P20010 - Instructions
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Wheel bushings were bad
Removed old clip removed rim from tractor, removed grease fitting on rim, took hammer and screw driver knocked out old bushing turned rim over knocked out other bushing. Press in new bushings reinstalled grease fitting slide tire back on tractor, put retaining washers on then locking clip put on dust cover grease at grease fitting. Repeat other side.
Parts Used:
-
Anthony from OLIVEHILL, TN
-
Difficulty Level:Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Pliers, Screw drivers
22 of 36 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Take the wheel off. Place the key in the slot. Put the wheel back on.
-
Gary from PILESGROVE, NJ
-
Difficulty Level:Very Easy
-
Total Repair Time:Less than 15 mins
5 of 11 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Wore out parts
NOTE: Ryobi parts are interchangeable with other model and part numbers. Item needed was no longer available. But keep looking for something that would work. Found item that look just like what I needed. It worked with no problems or issues.
Replaced trimmer spool and grass deflector assembly that was wore out and causing line to wrap around spool base. Simple change out. Remove 3 Philip screws to remove defector. Hold shaft base with needle nose pliers and turn spool base counterclockwise to remove spool base. Reverse steps to assemble back. Having the right tools helps. Spray screw head with WD-40 let sit a few minutes will help loosen dirty old the screw.
Replaced trimmer spool and grass deflector assembly that was wore out and causing line to wrap around spool base. Simple change out. Remove 3 Philip screws to remove defector. Hold shaft base with needle nose pliers and turn spool base counterclockwise to remove spool base. Reverse steps to assemble back. Having the right tools helps. Spray screw head with WD-40 let sit a few minutes will help loosen dirty old the screw.
Parts Used:
-
Maire from HARLINGEN, TX
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers
1 person
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Front wheels, too much end play
-
Frederick from BINGHAMTON, NY
-
Difficulty Level:Very Easy
-
Total Repair Time:Less than 15 mins
10 of 35 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!