Your coupon for will be reflected when you check out!
✖
Your coupon for
✖
Hello!
You're visiting the PartSelect site in U.S.
Would you like to shop on the Canadian site?
Stay on this site
Go to Canadian site
✖
Model Number Locations
1Select Category Type
Select Category Type
2Select Product Type
Select Product Type
3Select {MODEL} Type
Select {MODEL} Type
Sample Model Number Tags
Model numbers can be made up of numbers (1005400, for example) or a combination of letters and numbers (LAT1000AAE). The model number will most likely appear on either a paper sticker or a metal plate. Your appliance's model number tag may look similar to the sample model number tags shown here (model number highlighted in yellow):
Model has been saved to My Models. If you're not signed in, your lists are available on this device and will expire within 30 days.
Model has been saved to My Models.
This OEM gray Dishwasher Lower Dishrack Wheel Assembly is a plastic kit that allows the rack to slide in and out of the dishwasher easily. If it breaks or becomes damaged. sliding will feel difficult....
$33.57
In Stock
Order now and your part arrives in 2-3 business days!
This part is a door balance link kit, also sometimes known as door cable or door spring cable kit, that helps support the door as it opens and closes by connecting to the dishwasher door hinges. The k...
$27.95
In Stock
Order now and your part arrives in 2-3 business days!
The rack track stop on your dishwasher is designed to stop the dish rack at the appropriate place when opening and closing the rack. If your dishwasher is not cleaning your dishes properly, the rack s...
$10.44
In Stock
Order now and your part arrives in 2-3 business days!
The mounting bracket is sold individually, without screws. This part secures the upper side of the dishwasher to the underside of the counter or cabinet to prevent the dishwasher from moving, shaking,...
$14.65
In Stock
Order now and your part arrives in 2-3 business days!
This drain pump is used in dishwashers to remove water from the dishwasher tub. If the impeller in the dishwasher is damaged or the motor has been shorted out and will not drain, it is possible the bo...
$59.95
In Stock
Order now and your part arrives in 2-3 business days!
This hose clamp is used in a wide variety of household appliances. Most often it is found in washers, dishwashers, refrigerators, freezers, dehumidifiers, garbage disposals, or air conditioners. This ...
$7.95
In Stock
Order now and your part arrives in 2-3 business days!
The heating element is not designed to heat the water that enters it, but is designed to maintain the heat of the water that enters the dishwasher. It is located on the bottom of the dishwasher.
$77.91
In Stock
Order now and your part arrives in 2-3 business days!
This part is the replacement door seal for your dishwasher. It is approximately 22 inches long and 2 inches wide. This door seal is made of gray plastic and is found at the bottom the dishwasher. The ...
$10.48
In Stock
Order now and your part arrives in 2-3 business days!
This is a seal, but you may also know it as a door gasket and it is for your dishwasher. The seal forms a watertight barrier between the door and the dishwasher tub, deterring water from escaping duri...
$61.30
In Stock
Order now and your part arrives in 2-3 business days!
This dishwasher water inlet valve regulates the flow of water into the appliance during each cycle, helping ensure proper filling and efficient operation. If your dishwasher is leaking, overfilling, o...
$51.43
In Stock
Order now and your part arrives in 2-3 business days!
Questions And Answers for MDB4949SDM1
Ask our experts a question about this model and we'll get back to you as soon as possible!
4 questions answered by our experts.
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Tracy
January 31, 2023
What causes dishes to here food residue on plates?
For model number MDB4949SDM1
Hi Tracy,
Thank you for your question. If you dishwasher is leaving food particles on your dishes, there are a couple of things that you will need to check. First check and make sure that the drain hose is positioned correctly and see if both the drain hose and pump are clogged. If these items are clogged, clean them and give the interior of the dishwasher a good cleaning. Before starting the dishwasher, run the hot water in the sink for a few minutes until the water gets good and hot. If the water is not hot enough, it will not break down the soap or remove the food particles from the dishes. If you are not using the correct detergent, food particles will remain on your dishes. Check your owner's manual to see what type of soap you need. If you are overloading the dishwasher, then some dishes may not get cleaned and food particles will remain on them. If you have any questions, please let us know. We look forward to hearing from you!
2 people found this helpful.
Was this helpful?
Thank you for voting!
Mary
February 8, 2023
Where is the filter?
For model number MDB4949SDM1
Hello Mary, Thank you for the question. The filter is located at the bottom of the appliance. You will need to remove the Lower Spray Arm and Cover to access the Filter. Let us know if you have further questions!
Looking for plastic shroud in which the door latch and electrical board attach to it is located to the top of dishwasher door and when you open the door there are 4 screws that hold this in place can you purchase just that piece ?
For model number MDB4949SDM1
Hi Greg,
Thank you for your question. Based on your description, it sounds like you are referring to the control panel. The part number for the black control panel is PS12074759. The part number for the white control panel is PS11727972. The part number for the stainless steel control panel is PS11756319. We hope this helps!
Bonjour,
Je cherche un bac inférieur pour mon lave vaisselle maytag du modèle nommé ci-dessus.
Avez -vous cette pièce de maytag ou existe t-il une pièce d'un autre fabricant qui pourrait s'adapter à mon modèle ?
merci
For model number MDB4949SDM1
Bonjour Séverine, Merci pour la question. Le panier inférieur pour ce modèle porte le numéro PartSelect PS16543613. Nous espérons que cela vous aidera !
Was this helpful?
Thank you for voting!
< Prev
1
Next >
✖
Ask a Question
Ask our experts a question on this model and we'll respond as soon as we can.
Pulled dishwasher from under counter, attached link to spring, hooked spring back into frame/chassis, threaded link through pulleys, attached other end of link onto door, reinstalled dishwasher under counter. All's well. Note-I purchased an extra link anticipating that the other one will fail. They're cheap enough.
Caviat: The actual repair is less than 15 minutes, but I spent a lot of time playing with it before I figured out it was that easy and fast. You don't need to remove the dishwasher from the counter to do this. And it will probably help to look at the new part closely so you can understand where the retainer clip is to press it and release
... Read more the old pump.
First remove the water from the dishwasher pan that would not drain with a wet/dry vac. Otherwise the water will all drain on the floor when you remove the pump. Then remove the two screws on the kickplate on the front of the unit below the door. Remove the kickplate/maintainence access cover. The drain pump is on the right about 8 inches in. Using two hands you grasp the drain pump with your right hand and use the left hand to push the retaining clip down. Then the drain pump will rotate 1/4 turn counterclockwise and can be removed without pulling the dishwasher out. There is likely to be some water leak out that was traped in the pump housing that you can not reach with the vac. Disconnect the wire. Connect the wire to the new pump, put it in place and 1/4 turn clockwise to install it. Replace the kickplate and you're done.
1. Open the dishwasher and remove the two plastic grommets about halfway down on either side of the opening. Then remove the two screws under the grommets.
2. Remove the kick plate under the door. May have to lower unit by turning the feet using the adjustable wrench.
3. Make sure you have enough slack in the water i
... Read morenput line and electrical wiring that you can pull the dishwasher out about 12 inches or more.
4. There is a spring and nylon rope link on both sides of the unit. Probably just one link is broken, but the replacement comes with two, so you can replace both or save one as a spare. Look at the good side and it should be pretty self explanatory how it attaches. I found it easiest to first thread the link around the lower pulley, then attach the link to the spring, then spring to the rear support, then the link to the door.
