Your coupon for will be reflected when you check out!
✖
Your coupon for
✖
Hello!
You're visiting the PartSelect site in U.S.
Would you like to shop on the Canadian site?
Stay on this site
Go to Canadian site
✖
Model Number Locations
1Select Category Type
Select Category Type
2Select Product Type
Select Product Type
3Select {MODEL} Type
Select {MODEL} Type
Sample Model Number Tags
Model numbers can be made up of numbers (1005400, for example) or a combination of letters and numbers (LAT1000AAE). The model number will most likely appear on either a paper sticker or a metal plate. Your appliance's model number tag may look similar to the sample model number tags shown here (model number highlighted in yellow):
Model has been saved to My Models. If you're not signed in, your lists are available on this device and will expire within 30 days.
Model has been saved to My Models.
The Dust Shield is a 6-3/4 inch, black plastic part, used to prevent dust or debris fouling the wheel or axle. It attaches inside of the wheel around the axle. Installation is rated as "Easy" and will...
$6.35
In Stock
Order within the next 7 hrs and your part ships today!
Enhance the longevity of your lawn mower with this Husqvarna Idler Pulley Assembly. This essential component is paramount in maintaining belt tension, which enables the belt to function and turn smoot...
$22.98
In Stock
Order within the next 7 hrs and your part ships today!
This Handle Bolt is sourced directly from the original equipment manufacturer for use in various lawn and garden equipment. It is used to secure the upper and lower handles together and is tightened b...
$6.35
In Stock
Order within the next 7 hrs and your part ships today!
The E-Ring 7/16 is a 7/16-inch silver, metal part which can be attached to various locations on a variety of equipment to snap into grooves and secure parts into place. This part will require pliers t...
$5.95
In Stock
Order within the next 7 hrs and your part ships today!
9/16s inch socket, something to prop up one side of the mower (I used a plastic plant pot), and about 5 minutes was all that was needed. Undo the nut on the wheel, remove, replace it with the new one (can't mess it up - just goes on one way which is extremely obvious), replace and tighten the nut -- done. Just that simple. With the new
... Read morekicks it goes up hill like a champ now (instead of spinning, especially with the grass catcher attached).
Can't believe you all had replacement wheels for this dinosaur. They have drive gears attached to wheel. Very simple to fix but broke old exhaust chute on mower when I leaned it on its side. Now I have to find a replacement for it! Geeesh!!!
