Your coupon for will be reflected when you check out!
✖
Your coupon for
✖
Hello!
You're visiting the PartSelect site in U.S.
Would you like to shop on the Canadian site?
Stay on this site
Go to Canadian site
✖
Model Number Locations
1Select Category Type
Select Category Type
2Select Product Type
Select Product Type
3Select {MODEL} Type
Select {MODEL} Type
Sample Model Number Tags
Model numbers can be made up of numbers (1005400, for example) or a combination of letters and numbers (LAT1000AAE). The model number will most likely appear on either a paper sticker or a metal plate. Your appliance's model number tag may look similar to the sample model number tags shown here (model number highlighted in yellow):
Model has been saved to My Models. If you're not signed in, your lists are available on this device and will expire within 30 days.
Model has been saved to My Models.
First I removed the front door. Then I removed the front of the washer. The wax motor is in the center at the top. Remove the clip that holds it in place. Slide the motor to the left and remove. However, this was not the problem. The true problem was a plugged inlet screen where the cold water hose is connected. This makes for
... Read morea long fill time during the rinse cycle, and the machine stops. Clean both of the inlet screens (cold & hot) and the machine works perfectly!
I removed the cover above the washer and below the dryer (stackable washer and dryer). Removed the spring behind the wax motor and unhooked the wires. Then I pulled out the old wax motor and put the new one in.
opened door remove door with two screws at hinge. Remove two screw opposite door hinge. Pull front cover sides near the area of the top screws you just removed. Cover will pop loose and tilt forward remove from bottom clips. Remove two screws at the top in the front of machine that is behind the front cover that was just removed. Remov
... Read moree four screw in soap fill door. Lift top of machine this will expose the wax motor near door latch. Remove metal clip holding wax motor in place. move motor to left and push left side of wax motor this pop the right side out of clip. You can remove two wires from wax motor. Install wax motor. Reverse order to put machine back to together.
