LRG3091ST (00) LG Range - Instructions
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Oven wouldn't ignite
Took off the oven door then took out the racks and two screws in the oven bottom and removed it . Then removed the heat deflector. Then un plugged the old igniter and removed the burner to make it easier to remove the old igniter. Then installed the new igniter and reversed the process
Parts Used:
-
Martin from KEWASKUM, WI
-
Difficulty Level:Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Nutdriver
8 of 16 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Oven would not light
As soon as my husband put it in the oven, the very thin prongs broke. There was no guard on either side of the prongs for protection like the one that had been in there. Very costly to us of $185 with no fix. Very disappointed in that ignitor. It would have been an easy fix. Had replaced one previously but it only lasted 6 months. Now we have a new stove
Parts Used:
-
Sheila from HOPKINTON, MA
-
Difficulty Level:Very Easy
-
Total Repair Time:30 - 60 mins
7 of 18 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
melted foil on the base pan in the oven
i removed the oven door by lifting the safety latches on each hinge and gently lifted the door off. once off i could access the 2 large phillips head screws and loosened and removed them. then i simply slid out the old and slid in the new & reversed the process.
Parts Used:
-
rorke, from tarzana, CA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers
1 person
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Oven base coating melted in the center of the base
Removed two screws at the rear of the oven with a phillips screw driver. Removed door to get the base out. Installed new base and door.
Parts Used:
-
Paul from Sierra Vista, AZ
-
Difficulty Level:Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers
0 of 1 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Broken front leveler
This is a very simple repair of remove and replace. You do have to lay down the range to make it easy.
Parts Used:
-
K R from BOISE, ID
-
Difficulty Level:Very Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Pliers, Screw drivers
6 of 33 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!