KVWC908JSS0PARTS Whirlpool Range Hood - Overview
Sections of the KVWC908JSS0PARTS
[Viewing 1 of 1]
Keep searches simple, eg. "belt" or "pump".
Hood Control Panel
PartSelect #: PS12728687
Manufacturer #: W11387938
The Control panel houses the selection buttons for the range hood.
$95.60
In Stock
Switch
PartSelect #: PS11731241
Manufacturer #: W10853393
Introducing the SWTCH-RCKR Fan control switch by Whirlpool. This genuine OEM part elevates your range hoods by activating the fan motor, ensuring a more comfortable, smoke-free cooking environment in ...
$85.36
In Stock
SELF BALLASTED LED GU10 3000K SILVER
PartSelect #: PS12728694
Manufacturer #: W11388881
$69.26
In Stock
Questions And Answers for KVWC908JSS0PARTS
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
one switch went out on the range hood controlling the lights.
The repair did not happen. Parts select sent me the wrong part. They sent a cover plate without any switches.
I;m still waiting for the correct part.!!!!!!!!!!!!!!!!!!!!!!
I;m still waiting for the correct part.!!!!!!!!!!!!!!!!!!!!!!
Parts Used:
-
Jeffrey from MILTON, FL
-
Difficulty Level:Very Difficult
-
Total Repair Time:More than 2 hours
-
Tools:Screw drivers
2 of 2 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
SWITCH CONTROL UNIT HAD BROKEN OFF FROM ONE END OF ITS INTERIOR MOUNTING
Removed and cleaned to overhead grease trap filters which required a sink full of detergent some wire wool pads and and much elbow grease. This is probably a service task that should be performed at least annually for hoods in frequent use. And be careful not to cut your fingers on some of the sharp interior edges.
With the g ... Read more rease filters removed it was then possible to access the switch unit from the inside of the hood. Used a small Phillips screwdriver to loosen and remove the two fastening screws and removed and replaces the whole unit.
Refitting was the reverse of the above process.
With the g ... Read more rease filters removed it was then possible to access the switch unit from the inside of the hood. Used a small Phillips screwdriver to loosen and remove the two fastening screws and removed and replaces the whole unit.
Refitting was the reverse of the above process.
Read less
Parts Used:
-
NICHOLAS & LEIGH from CHARLOTTE, NC
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:1- 2 hours
-
Tools:Screw drivers
2 of 3 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Control panel broken
Amazing. PartSelect shipped me the wrong part and then wouldn't refund shipping cost to return it. They need to change their shipping policy as it now states they refund shipping if they were the cause of the mistake.
Parts Used:
-
Brian from LEANDER, TX
-
Difficulty Level:Very Difficult
-
Total Repair Time:More than 2 hours
1 person
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!