Washer Dryer Combo Drawers and Glides
- Search your model number to find:
- Genuine OEM parts guaranteed to fit
- Free manuals and guides
- Repair instructions and videos
Popular Washer Dryer Combo Drawers and Glides
Your Price
$13.62
In Stock
Washer Dryer Combo Front Glide Kit
2. Removed 4 screws from inside the dryer, to take off the blower housing.
3. Removed 4 screws and took out the large metal piece which supports the drum at the front. Removed the drum.
4. Replaced the two rollers that support the drum in the rear. Cleaned the pins they run on, and oiled very lightly. Also replaced the idler roller. I was surpirsed to see that these rollers use plain bearings, not ball bearings.
5. On the front support piece, drilled out the rivets for the glides, and replaced the worn out glides with new parts. Applied a little glue (3M weatherstrip adhesive) to the cork pieces, to glue them to the metal. Attached the plastic pieces over the cork pieces, and riveted in place using rivets that came with the glide kits.
6. Replaced front and rear felt seals. This was not as tricky as I expected it to be. They were held in by metal tabs. Glued the ends where they came together.
7. Replaced the felt blower seal. Glued to the blower housing.
8. Reinstalled the drum, installed new belt, which came with good instructions (luckily).
9. Reassembled front support piece and the front of the cabinet.
I also cleaned the lint from the cabinet and from the vent hose.
In general, the job went without a hitch, and the machine probably has quite a few years left, despite the fact that it's 18 years old. This gives me a good feeling.
I'd say this would be challenging, though, for someone who is not pretty experienced with machinery repair. Also, the cost of the parts was significant enough that it would not have been unreasonable to have opted for a new machine. Read more...
PartSelect Number PS1804752
Manufacturer Part Number 306508
The front glide is located at the front of the dryer, the drum rides along it. If you hear a metal-on-metal noise when your dryer is running, your front glide may be worn out and require replacing. This front glide kit comes with a blue plastic glide, a brown cork pad, and two metallic rivets. Two kits are required per appliance. While you have the front bulkhead removed for this repair, you may want to inspect the felt that lines it. If the felt is damaged, it is recommended that you replace it at the same time. You will need a rivet tool for this installation, as well as a stubby Phillips screwdriver, a 5/16 nut driver, and a drill with a 1/8-inch bit.
Fixes these symptoms
- Drum Not Spinning
- Marks left on clothes
- Noisy
- See more...
Installation Instructions
John from Charlottesville, VA
Belt broke on old machine.
1. Removed front of machine (2 screws at the bottom).2. Removed 4 screws from inside the dryer, to take off the blower housing.
3. Removed 4 screws and took out the large metal piece which supports the drum at the front. Removed the drum.
4. Replaced the two rollers that support the drum in the rear. Cleaned the pins they run on, and oiled very lightly. Also replaced the idler roller. I was surpirsed to see that these rollers use plain bearings, not ball bearings.
5. On the front support piece, drilled out the rivets for the glides, and replaced the worn out glides with new parts. Applied a little glue (3M weatherstrip adhesive) to the cork pieces, to glue them to the metal. Attached the plastic pieces over the cork pieces, and riveted in place using rivets that came with the glide kits.
6. Replaced front and rear felt seals. This was not as tricky as I expected it to be. They were held in by metal tabs. Glued the ends where they came together.
7. Replaced the felt blower seal. Glued to the blower housing.
8. Reinstalled the drum, installed new belt, which came with good instructions (luckily).
9. Reassembled front support piece and the front of the cabinet.
I also cleaned the lint from the cabinet and from the vent hose.
In general, the job went without a hitch, and the machine probably has quite a few years left, despite the fact that it's 18 years old. This gives me a good feeling.
I'd say this would be challenging, though, for someone who is not pretty experienced with machinery repair. Also, the cost of the parts was significant enough that it would not have been unreasonable to have opted for a new machine. Read more...
Your Price
$43.95
In Stock
Washer Dryer Combo Upper Drum Glide
What I would add to previous reviews is to pull the front off or the little acces grill in back and check to see what kind of belt you have. According to the model #, It showed the wide flat belt when in fact I had the smaller ribbed belt. Glad I checked before ordering.
A few things that will make your life easier is once you have the old upper guide/seal removed, put down the glue then use several med sized plastic spring clamps to hold the seal in place while the glue sets up, (@ 20-30 min). Their cheap and you should have some around anyway. When replacing the seals I would go ahead and replace the belt too. It's cheap and if your machine is 5+ yrs old probably is worn. Total cost of repair was about $60 (inc shipping). Took about 1 hr 20 min total time. Most of that time was scrapping the old seal material/ glue off the dryer front. Actual disassembly and repair maybe 1/2 hour. Other little tip is the clips for the lid of dryer is to use a flat screwdriver and gently push straight in until it's compressed enough to release the lid, it will pop up when pushed in far enough. That one took me a while to figure out.
Thanks to Part Select for such a helpful site. My dryer is like new again. Read more...
PartSelect Number PS470317
Manufacturer Part Number 5303937139
The upper drum glide is attached to the front panel of your dryer, you can locate it by removing the top portion of your dryer. The drum glide allows the drum to rotate with ease and little sound. The front upper felt glide pad with three nylon glides also includes adhesive, essential for mounting accurately. For this project you will need a putty knife, Phillips screwdriver, and a wire brush. This repair is meant to fix issues such as an abnormal amount of noise or the dryer not tumbling as it should. Consider replacing your belt at the same time if you have a dryer more than 5 years old, as it is likely worn.
Fixes these symptoms
- Marks left on clothes
- Noisy
- See more...
