Parts That Fix Maytag Washer MVWC555DW1 Will Not Start

This is lid lock designed for use within various washing machines. This lid lock, also known as a latch assembly, is used to secure the lid of your washing machine during the washing cycle. If your washing machine is experiencing issues starting or if the lid is not securing, this lid lock assembly likely needs to be replaced. This lid lock attaches underneath the top portion of your washer and its wire harness connects to the rear of the appliance. To replace this assembly, you will need a screwdriver, flathead screwdriver or putty knife, and wrench. This lid lock is an OEM part that is sold individually and does not come with any other parts or accessories.

This is a lid strike for various models of top-load washing machines. Lid strikes are designed to engage with the lid switch and communicate to the control board that the washer can start. If your washing machine is having issues starting, or if the lid strike for your washer is visibly damaged it will need to be replaced. Replacing this washing machine lid strike is simple and only requires a screwdriver. This lid strike is made almost entirely of durable white plastic and features two holes on either side for securing with screws. This lid strike is an OEM part and is not sold with any other parts or accessories, such as the necessary screws.

This is a shift actuator, and is designed for use in washing machines. This shift actuator is made to change the mode of the motor between spin and agitate, as well as communicate with the control board how fast the washer is spinning. If the shift actuator in your washer is broken or bad, it can lead to the washer not spinning or agitating correctly and may even show an error code related to that. This shift actuator is made mostly of plastic but does feature a 120V/60HZ/2.8W motor. This actuator is an OEM part and is sold individually.

This is a replacement clutch assembly or cam kit for your washer. The clutch assembly is mounted on the drive shaft on the bottom of your washer. You may need to replace the clutch assembly if the splines on the clutch assembly are stripped and the washer is making noise, or if you are having problems with the wash and spin cycles. You will need to access the bottom of the washer for this repair. It is easiest to if you disconnect your washer from both the water and power source, and lay it on its back. The clutch assembly contains 6 parts, and all are included with the kit. It is also important to change out the entire assembly, rather than individual pieces.

This start capacitor is a key component in your top-load washer, providing the initial voltage surge needed to start the motor and keep the appliance running smoothly. If your washer won’t start or fails to agitate, the capacitor may be faulty and require replacement. Designed for compatibility with select models, this genuine replacement part helps restore reliable performance. Always disconnect power before installation and consult your washer’s manual to confirm fit.

The main drive belt is designed to ride on the pulley until the basket gets up to speed.