation Instructions
Michael from FALLBROOK, CA
When right hand door was opened first, and then left hand door, the mullion rail did not move all the way to the "open" position so that if the left hand door was closed after the right hand door the rail would bang against the right hand door and not close all the way until manually pushed into pos
Remove the existing mullion rail:

- Remove the screw from the center hinged cover.
- Remove the mullion rail by pushing upward. The top and bottom hinges slide over tabs attached to the door. I had to bump it gently from underneath.
- Disconnect the three wire connector that's underneath the center hinged cover.

Install the new mullion rail by reversing the above steps:
- Connect the three wire connector and snap it into its holder.
- Slide the new part over the top and bottom hinges. Be sure that all three hinges are correctly lined up before sliding the rail over the tabs.
- Push it down far enough that the hole for the screw in the center cover is lined up with its corresponding receptacle in the door.
- Replace the screw.
Read more...
Your Price
$166.51
  In Stock
KitchenAid Refrigerator Flipper Assembly
★★★★★
★★★★★
6 Reviews
PartSelect Number PS11749098
Manufacturer Part Number WPW10151713
This flipper assembly is for refrigerators. The flipper assembly creates an airtight seal between the doors on a French-door refrigerator. Safely store any food that could deteriorate while the power is off and unplug the refrigerator before installing this part. Wear work gloves to protect your hands.
Fixes these symptoms
Installation Instructions
George from Washingtonville, NY
Broken top mount mullion, broken pin and deli tray lid
Parts arrived quick and installed easy. One reveiwer said his wife did theinstall and that was my inspiration. Thank you. Read more...
Your Price
$58.81
  In Stock
KitchenAid Refrigerator Ice Door Motor & Bracket Assembly
★★★★★
★★★★★
2 Reviews
PartSelect Number PS11756149
Manufacturer Part Number WPW10546285
Installation Instructions
Robert from SAN DIEGO, CA
Ice Dispenser worked poorly causing frequent frost buildups and poor dispenser operation
This built-in model requires complete removal of stainless steel door "Cover". A trim piece that covers the screws on the left side of the door requires lowering the refrigerator on to the rolling legs and moving it forward for access. The tipover strap on top of the refrigerator must be removed first. One the door is slowly lowered and then pulled out you need to remove the trim piece then remove the screws on the bottom, top, and lft side. Then remove the four screws from the internal side of the dispenser. With assistance slowly pull the entire front cover from the door which gives access to the internal electronic pad. Be very careful with the door cover as the edges are razor sharp stainless steel. Remove the electronic pad (4 socket screws) and move it to provide access to the motor bracket assembly. Remove assembly (2 screws) and replace with new. This includes removing the connector plug which came off easily. The replacement assembly was a new design from the original which appeared to be much better design. This was very simple to replace. Now the hardest part is "popping" the front door cover back on the front which is a two person job. I taped the trim attachment strips to the inside of the cover (left and bottom sides had the strip) so the screw holes would line up when the cover is replaced. All four sides must slide on at the same time with a slight advantage to the side with the handle. Note: this can be dangerous because of the sharp edges and very precise fit...a blood donation was required because of an errant hand and the quick snap in popping the door in place. Once its back on, reverse the process of replacing the screws and carefully moving back in to position and raising back up to previous height. I had very little information on how to do this so I did it slowly and deliberately so it took me about two hours. The dispenser now works better then ever and I have had no frost build up....I wish I had done it 4 years ago. Read more...
Your Price
$76.61
  In Stock
KitchenAid Refrigerator Door Retainer bar - White
★★★★★
★★★★★
2 Reviews
PartSelect Number PS11754562
Manufacturer Part Number WPW10421484
This door trim is used in refrigerators and is connected to the door handle. If the mounting tap is broken or there is discolouration from usage, it is best to replace this part to ensure it works well and looks good. The tools needed for this repair is a small screwdriver. To repair, first pull out the old door trim by placing the screwdriver in the gap between the trip and door handle and pushing upwards. Once you remove the old trim, you can replace it with the new door trim by aligning the slots on the trim with screws on the door. Slide the door trim down to install it. Remember to unplug appliance from the power source as a safety precaution before installation. For further installation instructions, refer to the manual guide provided by the manufacturer.
Installation Instructions
Gary from COLUMBUS, OH
The door shelf brace was missing.
I snapped the two end caps into the shelf rail and pushed it into place on the bottom of the inside door.Tolls were not needed as it was a perfect fit. Read more...
Your Price
$58.30
  In Stock
KitchenAid Refrigerator DOOR-COMP
★★★★★
★★★★★
4 Reviews
PartSelect Number PS11752673
Manufacturer Part Number WPW10316885
This part is the replacement compartment door for your refrigerator. It is made of clear plastic and is approximately 14 inches wide and 4 inches long. The compartment door connects to the refrigerator shelf and it can be raised and lowered to access the shelf. The main reason you would want to replace the compartment door, is if your old door is cracked or missing. This part is sold individually and is an OEM part sourced directly from the manufacturer.

Related KitchenAid Refrigerator Parts