Housing WPW10179455

Hello David, Thanks for your question. Yes, this part does come with a black rubber elbow. I hope this helps.

Hi Dale, Thank you for your question. All dishwashers will have a method to drain the water. Most models will have a single motor driven pump with two separate compartments, one for circulation and one for drain, each with its own impeller. Other types will have a separate drain pump and some will utilize the main circulating pump in conjunction with a drain solenoid and diverter valve or flapper. On models that use a separate drain pump you should check to see if there is any obstruction to the input and output of the pump and also verify that there is power getting to the pump motor during the drain portion of the cycle. If both check ok, then you should replace the pump and motor assembly. On models that use a drain flapper and solenoid, again you should check for any obstructions and verify that the solenoid is getting energized and that there is continuity. Use a multi-meter to make these tests. Check that the linkage operating the flapper or diverter is moving freely and replace any defective parts. On models that have a two section pump, the drain impeller may be at fault. First, verify that the motor is running in the proper direction. If the motor does not run, then check for power at the terminals on the motor. If voltage is not present, then you should check door switches, timer or electronic control as a possible cause. If proper voltage is present, then the motor windings could be open. If the motor is humming, then the problem could be that the drain impeller is jammed or the motor could be seized. If the motor is seized, then the motor or motor and pump assembly will need to be replaced. The electrical checks can be made with a multi-meter. Disassembly of the pump will be required to determine if the impeller is the problem. The drain compartment is typically located beneath the circulating compartment. Remove the lower rack, spray arm, pump cover and filter assembly to gain access. Inspect the drain impeller for damage or wear and replace if required. Also check that the food chopper is in good condition and not allowing large food particles to clog the drain outlet, and that both the chopper and impeller are turning freely. I hope this helps. Thank you and have a great day!

Hello Gib, thank you for your question. Yes, the housing part number WPW10179455 is compatible with your specific unit. I hope this helps!

Hello Nash, thank you for your question. Yes this housing is compatible and suitable to correct the issue. We hope this helps.