Weed Eater Trimmer Hardware

Your Price

$5.95

Weed Eater Trimmer Lawn Mower Flangelock Hex Nut

PartSelect Number PS9022497

Manufacturer Part Number 532409149

Made of high-quality metal, this hex flange locknut is designed for use with various lawn mowers and ride-on mower/tractor models and is sold individually. This locknut attaches to the end of the carriage bolt and is an important component to the axle assembly. This locknut has a 3/8-inch inner-diameter and is 16 threads-per-inch. To replace this locknut, you will need a wrench, and if there are multiple locknuts on your equipment, they may all need to be replaced.

Your Price

$6.21

Weed Eater Trimmer Chainsaw Clutch Washer

PartSelect Number PS9469029

Manufacturer Part Number 530015611

Your Price

$14.58

Weed Eater Trimmer Bolt

PartSelect Number PS9013762

Manufacturer Part Number 532180334

Your Price

$4.99

Weed Eater Trimmer Lawn Mower Hardened Washer

PartSelect Number PS9019116

Manufacturer Part Number 532851074

This washer is not part of a kit or assembly. It is sold individually. With an O.D. of 1 inch, this OEM replacement part is made of dark grey metal and is used to provide a tight seal between the mower blade and the blade bolt/screw. This part should be replaced if you notice any visible wear, warping, or damage. You will need a wrench or socket set to complete this repair. Customers rate this repair as Easy.

Installation Instructions

Sharon from MCMINNVILLE, TN

I did not have a special wench

I mowed until gas was empty. No bottom plug had to turn mower on side and drained oil. I had buy special lubricants to remove blade bolt. That was a challenge. I called a friend to help place new blade on. Put in new filter, oil, and gas. Mower works great! Read more...