Your coupon for will be reflected when you check out!
✖
Your coupon for
✖
Hello!
You're visiting the PartSelect site in U.S.
Would you like to shop on the Canadian site?
Stay on this site
Go to Canadian site
✖
Model Number Locations
1Select Category Type
Select Category Type
2Select Product Type
Select Product Type
3Select {MODEL} Type
Select {MODEL} Type
Sample Model Number Tags
Model numbers can be made up of numbers (1005400, for example) or a combination of letters and numbers (LAT1000AAE). The model number will most likely appear on either a paper sticker or a metal plate. Your appliance's model number tag may look similar to the sample model number tags shown here (model number highlighted in yellow):
Model has been saved to My Models. If you're not signed in, your lists are available on this device and will expire within 30 days.
Model has been saved to My Models.
Ask our experts a question about this model and we'll get back to you as soon as possible!
1 question answered by our experts.
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
William
April 18, 2023
Can I find a direct picture of the mower belt direction.my belt came off and I am trying to put it back on
For model number ST1942
Hello William, thank you for reaching out. Use the following instructions to install the mower belt:
To remove the mower deck:
Place the attachment clutch in the "DISENGAGED" position.
• Lower the attachment lift lever to its lowest position.
• Roll the belt off the engine pulley and belt keepers.
• Push the housing guide and slide it out of the bracket.
• Remove the clutch cable spring from the idler arm.
• Disconnect the front link from the mower and remove the retainer spring and washer.
• Go to either side of the mower and disconnect the mower suspension arm from the chassis pin and the rear lift link from the rear mower bracket; remove the retainer springs and washers.
• Go to the other side of the mower and disconnect the suspension arm and rear lift link.
To install the mower belt:
• Work belt around both mandrel pulleys and idler pulleys.
• Make sure the belt is in all pulley grooves and inside all belt guides.
• Install the mower deck back.
We hope this information is useful!
Was this helpful?
Thank you for voting!
< Prev
1
Next >
✖
Ask a Question
Ask our experts a question on this model and we'll respond as soon as we can.
