Main Control Board Assembly WR55X10942C

Every time there is a power outage, my refrigerator goes off for a couple days, but comes back on eventually. Last time I changed out the Compressor switch, the surge capacitor, and since the refrigerator was older and after reading that the fan should always operate when plugged in, I also changed the fan motor. Once again power went off last night and now the fridge is off. The interior lights work so I know there is power. I also did a resistance check on the compressor and that checked good. Without a drawing I cannot figure out what component would act in this way. I am leaning toward the motherboard. Could you please advise me on this?

The water and ice dispenser occasionally stop working. When the dispenser handle is depressed, the LED above, for the Water, Crushed or Cubed turns off and nothing is dispensed (no motor activity whatsoever, like a dead mother board). Pressing a couple of the temperate control buttons turns ALL the LEDS back on for 20 seconds or so and then the dispenser usually goes back to normal operating mode. Sometimes it takes a couple of times to get it to return functionality. Suspect it’s probably an issue with the main circuit board?

Refrigerator: Notice a ticking sound (constant click) , check temp kind of warm. Check temp settings and controls adjustment not working. I power cycle the unit the ticking went away and controls are working. Unit have done this 2 times.It seems the control board could be going bad?!? Wanted to check before purchase.

CAN THIS MAIN BOARD CAUSE THE ICE MAKER NOT TO WORK? I HAVE REPLACED THE ICE MAKER AND THE WATER SOLENOID VALVE IS WORKING PROPERLY AND WATER LINE IS NOT FROZEN, BUT STILL NO ICE.

Hii wil this fit on a Psw26sgpa refrigerator??

The main control board part # is given as: WR55X10942C but GE has made many different revs under this part #. I am having trouble finding the correct board rev. The current board rev in it is: 200D6221g010. Will your board really work in this frig?

Have water to fill glass but no water to ice maker

The freezer gets to cold, I reset the temp at 1 and the refri at 38. The temp on the refri stays at 38 but the freezer go to -9. Some times it stay at 1 but it changes to -9 frequently.

My fridge has a constant clicking sound and it cools both the freezer and the fridge but not as cold anymore. It has been two days now and it's been clicking every second. What could this be?

My fridge and freezer will operate as normal. Then the whole unit will make loud humming and clicking noises. After that the temperatures on both the fridge and freezer will become far to warm. I try to clean the components in the back of the fridge and unplug for a few minutes. Sometimes that helps reset it. Does this mother board sound like it may correct my issue?