Trimmer Carburetors

Your Price

$9.93

PartSelect Number PS9471212

Manufacturer Part Number 530047721

This primer bulb, also known as a purge bulb, is used to push more fuel from the fuel tank into the carburetor of your small engine equipment, to help the engine start easier. Over time and through extended use and exposure to gas and oil, the bulb of the primer will eventually lose its elasticity and crack or break. This bulb is made of plastic and can be replaced by accessing the ignition system. Disconnect the fuel lines and pop out the bulb with a set of pliers, and once you pop in the new bulb, you just reconnect the fuel lines. This bulb is compatible with a variety of makes and models of small engine equipment and is sold as an individual part.

Installation Instructions

Robert from MANVILLE, NJ

Replace the fuel lines

Replaced all fuel lines. Followed instructions found on Partselect.com, which said to insert cut fuel line in tank and use forceps to reach back in the tank and pull the fuel line through. The problem was that I did not have forceps, or needle nosed pliers that could reach the end of the hose.

Instead of running the line into the tank, I found another suggestion online to run the line from inside the tank outward, allowing me to grab the line with any pliers and thread it. The way I did this was used about a foot length of 14 gauge copper wire. Put an inch or two into the hose (that has been cut on an angle), and use a little black tape to secure the hose on the wire. Now you should be able to route the stiff wire from inside the tank to the fuel hole in the tank. Fish the wire through, and it should be enough to get the tapered end through the tank. Pull the copper wire, mine came out, but there was enough of the hose exposed on the outside of the tank for me to grab with pliers and pull it through. Read more...

Your Price

$39.54

Trimmer Carburetor

★★★★★

3 Reviews

PartSelect Number PS9119300

Manufacturer Part Number 753-06190

It is an authentic manufacturer-sourced replacement part that i supplied for Craftsman trimmers. The function of a carburetor is to mix the air and the gas into a highly combustible mix before it goes into the engine, over time components may wear out eventually requiring a replacement to ensure peak performance. It is a high-quality metal body carburetor with included rubber primer bulb, please note this assembly is sold individually. When replacing a carburetor it is advised to replace the gaskets as well to ensure the proper seal, keep in mind gaskets are sold separately.

Fixes these symptoms

Engine stops after a few seconds or minutes
Will Not Start
See more...

Installation Instructions

john from SHARPSVILLE, PA

string trimmer would not start

emptied fuel from tank. pulled off the 2 fuel lines from the carburetor.opened the air cleaner door. removed the 2 torque screws that hold on the carburetor. removed the carburetor and air cleaner gasket. installed new carburetor and gasket and put back and tightened the 2 torque screws. closed air cleaner door and pushed the fuel lines onto the new carburetor.put some fuel in the tank. started the trimmer. runs great. Read more...

Your Price

$46.07

Trimmer Carburetor Kit

★★★★★

1 Review

PartSelect Number PS9030700

Manufacturer Part Number 545081848

This carburetor rebuild kit (part number 545081848) is for lawn and garden equipment engines. Carburetor rebuild kit 545081848 includes gaskets and parts for rebuilding the carburetor. Work in a well-ventilated area and drain the fuel from the tank and fuel lines before rebuilding the carburetor

Your Price

$22.40

Trimmer Chainsaw Gasket And Diaphragm Kit

★★★★★

1 Review

PartSelect Number PS9472427

Manufacturer Part Number 530069844

This is a genuine manufacturer-sourced replacement gasket repair kit that is specially made for use with Paramount and Poulan lawn and garden equipment. It is utilized to replace carburetor gaskets and diaphragms that were originally installed on a new unit. If you have a problem with your carburetor this will usually take care of it. Keep in mind this high-quality kit is sold individually. Please make sure to refer to the appropriate diagrams of your model for the exact locations and applications of these components.

Your Price

$16.48

Trimmer Carburetor Repair Kit

PartSelect Number PS9231272

Manufacturer Part Number P005002280

Videos!

Your Price

$67.54

Trimmer Carburetor

PartSelect Number PS10039121

Manufacturer Part Number A021001692

This Genuine OEM carburetor is designed for use with a variety of Echo gas-powered tools, ensuring optimal fuel and air mixture for reliable engine performance. Sold individually, this essential component is responsible for blending air and fuel before the mixture enters the engine. A properly functioning carburetor is critical for smooth starts and efficient operation. If your engine fails to start despite having fresh fuel, the carburetor may be the issue. A simple test involves removing the air filter and adding a teaspoon of fuel directly into the carburetor. If the engine starts briefly and then stalls, it’s likely time to replace the carburetor. Built to meet original equipment standards, this replacement part helps restore performance and extend the life of your equipment.

Your Price

$45.98

Trimmer Carburetor

★★★★★

1 Review

PartSelect Number PS11824881

Manufacturer Part Number 588171156

This OEM carburetor mixes the air-fuel mixture to the proper ratio for combustion in your engine. This carburetor is sold individually, is silver in color and metal in material, and is located on the intake of the engine. Issues with your carburetor will cause problems with your engine running, and could cause excessive smoke due to too much gas. This can happen due to corrosion inside the carburetor. Carburetors can be rebuilt easily, and repairing them requires an allen wrench and a screwdriver. When troubleshooting your carb, remove the air filter and pour a teaspoon of fuel into the carburetor. Pull the starter rope, and if the engine starts then quickly dies, the carburetor is likely the problem. When replacing your carburetor, also replace all gaskets when doing so, as they are a one-time use.

Videos!