Uni Range Circuit Boards and Touch Pads

Videos!

Your Price

$42.83

Uni Range Overlay

★★★★★

1 Review

PartSelect Number PS12114508

Manufacturer Part Number 316220728

White in color. Overlay only.

Fixes these symptoms

Touchpad does not respond
See more...

Installation Instructions

John from Montesano, WA

broiler element would not shut off

I had already switched off the breaker for the range, so I unplugged the unit and moved it out from the wall. I removed the screws on the rear cover and exposed the clock/timer. I then removed the four screws holding the clock/timer,used my pocket knife to gently pry the wires off of the old unit one at a time, as these were very tight. Holding the new clock/timer in my other hand I installed the wires one at a time to match the original clock timer wiring.I installed the clock/timer, the range back cover, slid the range back into place, plugged it in and turned on the breaker. My wife is happy, I am too.
A repair shop wanted $100.00 just to go to our home and look at our range. We spent $104.00 plus $20.00 for the new overlay, fifteen minutes of my time, a real bargin!
Thank you PartSelect, I'll be ordering from you again! Read more...

Your Price

$43.83

Uni Range Overlay - Black

PartSelect Number PS438714

Manufacturer Part Number 316101514

This part goes in front of the clock/timer to allow visual indication of where the buttons are on the oven. Example bake, broil & clean. Only available in white. Black version is no longer available.

Installation Instructions

Michael from Anchorage, AK

Overlay was cracked, drawer glide missing

Overlay replacement is easy; 1st remove two screws that hold panel to top of stove (philips screwdriver) and lift up off of lip at very top, 2nd remove two screws that hold control to panel (nutdriver or square drive screwdriver), 3rd peel old overlay from control panel face (make sure you get any & all little bits so new overlay sits flush), 4th peel backing from overlay and position over control panel (peel protective film from face of overlay as well), 5th reposition control panel and reinstall two screws removed in step two above, lastly reposition top panel on stove and reinstall the two screws removed in step one above.
Drawer glide just snaps into place on the lower rear corners of drawer, then you slide drawer back into place. Read more...