Washer Dryer Combo Transmissions and Clutches

Popular Washer Dryer Combo Transmissions and Clutches

Your Price
$54.33
  In Stock
Washer Dryer Combo Washer Drive Pulley
★★★★★
★★★★★
21 Reviews
PartSelect Number PS10057144
Manufacturer Part Number W10721967
This is a replacement clutch assembly or cam kit for your washer. The clutch assembly is mounted on the drive shaft on the bottom of your washer. You may need to replace the clutch assembly if the splines on the clutch assembly are stripped and the washer is making noise, or if you are having problems with the wash and spin cycles. You will need to access the bottom of the washer for this repair. It is easiest to if you disconnect your washer from both the water and power source, and lay it on its back. The clutch assembly contains 6 parts, and all are included with the kit. It is also important to change out the entire assembly, rather than individual pieces.
Fixes these symptoms
  • Burning smell
  • Noisy and Marks Left on Clothes
  • Spinning Issues
  • See more...
Installation Instructions
Jerry from WALLA WALLA, WA
Noise on bottom of Washer louder as time went on. 1 1/2 years
Well, first investigated and found loose nut on drive clutch. First take off the two screws with nut drive then cover off using a screwdriver blade to snap off the cover. Then socket ratchet to take off the nut on drive clutch. take off belt by slowly rotating the drive gear. two screws that hold the electronics to the upper drive clutch and put aside, so you can snap off the cover for drive clutch on upper part with screwdriver and off the parts come and install whole unit back as took it apart. Line up the new upper clutch so that is position as was before. (Using parts diagram helps a lot as www. partsselect.com has for you or Maytag.com.) Then put the electronic part board back on and the gear and nut. Make sure it is tight by several attempts to make sure it's snugged up good and then slowly roll belt back on the pulley and motor drive. Put your cover guard back on with two screws and done. Read more...
Your Price
$27.55
  In Stock
Washer Dryer Combo Clutch Assembly
★★★★★
★★★★★
79 Reviews
PartSelect Number PS334641
Manufacturer Part Number 285785
A clutch assembly (Clutch, Washer Clutch) is found in your washing machine and is responsible for spinning the basket during the spin cycle. The clutch lining can wear over time. If the clutch lining is worn out, the clutch assembly will not rotate properly to release the brake. If you notice a burning smell, or the machine shaking and moving more than normal, this could indicate there is an issue with your clutch. If the washer spins when the washer basket is empty but not when it’s full, or if the assembly begins to turn blue, you may need to replace the clutch assembly. This assembly includes a brake cam driver, blue springs for large capacity washers, a black spring for compact washers, and the installation instructions. It’s constructed of plastic and metal, and comes in beige/silver.
Fixes these symptoms
  • Burning smell
  • Spinning Issues
  • Spins slowly
  • See more...
Installation Instructions
Andrew from SLC, UT
spin cycle did not engage
researched potential causes, found cluch dust under the washer and determined that it wouldn't engage because clutch was too worn. ordered the assembly, removed agitator from inside the tub as it is connected to the gear shaft, turned washer on it's back for access to motor, unattached the direct drive water pump from the motor drive, unbolted the 3 gearcase mounting bolts and took the entire gearcase, shaft, motor, etc... together, out from under the washtub. the clutch slides off the gearshaft with a little fidgeting and the new assembly is easily installed where the previous was. put everything back together... then... spin spin! worked perfectly Read more...
24% OFF
Your Price
$50.42
$66.20
  In Stock
Washer Dryer Combo Shift Actuator - 6 Pin
★★★★★
★★★★★
11 Reviews
PartSelect Number PS11769864
Manufacturer Part Number W10913953
