PPB2000LE Poulan Leaf Blower / Vacuum - Overview
Models starting with PPB2000LE
Click on the best match to narrow your results.
- PPB2000LE (Type5) Poulan Leaf Blower / Vacuum (Pro Leaf Blower)
- PPB2000LE (Type4) Poulan Leaf Blower / Vacuum (Pro Leaf Blower)
- PPB2000LE (Type3) Poulan Leaf Blower / Vacuum (Pro Leaf Blower)
- PPB2000LE (Type2) Poulan Leaf Blower / Vacuum (Pro Leaf Blower)
- PPB2000LE (Type1) Poulan Leaf Blower / Vacuum (Pro Leaf Blower)
Keep searches simple, eg. "belt" or "pump".
Trimmer Fuel Filter
PartSelect #: PS9285148
Manufacturer #: 530095646
This Genuine OEM fuel filter is designed to maintain the performance and longevity of your equipment by preventing dirt and debris from entering the carburetor. Located inside the fuel tank, this esse...
$5.95
In Stock
Chainsaw Fuel Line
PartSelect #: PS9472280
Manufacturer #: 530069247
This is the replacement fuel line 25 Inch for several OPE products that use small engines. The fuel line carries fuel from the tank to the carburetor. Over time, the fuel line can become badly clogged...
$9.93
Special Order
Chainsaw Purge Line
PartSelect #: PS9472264
Manufacturer #: 530069216
This part is the replacement tank/purge line for your outdoor power equipment. It is made of clear plastic and is sold individually. The tank/purge line returns excess fuel from the carburetor to the ...
$8.98
Special Order
Spark Plug (RCJ6Y)
PartSelect #: PS9484195
Manufacturer #: 952030249
The manufacturer-certified white and silver Spark Plug RCJ6Y ignites the air-fuel mixture inside the combustion chamber of your engine. Consult your manual or check your model number to determine if t...
No Longer Available
Trimmer Piston Ring
PartSelect #: PS9482766
Manufacturer #: 545154009
This OEM Piston Ring is used to provide a seal between the piston and cylinder wall. It attaches around the piston, inside the groove. It will require a screwdriver, allen wrench, torx wrench and sock...
$6.89
Special Order
Leaf Blower Vacuum Bag Assembly
PartSelect #: PS9971436
Manufacturer #: 530095564
This OEM Vacuum Bag holds grass and leaf clippings when the blower is switched to vacuum mode, and is attached to the exit port. It is constructed of white fabric. If broken due to wear/fatigue it wil...
$34.86
Special Order
Trimmer Piston Ring
PartSelect #: PS9482765
Manufacturer #: 545154001
This metal ring in your engine, known as the piston ring, seals the gap between the piston and cylinder wall. It makes sure that the gases produced during combustion do not escape and that the engine ...
$4.99
Special Order
Gasket Kit
PartSelect #: PS9472545
Manufacturer #: 530071458
This authentic Gasket Kit is a kit which contains everything needed for the entire unit. Replace if broken, damaged or worn. Refer to your make, model and diagrams if you are unsure if this is the correct kit for you.
No Longer Available
Common Symptoms of models starting with PPB2000LE
[Viewing 2 of 2]Will Not Start
Fixed by
these parts
these parts
Show All
Engine stops after a few seconds or minutes
Fixed by
these parts
these parts
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Both the Fuel line and the Engine fuel line, where dry rotted.
1) While still attached to the fuel tank, I first sized up the old fuel lines with the newer fuel lines.
2) With a pair of needle nose players, I then removed the old dry rotted fuel ?? lines, from the fuel tank.
3) I cleaned the fuel tank and around the carburetor area, to insure that there was no debris, that could possibly fa ... Read more ll into the path of the new fuel lines installation.
4) I then installed the smaller one of the fuel lines, so that it would be out of the way, of the larger fuel line. I Pulled the fuel line through the smaller hole in the fuel tank, with needle nose players. I pulled the smaller fuel line out through the fuel tank filler hole, attached the fuel filter to the smaller fuel line. I Made sure that the fuel filter was extended to the furthest end of the fuel tank bottom. Six inches in all. I then attached the smaller fuel line to the carburetor.
5) I Installed the larger fuel line, followed the same procedures as the smaller fuel line.
6) Both fuel lines where cut on an angle for easy installation. No lubricant was necessary.
7) I filled up the fuel tank with fresh fuel and oil, new air filter and spark plug. It started on the first pull. Amazing.
2) With a pair of needle nose players, I then removed the old dry rotted fuel ?? lines, from the fuel tank.
3) I cleaned the fuel tank and around the carburetor area, to insure that there was no debris, that could possibly fa ... Read more ll into the path of the new fuel lines installation.
4) I then installed the smaller one of the fuel lines, so that it would be out of the way, of the larger fuel line. I Pulled the fuel line through the smaller hole in the fuel tank, with needle nose players. I pulled the smaller fuel line out through the fuel tank filler hole, attached the fuel filter to the smaller fuel line. I Made sure that the fuel filter was extended to the furthest end of the fuel tank bottom. Six inches in all. I then attached the smaller fuel line to the carburetor.
5) I Installed the larger fuel line, followed the same procedures as the smaller fuel line.
6) Both fuel lines where cut on an angle for easy installation. No lubricant was necessary.
7) I filled up the fuel tank with fresh fuel and oil, new air filter and spark plug. It started on the first pull. Amazing.
Read less
Parts Used:
-
Victor from SCOTTSVILLE, KY
-
Difficulty Level:Very Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Pliers, Socket set
47 of 62 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!