Installation Instructions
Matthew from Portland, OR
Clothes getting scorch marks, drum noise
First and foremost, I read the repair reviews here at parts source and found that a) Other people had the same symptoms, b)following their repair tips made it super easy.What I would add to previous reviews is to pull the front off or the little acces grill in back and check to see what kind of belt you have. According to the model #, It showed the wide flat belt when in fact I had the smaller ribbed belt. Glad I checked before ordering.
A few things that will make your life easier is once you have the old upper guide/seal removed, put down the glue then use several med sized plastic spring clamps to hold the seal in place while the glue sets up, (@ 20-30 min). Their cheap and you should have some around anyway. When replacing the seals I would go ahead and replace the belt too. It's cheap and if your machine is 5+ yrs old probably is worn. Total cost of repair was about $60 (inc shipping). Took about 1 hr 20 min total time. Most of that time was scrapping the old seal material/ glue off the dryer front. Actual disassembly and repair maybe 1/2 hour. Other little tip is the clips for the lid of dryer is to use a flat screwdriver and gently push straight in until it's compressed enough to release the lid, it will pop up when pushed in far enough. That one took me a while to figure out.
Thanks to Part Select for such a helpful site. My dryer is like new again. Read more...
Your Price
$64.63
In Stock
Washer Dryer Combo Drawer Assembly
PartSelect Number PS12585054
Manufacturer Part Number 5304514792
Revitalize your washing machine with this genuine OEM drawer assembly from Frigidaire. This component effectively houses the compartments for the detergent, fabric softener, and bleach, ensuring a clean and organized washing routine. It is perfect for specific Frigidaire, Electrolux, White Westinghouse, and Tappan models. Make sure to verify that this part is the correct fit for your model per your owner's manual. Remember, pieces can seem identical but may have slight variations in size or shape. Tailored installation and removal instructions are also provided in the owner's manual to ensure a hassle-free experience.
Fixes these symptoms
- Leaking
- See more...
Installation Instructions
Jeff from MCCORDSVILLE, IN
Original Drawer Assembly bottom broke apart leaking water down the front of washer.
Very simple, removed Drawer Assembly from unit. Removed detergent bowl and front cover. Installed front cover and detergent bowl on replacement Drawer Assembly. Returned installed replacement Drawer Assembly on unit.
Read more...
Your Price
$61.06
In Stock
Washer Dryer Combo Drawer
PartSelect Number PS16620105
Manufacturer Part Number W11524105
The Whirlpool Dispenser Drawer boasts compatibility with a range of Whirlpool, KitchenAid, Maytag, Jenn-Air, Amana, Inglis, and Magic Chef washing machine models. Engineered by original equipment manufacturer (OEM) to assure quality and durability, this dispenser drawer significantly aids your laundry chores. Designed as per the assembly guidelines, the drawer accommodates compartments for detergent, fabric softener, and bleach, thus ensuring a thorough wash cycle. For proper installation and removal guidance of this part, kindly refer to your owner's manual. The size and shape of this part may display minute variations, so ensure compatibility with your machine model before ordering. Turn your washing experience smoother and more efficient with this genuine Whirlpool Dispenser Drawer.
Fixes these symptoms
- Leaking
- See more...
Your Price
$53.30
In Stock
Your Price
$122.93
In Stock
Washer Dryer Combo Drawer Slider - Left Side
PartSelect Number PS3522886
Manufacturer Part Number 4276ER0002A
Step up your laundry game with our robust LG Left Drawer Slide. Tailor-made for laundry appliance pedestals, its main function is to properly support your pedestal drawer as it smoothly glides in and out. What sets this drawer slide rail apart is that it is a genuine Original Equipment Manufacturer (OEM) part, promising not only superb quality but also impressive durability. It's essential to wear work gloves while installing this part to ensure optimum safety. Marking its uniqueness is the fact that it is designed to fit specifically with LG compatible brands, ensuring a perfect fit and seamless function. Enjoy peace of mind with this authentic LG product, designed to make your life easier.
Installation Instructions
Paul from Georgetown, TX
Drawer under washer was frozen, would not move
Forced the drawer open and removed it, 4 screws. Found bearings on on one side severely corroded and locked up. Only hard part was determining which side it was. Ordered the left, my left looking at the washer. Wrong!it was the washers right looking back at me.
Read more...
Your Price
$122.93
In Stock
Washer Dryer Combo Drawer Slider
PartSelect Number PS3522885
Manufacturer Part Number 4276ER0001A
Add efficiency and convenience to your laundry chores with the LG Drawer Slider. Designed explicitly for laundry appliance pedestals, the product provides effective support to the pedestal drawer, facilitating smooth sliding in and out. Remember to wear work gloves to safeguard your hands during the installation. Trust in the craftsmanship that only an authentic LG product can deliver. Check your appliance's manual before ordering to ensure accurate compatibility. A robust build guarantees the slider's long-term reliability.
Installation Instructions
Marcelo from LUTZ, FL
Drawer had broken rail. Would not stay closed.
Removed drawer, unscrewed right side rail and replaced it with new rail. I used only a Phillips head screw driver. Warning: when ordering the rails, be aware, the rail labeled for the right side of the drawer actually goes on the left and vise versa. Luckily I ordered one of each and decided to replace both rails. The right one broke first and the left one broke as I removed it
Read more...
Your Price
$19.95
In Stock
Your Price
$69.95
Special Order
Washer Dryer Combo Panel Side Right
PartSelect Number PS12342883
Manufacturer Part Number WE02X24781
Your Price
$69.95
Special Order