966612301 Husqvarna Lawn Mower - Overview
Models starting with 966612301
Click on the best match to narrow your results.
Keep searches simple, eg. "belt" or "pump".
Lawn Mower Hex Head Bolt
PartSelect #: PS9982804
Manufacturer #: 584953901
This part is the replacement washer head screw for your lawn tractor. It is black in color and is approximately an inch and a half in length. This self-threading screw is most commonly used for securi...
$3.99
In Stock
Lawn Mower Blade Bolt and Washer Assembly
PartSelect #: PS9020856
Manufacturer #: 532193003
This manufacturer-approved bolt and washer assembly is for lawn tractors.
Wear work gloves to protect your hands when installing this part.
$9.62
In Stock
Lawn Mower Flat Idler Pulley
PartSelect #: PS9031679
Manufacturer #: 539110311
This is an OEM replacement part for various models of lawn mowers. The Idler Pulley is used to apply tension to the blade belt, allowing the belt to turn. It has an O.D. of approx. 2.75 inches, is ma...
$15.91
In Stock
Lawn Mower Mandrel Assembly
PartSelect #: PS12116539
Manufacturer #: 587820301
This mandrel assembly is for lawn tractors.
Mandrel assembly attaches to the mower deck and spins the blades. The assembly may include multiple parts; refer to your parts diagram for a complete lis...
$58.37
In Stock
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
bent mower blade
it was a 5 minute job all I did was jack up the rear of the mower lay down along side of it and install the new blade tighten up the bolt then I lower the mower back down to the ground the started up the mower for a test run of the blade. and it works just fine
Parts Used:
-
Dan from Taylor, MI
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Wrench (Adjustable)
2 of 3 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Worn out Mandrel Assemblies
Remove Deck, Remove Blades, Remove guards and belt, use old belt to hold pully to remove pully (would be good to have pully wrench), Remove mandrel Assembly, Install new mandrel assemblies (had to tap the new mandrel assemblies. Should have been done by manufacturer.). Reinstall blades, guards, and belt. Put deck back on.
Parts Used:
-
Joseph from CANBY, MN
-
Difficulty Level:Difficult
-
Total Repair Time:More than 2 hours
-
Tools:Socket set
2 of 3 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!