Parts That Fix Maytag Washer 7MMVWC416FW0 Leaking
The hose clamp is used to hold the water hose in place which will prevent the hose from leaking water. Sometimes the clamp may lose its ability to latch on, causing a leaking washer. For the installation, you will need a flat head screw driver to replace the clamp and a drill to access the screws to remove the front of the washer. Be careful if you do not have specific clamp pliers as the clamp could fly off. Once the front of the washer has been removed, take a quick look for water damage or any obvious signs of where the leak is coming from. If it is not obvious, run water to test.
Replacing your Kenmore Washer Washer Hose Clamp
The drain hose carries used water from the washer to your house drain.
Replacing your Whirlpool Washer Drain Hose
Customer Repair Stories
Step 2: Loosened clamp on the hose connected to the washer with a set of pliers and pulled the drain hose out of the bottom of the washer.
Step 3: Took the new hose and clamp and placed it back into the bottom of washer, making sure th ... Read more at the clamp was secured around the correct placing on the hose.
Step 4: Placed curved part of the hose back into trap, making sure it was secure.
(Final) Step 5: Plugged the washer back in. Ran through a small washing cycle to make sure hose wasn't leaking out of either end.
-
Kelly from Rockwood, TN
-
Difficulty Level:Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Pliers
-
Delmar from EAST TROY, WI
-
Difficulty Level:Really Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Pliers
The tub-to-pump hose carries the water from the tub to the drain pump. Unplug the washer and shut off the water supply before installing this part. Wear work gloves to protect your hands
Replacing your Whirlpool Washer Washer Tub to pump Hose Assembly
This part goes on the agitator retaining bolt.
Replacing your Whirlpool Washer Washer Washer
Customer Repair Stories
-
Joseph from Kalkaska, MI
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Socket set
This clamp helps to prevent leaking by holding the end of water hose in place.