CS-350TES Echo Chainsaw - Overview
Models starting with CS-350TES
Click on the best match to narrow your results.
Keep searches simple, eg. "belt" or "pump".
Chainsaw Stud
PartSelect #: PS9237151
Manufacturer #: V224000031
This part is the replacement stud for your chainsaw. It is approximately 1 ¼ inches long and is black in color. The stud secures the chain bar to the chainsaw. It the stud is damaged or missing, it ca...
$5.95
In Stock
Trimmer Clip
PartSelect #: PS9261895
Manufacturer #: 13201309820
This genuine fuel clip is a silver, metal, individually sold part. It can be installed with pliers and is rated as Easy to install by customers.
This part attaches to the fuel filter to secure the fu...
$5.19
In Stock
Trimmer Fuel Line Clip
PartSelect #: PS10053748
Manufacturer #: V490001230
Used in over 150 models of outdoor power equipment, this clip is commonly used to clip fuel lines or other hoses/tubes in place. It is sold individually, not as part of a kit or assembly, made of meta...
$5.95
In Stock
Trimmer Washer
PartSelect #: PS9308885
Manufacturer #: 90060300005
This OEM metal washer is commonly used on a variety of different small engine/lawn equipment models and is sold individually. This washer is used to help evenly distribute pressure from the securing b...
$5.19
In Stock
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
worn out paddles and scrapper blade
I followed the instructions on Youtube, but I used an Impact drill and ratchet set. The hardest part is assembling the screw on the lower part of the paddle. It helps if you have your snow blower against a wall or something else so that it can not move b/c you will need some strength to push the screw threw the pre-drilled hole to the 10
... Read more
mm nut. I used a vise grip to hold the nut do to the lack of space and with my impact driver started to thread the screw to the nut. This part took about 1 min on one side and 10 minutes on the other side. I guess I got lucky the first time. Changing the scraper blade took about 4 minutes start to finish. It will help if you have needle nose pliers to remove and reattach the spring on each side. The instruction on you tube were very helpful. Hope you find this information helpful.
Read less
Parts Used:
-
Sam from GAITHERSBURG, MD
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:30 - 60 mins
-
Tools:Pliers, Screw drivers, Socket set
2 of 6 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!