Your coupon for will be reflected when you check out!
✖
Your coupon for
✖
Hello!
You're visiting the PartSelect site in U.S.
Would you like to shop on the Canadian site?
Stay on this site
Go to Canadian site
✖
Model Number Locations
1Select Category Type
Select Category Type
2Select Product Type
Select Product Type
3Select {MODEL} Type
Select {MODEL} Type
Sample Model Number Tags
Model numbers can be made up of numbers (1005400, for example) or a combination of letters and numbers (LAT1000AAE). The model number will most likely appear on either a paper sticker or a metal plate. Your appliance's model number tag may look similar to the sample model number tags shown here (model number highlighted in yellow):
Model has been saved to My Models. If you're not signed in, your lists are available on this device and will expire within 30 days.
Model has been saved to My Models.
This valve is used in washers and it is known as the washer inlet valve. This specific valve is used to control the flow of cold water into your washing machine. If your washer is leaking, if it will ...
This is a bellow assembly, also known as a door boot gasket kit, and it is designed for use with front load washers. This gasket acts as the main seal between the door of the washing machine and the w...
This drain pump, also referred to as a drain pump motor assembly, is designed for use with front load washers. This pump is used to remove the water from your washing machine during the washing cycle....
This valve is designed for use with washers. Inlet valves on washers are what control the flow of water into your appliance, this valve is used to control the flow of hot water into your washer. If yo...
Front-loading washing machines use a suspension system to support the tub during the wash cycle. This suspension system is only designed to handle a certain amount of movement, so when you are transpo...
My husband took off the back of the washer and disconnected the hose that connected the pump to the main drum. He has strong fingers--did it that way--but really you need a pillars. After putting it all back together we got another weird code--E29 and the door wouldn't lock. But after turning everything off and waiting 30 minutes, the
... Read moregenius machine just suddenly reset itself and started working correctly. No problems since and we've done about 30 loads since then. While on the phone with Bosch, trying to learn how to clear the new code, I heard only, "We only give information to certified repairmen and home repairs are definitely not covered by the warranty." Who cares? I'm now a satisfied mom who is actually washing clothes after only two days waiting for shipping--IF I could get any repairman to my house this month I'd be surprised and not for cheaper than the price of a new washer! Thank you for your great parts:)
Turned off the water to the washer. Took the top off of the washer. Used pliers to loosen the rings holding the hoses to the valve. After the hoses were removed from the valve I popped out the old inlet valve. I put the new inlet valve in place and put the hoses and rings back on. Secured the top of washer back on the washer turned the wa
... Read moreter back on. No leak present.
The thickness of the sleeves are 3.0 mm thick on the base of the sleeve. However the sleeve on the bottom of both the upper and lower hinges of this model washer are different sizes. The base of the sleeve on the top of each hinge post is 3.0 mm but the sleeve on the bottom post of each hinge is only 1.2 mm thick. The bracket on the d
... Read moreoor that holds all 4 screws to attach the door to the washer will not fit unless you reuse the old sleeve from the lower posts or reduce the thickness of the disc on the lower post to 1.2 mm. I spent hours trying to get the door back on and finally saw why I couldn't get the screws back in because the bracket could not go in place and sit flush the the washer.
