Sprayer Bearings

Sprayer Snow Blower Flange Bearing This metal flange bearing is an authentic manufacturer-sourced component which is designed for use in lawn and garden outdoor equipment. It is bronze in color, with 6 six flat sides, and it has an inner diameter of 0.75 inches, and a height of 1 inch. It also features a protruding circular rim on one end, known as a flange, which keeps the bearing stable and secure. The bearing serves as a support mechanism, allowing rotating parts to move smoothly with minimal friction. Over time the bearing may wear down, crack, or fall off causing excessive noise, reduced performance, and potential damage to the snowblower impeller or auger. Use a bearing puller tool to pry the bearing off the equipment. Align the new flange bearing with the mounting holes and secure it in place.

Sprayer Trimmer Ball Bearing This single-row, deep-groove ball bearing is sized at 12x32x10mm and is made of durable metal. It is used to reduce friction and vibrations when it is in between two parts that are rotating or moving against each other. This bearing can handle forces that are applied to it up-and-down and sideways, also known as radial and axial loads. It is easy to install and can handle high rotational speeds without causing too much vibration or making much noise. Over time, this ball bearing wears out from heat and pressure and starts to fail. If the engine of your machine has been run without oil in the gas tank, this ball bearing can seize. In these situations, you will need to replace the ball bearings. Otherwise, you will notice that your machine overheats, works harder because of the increased friction it is handling, and produces excessive vibration and noise. To extract a ball bearing from your machine, you will need to insert a flat-head screwdriver through the bearing opening and against the seal. Then, tap the seal out with a mallet. Afterwards, slot a socket through the diameter of the bearing, and tap the entire bearing out of its place by again using a mallet. This authentic OEM part is sold individually, so be sure to refer to your user manual to verify how many bearings your machine needs and where they are in it.

Sprayer Trimmer Ball Bearing

Sprayer Bushing-nyliner

Sprayer Bearing

Sprayer Bearing-ball, 25mm

Sprayer Bushing-flange

Sprayer Snow Blower Bearing

Sprayer Bearing-ball 609

Sprayer Bearing