This 6-pin shift actuator is an authentic OEM part supplied directly by the manufacturer for use in washing machines. The shift actuator is responsible for controlling the movement of the washer transmission during the different phases of the wash cycle. This allows the washer to switch between agitating and spinning modes. Signs of a faulty shift actuator include the washer failing to agitate or spin, incomplete cycles where the washer gets stuck in one phase, or unusual noises during operation
Fixes these symptoms
  • Cycle Not Advancing
  • Spinning Issues
  • Spins slowly
  • See more...
Installation Instructions
Beverly from MADISON, IN
Wouldn't spin properly
Replaced the gears that were eaten up, the retainer and the actuated. All parts but the spring are plastic. Did all according to your instructions. Happy to report all went well. Washer is working again. Read more...
13% OFF
Your Price
$245.18
$281.96
  In Stock
Washer Dryer Combo Gearcase
★★★★★
★★★★★
7 Reviews
PartSelect Number PS341974
Manufacturer Part Number 3360629
This is used in your direct drive washer that has a neutral drain.
Fixes these symptoms
Installation Instructions
Troy from Storm Lake, IA
Tub wouldn't turn, but motor would allow it to drain.
I took the two screws for the control panel out and tilted it up and back. Then remove the two metal clips which held the outer panel to the back panel. After disconnecting the power and water I tipped the washer on its back. I had to remove two clips to take the water pump off of the motor, then removed the two screws and clips which held in the motor. After removing the motor, I found the coupler was bad. To remove the gearcase, I took out the softener dispenser and removed one bolt to take out the agitator. Under the agitator was a clip. Three bolts held the gearcase to the frame. After removing them, the gearcase pulled straight out the bottom. Replacement was just a reverse process, with the addition of a light coat of grease to the gearcase shaft. Read more...
Your Price
$121.84
  In Stock
Washer Dryer Combo Basket Drive Assembly with Clutch
★★★★★
★★★★★
1 Review
PartSelect Number PS11723156
Manufacturer Part Number W10820043
This basket drive assembly is for washers. Basket drive assembly sits on top of the transmission shaft and houses the spin basket brake mechanism. The basket drive spins to rotate the basket during the spin cycle.
Fixes these symptoms
Your Price
$53.02
  In Stock
Washer Dryer Combo Clutch Lining Kit
★★★★★
★★★★★
3 Reviews
PartSelect Number PS334642
Manufacturer Part Number 285790
This kit comes with springs, hardware, and brake lining.
Fixes these symptoms
Installation Instructions
Adam from Lehi, UT
Agitator had a terrible ratcheting sound when running in free-wheel mode during spin cycle.
Removed the gearbox from the drum and removed the direct drive motor from the gearbox. Disassembled gearbox and drained gear oil. Rebuilt the neutral drive assembly with the ordered parts. Cleaned sealing surfaces. Filled gearbox with new gear oil. Sealed and re-installed the top cover to the gearbox. Reattached motor and then reinstalled assembly to drum and clutch (installed new clutch lining at this time as well). Read more...
Your Price
$54.32
  In Stock
Washer Dryer Combo Coupling Assembly
PartSelect Number PS3522903
Manufacturer Part Number 4323EA2001C
Your Price
$35.82
  In Stock
Washer Dryer Combo Trunnion Plate
PartSelect Number PS2352980
Manufacturer Part Number 137107000
Locking Plate.
Your Price
$263.82
  In Stock
Washer Dryer Combo Transmission Assembly
PartSelect Number PS8746231
Manufacturer Part Number WH16X10186
Your Price
$85.27
  In Stock
Washer Dryer Combo Brake Shoe Assembly
PartSelect Number PS334528
Manufacturer Part Number 285438
This assembly comes with two brake shoes.
Installation Instructions
Michael from Trafalgar, IN
Found cracked brake shoe
Remove the main bolts that hold the gearbox in place, pull the gearbox and shaft out. You will see the brake shoes and drum--the large spring is a struggle to replace. Getting it out was not hard. The biggest struggle I had was replacing the brake shoe spring after replacing the shoes. I ultimately compressed the spring in a vise, then used safety wired it, then placed it between the shoes, then cut the wire to relaease the spring. Read more...

Washer Dryer Combo Transmission or Clutch Brands