EC7600 (EPA) Shindaiwa Lawn Tractor Accessories - Overview
Sections of the EC7600
[Viewing 7 of 7]Keep searches simple, eg. "belt" or "pump".

Chainsaw Purge Bulb
PartSelect #: PS8857246
Manufacturer #: 12318139130
This OEM replacement part is used to pump fuel from the tank to the carburetor in order to start the engine. It may also be referred to as a Primer Bulb. It is made of durable black plastic and is sol...
$6.81
In Stock

Chainsaw Fuel Filter
PartSelect #: PS11826309
Manufacturer #: A369000460
The Fuel Filter is a white and silver, individually sold, steel part. It reuires pliers to install and its installation is rated as Easy.
The part attaches inside of the fuel tank and is used to cle...
$8.60
Special Order

Trimmer Clip
PartSelect #: PS9238696
Manufacturer #: V490000500
This OEM Clip is a silver, steel part, which is sold individually. The part secures the fuel line to the fuel filter and is rated as Easy to install.
You will know you need a new one if there is a l...
$5.95
In Stock
Questions And Answers for EC7600
Be the first to ask our experts a question about this model!
✖
Ask a Question
Ask our experts a question on this model and we'll respond as soon as we can.
Sorry, we couldn't find a match for "".
Here's a guide for finding your model number.
Something went wrong. Please try again later.
Your Question Has Been Submitted!
Our experts will send you an email as soon as your question has been answered.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Replace clogged fuel filter.
Thru fuel cap, insert copper wire with hook formed on end. Fish around until you grab the fuel line. Pull the fuel line and filter thru the fuel fill neck.
Pull off old filter and replace with new. Push back into fuel tank & be done.
Pull off old filter and replace with new. Push back into fuel tank & be done.
Parts Used:
-
Keith from NORWOOD, NJ
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
24 of 42 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Bulb was worn out and broken open
The unit is a press fit. To remove the old one required breaking the plastic compression tabs that hold it in place. That was simple enough. Replacing requires lining up in the correct position to meet the inner hose. Then push it in. The compression tabs on the replacement click in and hold.in place.
Parts Used:
-
Richard from SPRING HILL, FL
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Pliers, Screw drivers
12 of 14 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!