All Installation Instructions for Frigidaire Cooktop GLGC30

The burner would not light by itself, and the flame was lopsided.

The repair was nothing, but the diagnosis was a bit tricky. After carefully looking at the burner head, (cast aluminum) I pretty much figured out that the 4 small cast aluminum bumps that keep the burner cap positioned up in the air the correct amount to allow gas to flow under the cap, were worn down, preventing the gas from exiting properly by the igniter. My guess was correct. The new burner head solved all my problems. I love Parts Select for the ease of finding the correct parts and how fast they ship their orders. Great company, great service. Keep up the good work

Parts Used:

Sealed Burner Head - 14k

Roland from Auburn, ME
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

26 of 29 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

gas ignitor continued to run after turned on or off

Removed all of the grates, control knobs and gas diffusers. Unscrew the drip pans, two on each pan, which attach the pans to the gas supply. Raised the drip pans from the top and unplugged the ignitors from all pans. Remove the top and the rubber deflector over the ignitor switch. The ignitor switch snaps off and on. One of the seals under the drip pan was broken and needed replaced. I would recommend ordering these also. Turned out this was a good time to give everything a goo cleaning then replace as removed.

Parts Used:

Igniter Switch

Duff from Buena Vista, CO
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers

10 of 13 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

broken ceramic burner element

Simple: remove the element by hand and replace new one.

I can't believe how quickly I received my new part -literally next day.

Parts Used:

Sealed Burner Head - 14k

Phillip from Saint Simons Island, GA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

9 of 12 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Top burners were not lighting without a match

Was easy...I pulled oven out from the wall so I could get to the back.i used a nut driver to remove small silver cover.matched up wires to the never module and re installed.pluged oven back in and burners lit perfectly

Parts Used:

MODULE

Earl from ALLIANCE, OH
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Pliers

3 of 4 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

burner ingnighter would not lite burner

Replaced the ingintion module, still did not work, replaced the burner complete with new ingiter , it now works but another one quit . the front right one has 5 ohms resistance ,replaced with new one with 0 ohms, the back left has 2 ohms resistance and now it does not work , will need to replace that burner allso. too bad you can't buy just the spark module for the burner.

Parts Used:

MODULE

Wayne from Palestine, IL
Difficulty Level:
A Bit Difficult
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Pliers, Screw drivers, Wrench (Adjustable)

30 of 86 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Two of theTop gas burners would not spark

Took 6 screws out holding the top on from the sides. Lifted the top front, popped out the spark module, Took 6wires off & reversed the processed to install the new one. I was really amazed when I ordered it Wednesday and it arrived on Friday. Believe me I bookmarked this site.

Parts Used:

MODULE