All Installation Instructions for General Electric Refrigerator GMR06

Plastic handle had cracked

Only tool needed was a screwdriver --unscrew the old one, (cleaned the door!), then screwed the new handle back on. Five screws. I did also break part of the old handle out from under the GE logo on the old handle so I could install the logo on the new handle. It was easy to do but annoying that it didn't come with either the logo already installed in the new handle, or included in the order. The new handle had the impression in place and would have looked like it was missing something!

Parts Used:

Handle

Liz from Alexandria, VA
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

14 of 15 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Refrigerator would not come on

I removed the one screw holding cover in place contained the thermostat . Next , I removed the thermostat from the plastic housing. NO screws, it just clippped in. I replaced the old with the new and reinstalled the cover. 2 minutes max. Sears said the part was obsolete but Partselect had what I needed.

Parts Used:

Temperature Control Thermostat

SHawn from El Campo, TX
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

12 of 14 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

The fridge handle was torn off in this rental unit

Recommended to go on line and to match serial number with part replacement. Probably should have ordered the screws but the maintenance person had extras so the handle went on without a problem.

Parts Used: