GL6000ER (AWYABBL) LG Air Conditioner - Overview
Sections of the GL6000ER
[Viewing 1 of 1]
Keep searches simple, eg. "belt" or "pump".
Remote Control Assembly
PartSelect #: PS11760970
Manufacturer #: AKB73795706
This remote control is a device for adjusting your air conditioner settings. It requires two AAA batteries for operation. A malfunctioning remote control may have unresponsive buttons or signs of phys...
$49.42
In Stock
Thermistor,NTC
PartSelect #: PS3528997
Manufacturer #: 6323A20012C
This part is a thermistor assembly and it works in conjunction with your room air conditioner. The thermistor is a sensor that attaches to the control board of your air conditioner. Once attached it w...
No Longer Available
Clamp,Spring
PartSelect #: PS3522763
Manufacturer #: 3H02932C
The fan blade clamp, also known as a clamp spring, are for air conditioners. The clamp supports the fan blade on the motor shaft. When the motor is running, it signals the shaft to turn and rotate, bu...
No Longer Available
Curtain Installation Kit
PartSelect #: PS3518395
Manufacturer #: 3127A20083A
This is used for window air conditioners.
No Longer Available
Questions And Answers for GL6000ER
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Common Symptoms of the GL6000ER
[Viewing 1 of 1]
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Bad thermistor
Took front cover off air conditioner and pulled it a little forward out of the outdoor housing. I then flipped the LED display section out to the left and exposed the patch panel. The next step was to remove the panel with a small screwdriver and disconnect the old thermistor plug. I then plugged in the new one, remove the old one from th
... Read more
e grid bracket and placed the new one in. I then replaced everything else in reverse order. I have two LG air conditioners and they both have the same connection setup.
Read less
Parts Used:
-
Cindy from Baltimore, MD
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers
1 person
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Bad thermister, unit would run constantly without cycling.
Remove the front cover. Slide the unit forward a few inches from the case. Remove 1 screw from the top on the control box. Unsnap the old thermister leads going into the circuit board. Snap in the new thermister and place the end in the plastic holder in front of the coils. Install front cover.
Parts Used:
-
Gary from Aurora, CO
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers
Was this instruction helpful to you?
Thank you for voting!