Hotpoint Microwave Switches

Your Price

$37.95

Hotpoint Microwave Secondary Door Switch

★★★★★

49 Reviews

PartSelect Number PS237421

Manufacturer Part Number WB24X829

The secondary door switch is a simple on/off mechanism that stops the microwave from operating when the door is open (normally opened). The switch monitors the door latch position, and communicates whether the door is open or closed to the electrical control board. This door switch is approximately 1 inch long, and has 2 metal prongs called terminals that extend out of its body. Common symptoms related to a faulty secondary door switch include: microwave will not turn/shut off, or the microwave will not heat properly. NOTE: Before you begin this repair, first make sure your microwave is unplugged, and that your capacitor is discharged. A capacitor stores large amounts of electricity even when your microwave is unplugged.

Fixes these symptoms

Doesn’t shut off
No heat
Touchpad does not respond
See more...

Installation Instructions

Marla from Arlington, TX

light worked, timer and control pad worked, but no turntable, no heat, no noises of any sort, just didn't start up

Noted on partselect.com that someone else with this problem, found it to be secondary door switch. There are three door switches in this model, but online info noted that one of the three might feel "soft" (in my case, one switch clicked in a rather "jiggly" way, the other two were strong decisive clicks.) To access the door switches on this model was the only difficult part. First use a torx bit to remove the two torx screws below the latches inside the microwave. This frees the latching part inside, that holds the door switches, which you will remove after you take off the control panel. The top grill has to come off before you can remove the door panel. Remove the screws above the grill, on the microwave top cover, The grill on this model is covered with a panel that moves out when it vents. After removing the two top screws, the covered grill vent slides left to remove. Be careful, as the sliding tabs are plastic. Wiggle and jiggle it, to slip it off. Below the removed grill, is a small metal grill with one screw in lower center. Remove that screw, and wiggle that out. You'll then see the one screw that holds on the control panel. Remove this screw, and lift the control panel up to remove. Again, go slowly and gently, as the bottom tabs holding the control panel in, are also plastic and easily broken. Lay the control panel on something, (I used the coffee maker) and pull out the wire bundles tucked on the left, that are attached to the latching panel. Wiggle the latching panel gently to lift it up off of it's plastic tabs and pull it out towards you, so you can see the three door switches. Each switch (part number WB24X829) has a little black switch on it. Feel each switch with either your finger, or a screwdriver to see which one doesn't "click" strongly. The weak one is the one you will replace. The door switches are fitted into a tab, and plugged into their wires. Remove the defective switch, pull out the wires, and replace it with the new switch, plugging back the wires, and slipping it back into it's plastic tabs. Then put everything back together in reverse order. The entire job took me fifteen minutes EXCEPT for figuring out how to slide off the upper grill, which I have told you. A repairman would have cost $150, the part was $18. AND, there's a good chance, the other two switches will get "used up" in the next year or so as well, so I'll be ready next time. Thank you, Partselect, why work all day, to make money, only to give it to somebody else, for fifteen minutes of work. All I needed was the knowledge. Read more...

Your Price

$45.95

Hotpoint Microwave Monitor Door Switch

★★★★★

15 Reviews

PartSelect Number PS237422

Manufacturer Part Number WB24X830

Unplug your microwave before attempting this repair. You will need to remove the grill, which is held into place by two screws at the top of the grill (open your microwave door before doing this). Remove the grill. Remove the screw on the left holding the control panel in place. Loosen the screw behind the panel. You should now be able to lift the panel up and pull forward to detach. You will find the door switch by removing the screws to detach the switch assembly. Press on the release tab to remove the middle switch. Disconnect the wire connector to release the old switch. The door switch is normally closed.

Fixes these symptoms

Doesn’t shut off
No heat
Won’t turn on
See more...

Installation Instructions

George from Sugar Land, TX

GE Microwave turns on when door is opened

I saw a similar problem description at partselect.com and was confident to take the challenge to repair it myself. (Thanks to partselect.com). When I opened the microwave cover I found 3 similar switches. 2 of them works the same way and the other in reverse direction. Image diagram provided to buy parts is helpful to identify the switch.
Steps:
Remove the built-in microwave from the wall and keep it in an open space.
Remove the microwave screws and take the cover out.
Remove the 2 screws(inside) from the plastic panel where switches are snapped in
Gently remove the faulty switch and replace with the new one.
(In my case the topmost secondary door switch was broken) Read more...

Your Price

$60.34

Hotpoint Microwave Micro Switch Monitor

★★★★★

5 Reviews

PartSelect Number PS8754455

Manufacturer Part Number WB24X10205

This Microwave Switch by GE is the ideal component for users striving to maintain the safety and efficiency of their microwave unit. As a door monitor switch, it ensures that your microwave remains switched off while the door is open, acting as a critical preventive apparatus. The switch is normally closed but will automatically open when it's put into action. Get the peace of mind knowing that accidental operations are averted with this essential microwave component. Due to high-voltage capacitors in a microwave which can hold dangerous electrical charge, have this part installed by a certified service technician. Trust the robust reliability of GE for a quality Microwave Switch that enhances your appliance's safety signals.

Fixes these symptoms

Won’t turn on
See more...

Installation Instructions

Earl from STOW, OH

door switch monitor broke ,tripped breaker

when on line to see how to replace the micro switch, very helpful.be careful removing door latching housing & vent cover.unplug control panel & set aside so it's out of the way. Read more...