Your coupon for will be reflected when you check out!
✖
Your coupon for
✖
Hello!
You're visiting the PartSelect site in U.S.
Would you like to shop on the Canadian site?
Stay on this site
Go to Canadian site
✖
Model Number Locations
1Select Category Type
Select Category Type
2Select Product Type
Select Product Type
3Select {MODEL} Type
Select {MODEL} Type
Sample Model Number Tags
Model numbers can be made up of numbers (1005400, for example) or a combination of letters and numbers (LAT1000AAE). The model number will most likely appear on either a paper sticker or a metal plate. Your appliance's model number tag may look similar to the sample model number tags shown here (model number highlighted in yellow):
Model has been saved to My Models. If you're not signed in, your lists are available on this device and will expire within 30 days.
Model has been saved to My Models.
This is a cooktop burner igniter that is compatible with various makes and models of cooktops and ranges and is sold as an individual part. This part creates a spark that ignites the burner within you...
$63.60
In Stock
Order within the next 7 hrs and your part ships today!
This spacer kit, also known as a grate foot kit, is a set of four padded feet designed to protect your burner grates and prevent scratches on the cooktop. Typically located at the bottom corners of th...
$30.92
In Stock
Order within the next 7 hrs and your part ships today!
This authentic OEM venturi tube, also known as a gas tube connector or surface burner tube, mixes gas and air to create the proper fuel-air mixture for combustion in your range. It is typically locate...
$62.04
In Stock
Order within the next 7 hrs and your part ships today!
This nut is designed for use with different makes and models of ranges and cooktops and is a genuine OEM part. This nut is 1mm thick and is 22-threads-per-inch, and is made of high-quality, durable st...
$23.41
In Stock
Order within the next 7 hrs and your part ships today!
This OEM control panel switch, also known as a limit switch or limit sensor, is mounted within the control panel housing on ranges. It is a small component that is responsible for transferring power t...
This spark ignition switch in your stove or range, also known as a potentiometer or burner switch, is an authentic OEM component. It generates the spark needed to ignite the gas in the burner and regu...
$55.14
In Stock
Order within the next 7 hrs and your part ships today!
Remove slide racks from oven. At the back right corner of oven unscrew heat sensor probe. Access rear of range. Remove screws holding back panel. Find wire from temperature probe where it passes through back wall of over and unclip it pulling probe wire and probe out back of oven. From the inside of oven, push chopstick through hole probe
... Read more wire was routed through, to find hole in back wall of oven. Once chopstick is visible from back of oven, with chopstick enlarge hole through visible insulation. This is the opening the new probe wire needs to be routed through. From inside oven push new wire, using chopstick, through this hole and reattach wire at back of oven using the plastic clip on the wire. From inside oven screw probe to back of oven wall, reattach outside panel to back of oven, turn gas back on, plug range back in, check oven operates, and push range back in place, reinstall racks. You may have to remove oven door if you have trouble reaching to the back of the oven to access the probe. YouTube videos are easy to find showing how to do that.
